Numerical Analysis of Mixed Convection of Nanofluids Inside a Vertical Channel

2016 ◽  
Vol 13 (03) ◽  
pp. 1650012 ◽  
Author(s):  
M. B. Akgül ◽  
M. Pakdemirli
Keyword(s):  
Mixed Convection ◽  
Single Phase ◽  
Volume Fraction ◽  
Solid Volume Fraction ◽  
Vertical Channel ◽  
Eulerian Model ◽  
Two Phase ◽  
Thermal Fields ◽  
Laminar Mixed Convection ◽  
Effective Particle

Laminar mixed convection of an Al[Formula: see text]O[Formula: see text]/water nanofluid inside a vertical channel is investigated numerically. Single-phase and two-phase Eulerian models are employed to analyze flow and thermal fields of the nanofluid in conjunction with the suitable expressions for the particle viscosity and effective particle thermal conductivity. The results of two-phase Eulerian model are compared with the single-phase model and with the published experimental data. Effects of the solid volume fraction, Reynolds number and Grashof number on the heat transfer performance of the nanofluid are investigated and discussed in detail.

Numerical Simulation of Nanofluid-Cooling Enhancement of Three Fins Mounted in a Horizontal Channel

2016 ◽  
Vol 138 (9) ◽  
Author(s):  
Moussa Khentoul ◽  
Rachid Bessaïh
Keyword(s):  
Volume Fraction ◽  
Numerical Study ◽  
Solid Volume Fraction ◽  
Horizontal Channel ◽  
Thermal Fields ◽  
Nusselt Numbers ◽  
Simpler Algorithm ◽  
Laminar Mixed Convection ◽  
Cooling Enhancement ◽  
Volume Method

This article presents a numerical study of two-dimensional laminar mixed convection in a horizontal channel. The upper horizontal wall of the channel is insulated. The governing equations were solved by using the finite volume method based on the simpler algorithm. Comparisons with previous results were performed and found to be in excellent agreement. The results were presented in terms of streamlines, isotherms, local and average Nusselt numbers for the Richardson number (0 ≤ Ri ≤ 10), Reynolds number (5 ≤ Re ≤ 100), solid volume fraction of nanoparticles (0 ≤ ϕ ≤ 0.10), and the type of nanofluids (Cu, Ag, Al2O3, and TiO2). The results show that the previous parameters have considerable effects on the flow and thermal fields. It was found that the heat transfer increases with increasing of Ra, Re, and ϕ.

Numerical Study of Laminar Mixed Convection of a Nanofluid in a Horizontal Curved Tube with Constant Heat Flux and Mass Flow Rate

2011 ◽  
Vol 110-116 ◽  
pp. 3657-3662
Author(s):  
S. Alikhani ◽  
A. Behzadmehr ◽  
S. Mirmasoumi
Keyword(s):  
Heat Flux ◽  
Mixed Convection ◽  
Mass Flow Rate ◽  
Mass Flow ◽  
Flow Rate ◽  
Volume Fraction ◽  
Numerical Study ◽  
Two Phase ◽  
Curved Tube ◽  
Laminar Mixed Convection

Fully developed laminar mixed convection of a nanofluid (water/Al2O3) in a horizontal curved tube is numerically investigated. Three-dimensional elliptic governing equations have been solved to show how nanoparticle concentration affects on thermal and hydrodynamic parameters while these parameters are impressed by centrifugal and buoyancy forces under constant mass flow rate and heat flux. Comparisons with previously published experimental works on horizontal curved tubes show good agreements between the results. Results which are obtained using the two – phase mixture model indicate that adding the nanoparticles causes changes in the properties of nanofluid and finally increases the temperature of the flow. Furthermore, increasing nanoparticles volume fraction at first augments the heat transfer coefficient of nanofluid and then, for higher concentration of particles, decreases this thermal parameter of nanofluid.

