Étude statistique des effets de solvant. III. Calcul et interprétation de paramètres empiriques de polarité à partir de propriétés physicochimiques des solvants purs

1985 ◽  
Vol 63 (12) ◽  
pp. 3492-3498 ◽  
Author(s):  
M. Chastrette ◽  
J. Carretto

Using multivariational statistical methods, the calculation and interpretation of empirical parameters of the polarity of solvents has been reexamined. The size of the sample used (57 aprotic solvents and 24 protic solvents) assures that it is representative. For each solvent, the data tabulated include some physical constants (dielectric constants, dipole moments, refractive indices, molar refractions, boiling points, Hildebrand's δ parameters) or theoretical values (energy levels of frontier orbitals). The methods used are factorial analysis and multiple regression. The results obtained show that, for the aprotic solvents, the parameter ET is a measure of the polarity, of the polarizability, and of the cohesion of the solvent to the extent of 43, 39, and 18% respectively. For the parameter π*, these proportions are respectively 53, 18, and 29%. For the protic solvents, the parameter ET is explained by the same variables except for 5 solvents more acidic than water; this anomaly is explained by the basicity of the oxygen of the betaine used to define ET.

2021 ◽  
Vol 20 (1) ◽  
pp. 59-68
Author(s):  
Zohreh Khanjari ◽  
Bita Mohtat ◽  
Reza Ghiasi ◽  
Hoorieh Djahaniani ◽  
Farahnaz Kargar Behbahani

This research examined the effects of solvent polarity and temperature on the tautomerization of a carbonitrile molecule at CAM-B3LYP/6-311G (d,p) level of theory. The selected solvents were n-hexane, diethyl ether, pyridine, ethanol, methanol, and water. The solvent effects were examined by the self-consistent reaction field theory (SCRF) based on conductor-like polarizable continuum model (CPCM). The solvent effects were explored on the energy barrier, frontier orbitals energies, and HOMO-LUMO gap. Dependencies of thermodynamic parameters (ΔG and ΔH) on the dielectric constants of solvents were also tested. Specifically, the temperature dependencies of the thermodynamics parameters were studied within 100–1000 K range. The rate constant of the tautomerism reaction was computed from 300 to 1200 K, in the gas phase.


1992 ◽  
Vol 33 (5) ◽  
pp. 389-393 ◽  
Author(s):  
R.R. Reddy ◽  
S. Anjaneyulu ◽  
T.V.R. Rao

2000 ◽  
Vol 65 (12) ◽  
pp. 839-846
Author(s):  
Jasmina Nikolic ◽  
Gordana Uscumlic ◽  
Vera Krstic

Rate constants for the reaction of diazodiphenylmethane with cyclohex-1-enylcarboxylic acid and 2-methylcyclohex-1-enylcarboxylic acid were determined in nine aprotic solvents, as well as in seven protic solvents, at 30?C using the appropriate UV-spectroscopic method. In protic solvents the unsubsituted acid displayed higher reaction rates than the methyl-substituted one. The results in aprotic solvents showed quite the opposite, and the reaction rates were considerably lower. In order to explain the obtained results through solvent effects, reaction rate constants (k) of the examined acids were correlated using the total solvatochromic equation of the form: log k=logk0+s?*+a?+b?, where ?* is the measure of the solvent polarity, a represents the scale of the solvent hydrogen bond donor acidities (HBD) and b represents the scale of the solvent hydrogen bond acceptor basicities (HBA). The correlation of the kinetic data were carried out by means of multiple linear regression analysis and the opposite effects of aprotic solvents, as well as the difference in the influence of protic and aprotic solvents on the reaction of the two examined acids with DDM were discussed. The results presented in this paper for cyclohex-1-enylcarboxylic and 2-methylcyclohex-1-enylcarboxylic acids were compared with the kinetic data for benzoic acid obtained in the same chemical reaction, under the same experimental conditions.


Polymers ◽  
2020 ◽  
Vol 12 (3) ◽  
pp. 565 ◽  
Author(s):  
Beata Jewłoszewicz ◽  
Krzysztof A. Bogdanowicz ◽  
Wojciech Przybył ◽  
Agnieszka Iwan ◽  
Ireneusz Plebankiewicz

Poly(3,4-ethylenedioxythiophene:poly(styrenesulfonate) (PEDOT:PSS) water and toluene solutions were investigated in detail, taking into consideration their stability, wettability, transparency, and electrochemical properties, along with change polarity caused by dopant. As dopant, methanol, ethanol, and isopropanol were used with different dipole moments (1.70, 1.69, and 1.66 D) and dielectric constants (33.0, 24.5, and 18.0). Three techniques, i.e., spin coating, doctor blade coating, and spray coating, were employed to created PEDOT:PSS layers on glass, glass/indium tin oxide (ITO), and glass/fluorine-doped tin oxide (FTO) substrates with optimized technical parameters for each used equipment. All used PEDOT:PSS water and toluene solutions demonstrated good wetting properties with angles below 30° for all used surfaces. Values of the energy bandgap (Eg) of PEDOT:PSS investigated by cyclic voltammetry (CV) in solution showed increase energy Eg along with addition of alcohol to the mixture, and they were found in the range of 1.20 eV to 2.85 eV. The opposite tendency was found for the Eg value of the PEDOT:PSS layer created from water solution. The storage effect on PEDOT:PSS layers detected by CV affected only the lowest unoccupied molecular orbital (LUMO) level, thereby causing changes in the energy bandgap. Finally, simple devices were constructed and investigated by infrared (IR) thermographic camera to investigate the surface defects on the created PEDOT:PSS layers. Our study showed that a more stable PEDOT:PSS layer without pin-holes and defects can be obtained from water and toluene solutions with isopropanol via the spin coating technique with an optimal speed of 3000 rpm and time of 90 s.


Author(s):  
Zhi Liang ◽  
Hai-Lung Tsai

Ab initio MD simulation of laser-matter interactions is a hot area in the study of the mechanisms of photo-dissociation, photo-ionization and laser induced chemical reactions. The major problems in the study of laser-molecule interactions are to determine the energies and wave functions of molecular vibration states and the molecular transition dipole moments. An efficient method is presented to calculate the intramolecular potential energies and electrical dipole moments of CO2 molecules at the electronic ground state by solving the Kohn-Sham (KS) equation for a total of 101,992 nuclear configurations. The Projector-Augmented Wave (PAW) exchange-correlation potential functionals and Plane Wave (PW) basis functions were used in solving the KS equation. The calculated intra-molecular potential function was then included in the pure vibrational Schro¨dinger equation to determine the vibrational energy eigen values and eigen functions. The vibrational wave functions combined with the calculated dipole moment function were used to determine the transition dipole moments. The calculated results have a good agreement with experimental values. These results can be further used to determinations of molecular spectroscopy and laser absorption coefficients.


Sign in / Sign up

Export Citation Format

Share Document