Arsenic removal from contaminated water by the Soyatal Formation, Zimapán Mining District, Mexico – a potential low-cost low-tech remediation system

2001 ◽  
Vol 1 (1) ◽  
pp. 23-31 ◽  
Author(s):  
Lois K. Ongley ◽  
Ma. Aurora Armienta ◽  
Katherine Heggeman ◽  
Alison S. Lathrop ◽  
Helen Mango ◽  
...  
Keyword(s):  
Arsenic Removal ◽  
Low Cost ◽  
Contaminated Water ◽  
Mining District

scholarly journals Arsenic removal from arsenic-contaminated water by biological arsenite oxidation and chemical ferrous iron oxidation using a down-flow hanging sponge reactor

2017 ◽  
Vol 17 (5) ◽  
pp. 1249-1259 ◽  
Author(s):  
Nao Kamei-Ishikawa ◽  
Nami Segawa ◽  
Daisuke Yamazaki ◽  
Ayumi Ito ◽  
Teruyuki Umita
Keyword(s):  
Arsenic Removal ◽  
Low Cost ◽  
Iron Hydroxide ◽  
Iron Oxidation ◽  
Quality Standards ◽  
Small Scale ◽  
Contaminated Water ◽  
Water Quality Standards ◽  
Ferrous Iron Oxidation ◽  
Arsenite Oxidizing Bacteria

The down-flow hanging sponge (DHS) reactor was used for continuous As removal treatment of As-contaminated water. The treatment scheme was: (1) As(III) in contaminated water is oxidized by arsenite-oxidizing bacteria fixed in the sponges in the reactor; (2) Fe(II) naturally existing in the water is oxidized by dissolved oxygen; (3) Fe(III) is precipitated as iron hydroxide and As(V) is co-precipitated with the iron hydroxide; and finally (4) the co-precipitates are fixed in the sponges. This system could remove As from As-contaminated water on a small scale and at low cost. The results showed that, after using the DHS reactor, As and Fe concentrations in the treated water were lower than water quality standards for drinking water when Fe(II) concentration in the influent was lower than 10 mg/L and the Fe/As ratio was higher than 6.67–8.42, with dependence on the Fe concentration. Additionally, even if Fe concentration is higher than 10 mg/L, the treatment system is still applicable if the pH of the influent is higher than 7 or the retention time is longer than 2 h.

Parameters Affecting Dye Adsorption - Using Graphene Coated Sand (GSC)

2018 ◽  
Vol 4 (02) ◽  
Author(s):  
Seroor Atalah Khaleefa Alia ◽  
Dr. Mohammed Ibrahimb ◽  
Hussein Ali Hussein
Keyword(s):  
Heavy Metals ◽  
Contact Time ◽  
Organic Dyes ◽  
Low Cost ◽  
Dye Adsorption ◽  
Contaminated Water ◽  
Maximum Adsorption Capacity ◽  
Engineering Designs ◽  
Heavy Metals Ions ◽  
Coated Sand

Adsorption is most commonly applied process for the removal of pollutants such as dyes and heavy metals ions from wastewater. The present work talks about preparing graphenic material attached sand grains called graphene sand composite (GSC) by using ordinary sugar as a carbon source. Physical morphology and chemical composition of GSC was examined by using (FTIR, SEM, EDAX and XRD). Efficiency of GSC in the adsorption of organic dyes from water was investigated using reactive green dye with different parameters such as (ph, temperature, contact time and dose). Adsorption isotherm was also studied and the results showed that the maximum adsorption capacity of dye is 28.98 mg/g. This fast, low-cost process can be used to manufacture commercial filters to treat contaminated water using appropriate engineering designs.

Efficient low-cost magnetic composite based on eucalyptus wood biochar for arsenic removal from groundwater

2021 ◽  
Vol 14 ◽  
pp. 100585
Author(s):  
Amalia Lara Bursztyn Fuentes ◽  
Facundo Barraqué ◽  
Roberto Carlos Mercader ◽  
Alberto Néstor Scian ◽  
María Luciana Montes
Keyword(s):  
Arsenic Removal ◽  
Low Cost ◽  
Magnetic Composite ◽  
Eucalyptus Wood

scholarly journals Eggshell Powder as an Adsorbent for Removal of Fluoride from Aqueous Solution: Equilibrium, Kinetic and Thermodynamic Studies

2012 ◽  
Vol 9 (3) ◽  
pp. 1457-1480 ◽  
Author(s):  
R. Bhaumik ◽  
N. K. Mondal ◽  
B. Das ◽  
P. Roy ◽  
K. C. Pal ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Adsorption Process ◽  
Low Cost ◽  
Fluoride Removal ◽  
Contaminated Water ◽  
Fluoride Adsorption ◽  
Langmuir Isotherm Model ◽  
Pseudo Second Order ◽  
Kinetic And Thermodynamic Studies ◽  
Maximum Removal

A new medium, eggshell powder has been developed for fluoride removal from aqueous solution. Fluoride adsorption was studied in a batch system where adsorption was found to be pH dependent with maximum removal efficiency at 6.0. The experimental data was more satisfactorily fitted with Langmuir isotherm model. The kinetics and the factor controlling adsorption process fully accepted by pseudo-second-order model were also discussed. Eawas found to be 45.98 kJmol-1by using Arrhenius equation, indicating chemisorption nature of fluoride onto eggshell powder. Thermodynamic study showed spontaneous nature and feasibility of the adsorption process with negative enthalpy (∆H0) value also supported the exothermic nature. Batch experiments were performed to study the applicability of the adsorbent by using fluoride contaminated water collected from affected areas. These results indicate that eggshell powder can be used as an effective, low-cost adsorbent to remove fluoride from aqueous solution as well as groundwater.