Heat transfer and entropy generation analysis of Cu-water nanofluid in a vertical channel

2018 ◽  
Vol 15 (5) ◽  
pp. 604-613
Author(s):  
Essma Belahmadi ◽  
Rachid Bessaih
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Mixed Convection ◽  
Friction Factor ◽  
Entropy Generation ◽  
Volume Fraction ◽  
Solid Volume Fraction ◽  
Vertical Channel ◽  
Simple Algorithm ◽  
Content Type

Purpose The purpose of this study is to analyze heat transfer and entropy generation of a Cu-water nanofluid in a vertical channel. The channel walls are maintained at a hot temperature Tw. An up flow penetrates the channel at a uniform velocity v0 and a cold temperature T0 (T0 < Tw). The effects of Reynolds number Re, Grashof number Gr and solid volume fraction ϕ on streamlines, isotherms, entropy generation, friction factor, local and mean Nusselt numbers are evaluated. Design/methodology/approach The Cu-water nanofluid is used in this study. The software Ansys-fluent 14.5, based on the finite-volume method and SIMPLE algorithm, is used to simulate the mixed convection problem with entropy generation in a vertical channel. Findings The results show that the increase of Reynolds and Grashof numbers and solid volume fraction improves heat transfer and reduces entropy generation. Correlations for the mean Nusselt number and friction factor in terms of Reynolds number and solid volume fraction are obtained. The present results are compared with those found in the literature, which reveal a very good agreement. Originality/value The originality of this work is to understand the heat transfer and entropy generation for mixed convection of a Cu-water nanofluid in a vertical channel.

Comparison of Single and Two-Phase Models for the Study of Mixed Convection Flows With Nanofluids

2010 ◽  
Author(s):  
Mahmood Akbari ◽  
Amin Behzadmehr ◽  
Nicolas Galanis
Keyword(s):  
Heat Transfer ◽  
Experimental Data ◽  
Mixed Convection ◽  
Single Phase ◽  
Volume Fraction ◽  
Solid Particles ◽  
Two Phase ◽  
Prediction Ability ◽  
Numerical Predictions ◽  
Phase Models

The single phase and three different two phase models (Volume of fluid, Mixture and Eulerian) are used to analyse laminar mixed convection flow of Al2O3-water nanofluids in a horizontal tube, in order to evaluate their prediction ability. The flow is considered steady and developing. The fluid’s physical properties are temperature dependent whereas those of the solid particles are constant. A uniform heat flux is applied at the fluid-solid interface. Two different Reynolds numbers and three different volume fractions have been considered. The governing three-dimensional partial differential equations are elliptical in all directions and coupled. Predicted convective heat transfer coefficients, velocity, and temperature profiles, as well as secondary flow’s velocity vectors and temperature contours are compared at different axial positions. To validate the comparisons and verify the accuracy of the results, the numerical predictions are compared with corresponding experimental data. There are essentially no differences between the predictions of the two-phase models; however their results are significantly different from those of the single-phase approach. Two-phase model results are closer to the experimental data, but they show an unrealistic increase in heat transfer for small changes of the particle volume fraction. Hydrodynamically, the two-phase and single-phase approaches perform almost the same but their thermal predictions are quite different.

Gas Phase Distribution Effects on Heat Transfer in Upward Vertical Bubbly Channel Flows

2016 ◽  
Author(s):  
Haden Hinkle ◽  
Deify Law
Keyword(s):  
Heat Transfer ◽  
Gas Phase ◽  
Bubble Size ◽  
Single Phase ◽  
Volume Fraction ◽  
Phase Distribution ◽  
Vertical Channel ◽  
Channel Flows ◽  
Two Phase ◽  
Ansys Fluent

Two-phase (non-boiling) flows have been shown to increase heat transfer in channel flows as compared with single-phase flows. The present work explores the effects of gas phase distribution such as volume fraction and bubble size on the heat transfer in upward vertical channel flows. A two-dimensional (2D) channel flow of 10 cm wide by 100 cm high is studied numerically. Numerical simulations are performed using the commercial computational fluid dynamics (CFD) code ANSYS FLUENT. The bubble size is characterized by the Eötvös number. The volume fraction and the Eötvö number are varied parametrically to investigate their effects on Nusselt number of the two-phase flows. All simulations are compared with a single-phase flow condition.

scholarly journals Numerical Simulation of the Cooling of Heated Electronic Blocks in Horizontal Channel by Mixed Convection of Nanofluids