Arsenic removal from contaminated water by ultrafine δ-FeOOH adsorbents

2014 ◽  
Vol 237 ◽  
pp. 47-54 ◽  
Author(s):  
Márcia C.S. Faria ◽  
Renedy S. Rosemberg ◽  
Cleide A. Bomfeti ◽  
Douglas S. Monteiro ◽  
Fernando Barbosa ◽  
...  
Keyword(s):  
Arsenic Removal ◽  
Contaminated Water

Highly Efficient and Low‐cost Clay‐based Adsorbent for Glyphosate Removal from Contaminated Water

2021 ◽  
Author(s):  
Farzana Nargis ◽  
Ann Duong ◽  
Erwin Rehl ◽  
Charles Bradshaw ◽  
Hossein Kazemian
Keyword(s):  
Low Cost ◽  
Contaminated Water ◽  
Highly Efficient

scholarly journals Removal of Cyanide-Contaminated Water by Vetiver Grasses

2015 ◽  
Vol 9 (13) ◽  
pp. 252 ◽  
Author(s):  
Piyada Wachirawongsakorn ◽  
Tongsai Jamnongkan ◽  
Mohd Talib Latif
Keyword(s):  
Growth Rate ◽  
Survival Rate ◽  
Sri Lanka ◽  
Removal Efficiency ◽  
Water Samples ◽  
Low Cost ◽  
Contaminated Water ◽  
Vetiver Grass ◽  
Vetiveria Zizanioides ◽  
Concentration Levels

<p>Vetiver grass and it usages have been widely investigated in many researches as the preferred plant species due to its known efficiency, low cost, the ease of availability and spread. This research aimed to use four different vetiver grass (<em>Vetiveria zizanioides</em>) ecotypes to remove cyanide (CN<sup>-</sup>)-contaminated water for improve its quality. Growth capability, tolerance and removal efficiency were evaluated. The results showed that the vetiver grass had a 100% survival rate for one month after planting. Songkhlar3 had the longest leaves, followed by Surat-Thani, Sri Lanka and Monto, respectively. Root lengths of all ecotypes showed no significant differences (p ≤ 0.05). All vetiver grass ecotypes could potentially purify CN<sup>-</sup>-contaminated water at lower concentrations of ≤ 35 mg CN<sup>-</sup>/L. The Monto ecotype had the highest CN<sup>-</sup> removal efficiency at all CN<sup>-</sup> concentration levels, showing 100% CN<sup>-</sup> removal from the 5-45 mg CN<sup>-</sup>/L contaminated water samples within 2-5 weeks growth. The tolerance of vetiver grass to CN<sup>-</sup> was a more important factor than growth rate when selecting a vetiver grass ecotype for CN<sup>-</sup> phytoremediation.</p>

scholarly journals Evaluation of modified montmorillonite with di-cationic surfactants as efficient and environmentally friendly adsorbents for arsenic removal from contaminated water

2017 ◽  
Vol 18 (2) ◽  
pp. 460-472 ◽  
Author(s):  
E. Shokri ◽  
R. Yegani ◽  
B. Pourabbas ◽  
B. Ghofrani
Keyword(s):  
Contact Time ◽  
Arsenic Removal ◽  
Environmentally Friendly ◽  
Contaminated Water ◽  
X Ray Diffraction ◽  
Solution Ph ◽  
Modified Montmorillonite ◽  
Adsorption Capacities ◽  
Modified Adsorbents ◽  
Adsorption Desorption

Abstract In this work, montmorillonite (Mt) was modified by environmentally friendly arginine (Arg) and lysine (Lys) amino acids with di-cationic groups for arsenic removal from contaminated water. The modified Mts were characterized by X-ray diffraction, Fourier transform infrared spectroscopy, zeta potential and thermal analysis. The adsorption of As(V) onto modified Mts as a function of initial As(V) concentration, contact time and solution pH was investigated. The removal efficiency was increased with increasing the As(V) concentration and contact time; however, it was decreased with increasing solution pH. The maximum As(V) adsorption capacities of Mt-Arg and Mt-Lys were 11.5 and 11 mg/g, respectively, which were five times larger than pristine Mt. The high adsorption capacity makes them promising candidates for arsenic removal from contaminated water. The regeneration studies were carried out up to 10 cycles for both modified Mts. The obtained results confirmed that the modified adsorbents could also be effectively used for As(V) removal from water for multiple adsorption – desorption cycles.

Sign in / Sign up

Export Citation Format

Share Document