2020 ◽  
Vol 2020 ◽  
pp. 1-11
Author(s):  
Mustapha Ait Hssain ◽  
Rachid Mir ◽  
Youness El Hammami
Keyword(s):  
Heat Transfer ◽  
Mixed Convection ◽  
Volume Fraction ◽  
Numerical Study ◽  
Solid Volume Fraction ◽  
Simple Algorithm ◽  
Separation Distance ◽  
Horizontal Channel ◽  
Laminar Mixed Convection ◽  
Finite Volume Approach

The present work is devoted to the numerical study of steady and laminar mixed convection of nanofluid (water nanoparticles) in a horizontal channel provided with sources of heat at constant temperature, which simulate hot electronic components. The transport equations for continuity, momentum, and energy are solved with finite volume approach using the SIMPLE algorithm. The effective thermal conductivity and the dynamic viscosity of the nanofluid are calculated using, respectively, the Maxwell-Garnett and Brinkman model. The influence of the volume fraction of the nanoparticles 0%≤φ≤10%, Reynolds numbers 5≤Re≤75, the distance between the blocks 0≤d/H≤3, and the types of nanoparticles added (TiO2, Al2O3, CuO, Ag, Cu, and MgO) were investigated and discussed. It emerges from this simulation that the heat transfer increases with the increase in the volume fraction of the nanoparticles and the Reynolds number and decreases with the augmentation of separation distance between heated sources. Moreover, the study shows that the heat transfer is improved by 20% at a solid volume fraction of 10% of Cu nanoparticles.

Laminar Mixed Convection Nanofluids Flow in a Elliptic Duct Using Two Phase Approach

2011 ◽  
Author(s):  
A. Akbarinia ◽  
M. Shariat ◽  
R. Laur
Keyword(s):  
Nusselt Number ◽  
Mixed Convection ◽  
Friction Factor ◽  
Skin Friction ◽  
Volume Fraction ◽  
Nanofluid Flow ◽  
Two Phase ◽  
Local Skin ◽  
Laminar Mixed Convection ◽  
Mean Diameter

Laminar mixed convection Al2O3-Water nanofluid flow in elliptic ducts with constant heat flux boundary condition has been simulated employing two phase mixture model. Three-dimensional Navier-Stokes, energy and volume fraction equations have been discretized using the Finite Volume Method (FVM). The Brownian motions of nanoparticles have been considered to determine the thermal conductivity and dynamics viscosity of Al2O3-Water nanofluid, which vary with temperature. Simulation effects of solid volume fraction and nanoparticles mean diameter on thermal and hydraulics behaviors of nanofluid flow in elliptic ducts have been presented and discussed. The calculated results show good agreement with the previous numerical data. Results show that in a given Reynolds number (Re) and Richardson number (Ri), increasing solid nanoparticles volume fraction increases the Nusselt number (Nu) while the skin friction factor decreases. Increasing nanoparticles mean diameter augments the local skin friction factor whereas it causes the Nusselt number to reduce. But these effects are significant for nanoparticles diameter equal to 13nm especially.

Magnetohydrodynamic Mixed Convection of a Cu-Water Nanofluid in a Vertical Channel

2013 ◽  
Vol 135 (7) ◽  
Author(s):  
A. Raisi ◽  
S. M. Aminossadati ◽  
B. Ghasemi
Keyword(s):  
Magnetic Field ◽  
Heat Transfer ◽  
Mixed Convection ◽  
Heat Transfer Rate ◽  
Transfer Rate ◽  
Volume Fraction ◽  
Solid Volume Fraction ◽  
Convection Heat Transfer ◽  
Vertical Channel ◽  
Mixed Convection Heat Transfer

This technical brief numerically examines the mixed convection heat transfer of a Cu-water nanofluid in a parallel-plate vertical channel that is influenced by a magnetic field. An upward flow of Cu-water nanofluid enters the channel at a relatively low temperature and a uniform velocity. It is found that the magnetic field has dissimilar effects on the heat transfer rate at different Richardson numbers. The increase of solid volume fraction results in an increase of the heat transfer rate especially at low Richardson numbers.

Sign in / Sign up

Export Citation Format

Share Document