On the reaction of furan with bromine in aqueous solution. Observation of the slow hydration of malealdehyde

1983 ◽  
Vol 61 (9) ◽  
pp. 2171-2176 ◽  
Author(s):  
Oswald S. Tee ◽  
B. E. Swedlund
Keyword(s):  
Aqueous Solution ◽  
Rate Constant ◽  
Uv Spectrophotometry ◽  
Stopped Flow ◽  
Geometrical Isomers ◽  
Rate Of Reaction

The rate of reaction of furan with bromine in aqueous solution has been measured and the rate constant obtained by Williamson and Coller is confirmed. However, it is now found that the reaction of bromine with furan in water has two distinct stages: attack of bromine leading to the formation of malealdehyde 3 and hydration of 3 to a 2:1 mixture of the geometrical isomers of its cyclic hydrate 4. This second, slower process is observable by stopped-flow uv spectrophotometry occurring after the consumption of bromine. The observed kinetics are very similar to those recently found for the analogous hydration of phthalaldehyde by McDonald and Martin.

The mechanism of the oxidation of thiocyanate ion by peroxomonosulphate in aqueous solution. II. Kinetics of the reaction

1966 ◽  
Vol 19 (8) ◽  
pp. 1365 ◽  
Author(s):  
RH Smith ◽  
IR Wilson
Keyword(s):  
Aqueous Solution ◽  
Initial Rate ◽  
Stopped Flow ◽  
Thiocyanate Ion ◽  
First Order ◽  
Conductance Method ◽  
Rate Of Reaction ◽  
Kinetics Of

Initial rates of reaction for the above oxidation have been measured by a stopped-flow conductance method. Between pH 2 and 3.6, the initial rate of reaction, R, is given by the expression R{[HSO5-]+[SCN-]} = {kb+kc[H+]}[HSO5-]0[SCN-]20+ka[H+]-1[HSO5]20[SCN-]0 As pH increases, there is a transition to a pH-independent rate, first order in each thiocyanate and peroxomonosulphate concentrations.

scholarly journals Kinetics of thiamin cleavage by sulphite

1969 ◽  
Vol 113 (4) ◽  
pp. 611-615 ◽  
Author(s):  
J. Leichter ◽  
M. A. Joslyn
Keyword(s):  
Aqueous Solutions ◽  
Rate Constant ◽  
Sulphur Dioxide ◽  
First Order ◽  
Ph Values ◽  
Rate Of Reaction ◽  
Kinetics Of

Results are presented on the rate of thiamin cleavage by sulphite in aqueous solutions as affected by temperature (20–70°), pH(2·5–7·0), and variation of the concentration of either thiamin (1–20μm) or sulphite (10–5000μm as sulphur dioxide). Plots of the logarithm of percentage of residual thiamin against time were found to be linear and cleavage thus was first-order with respect to thiamin. At pH5 the rate was also found to be proportional to the sulphite concentration. In the pH region 2·5–7·0 at 25° the rate constant was 50m−1hr.−1 at pH5·5–6·0, and decreased at higher or lower pH values. The rate of reaction increased between 20° and 70°, indicating a heat of activation of 13·6kcal./mole.

THE OXIDATION OF NITRITE AND IODATE IONS BY HYPOCHLORITE IONS

1961 ◽  
Vol 39 (8) ◽  
pp. 1645-1651 ◽  
Author(s):  
M. W. Lister ◽  
P. Rosenblum
Keyword(s):  
Activation Energy ◽  
Aqueous Solution ◽  
Rate Constant ◽  
Hypochlorous Acid ◽  
Slow Stage ◽  
Iodate Ions

The oxidation of nitrite ions and of iodate ions by hypochlorite ions in aqueous solution has been examined. The oxidation of nitrite is really a reaction of hypochlorous acid, with the slow stage HOCl + NO2− + H2O → H3O+ + Cl− + NO3−. The rate constant is given by log k = 7.36−6450/RT (time in minutes, and the activation energy in calories). The oxidation of iodate is chiefly a reaction of hypochlorite ions, probably ClO− + IO3− → Cl− + IO4−, although the rate is somewhat increased by a higher concentration of hydroxide ions. The rate constant is given by log k = 16.15−26,100/RT. These results are compared with other oxidations by hypochlorite ions, to see if any general trends are apparent.

scholarly journals EFFECT OF DIATOMEAOUS EARTH TREATMENT USING HYDROGEN CHLORIDE AND SULFURIC ACID ON KINETICS OF CADMIUM(II) ADSORPTION

2010 ◽  
Vol 2 (2) ◽  
pp. 107-112
Author(s):  
Nuryono Nuryono ◽  
Narsito Narsito
Keyword(s):  
Aqueous Solution ◽  
Sulfuric Acid ◽  
Hydrogen Chloride ◽  
Rate Constant ◽  
Diatomaceous Earth ◽  
Adsorption Rate ◽  
Physical Interaction ◽  
First Order ◽  
Adsorption Rate Constant ◽  
Kinetics Of

In this research, treatment of diatomaceous earth, Sangiran, Central Java using hydrogen chloride (HCl) and sulfuric acid (H2SO4) on kinetics of Cd(II) adsorption in aqueous solution has been carried out. The work was conducted by mixing an amount of grounded diatomaceous earth (200 mesh in size) with HCl or H2SO4 solution in various concentrations for two hours at temperature range of 100 - 150oC. The mixture was then filtered and washed with water until the filtrate pH is approximately 7 and then the residue was dried for four hours at a temperature of 70oC. The product was used as an adsorbent to adsorb Cd(II) in aqueous solution with various concentrations. The Cd(II) adsorbed was determined by analyzing the rest of Cd(II) in the solution using atomic absorption spectrophotometry. The effect of treatment was evaluated from kinetic parameter of adsorption rate constant calculated based on the simple kinetic model. Results showed  that before equilibrium condition reached, adsorpstion of Cd(II) occurred through two steps, i.e. a step tends to follow a reaction of irreversible first order  (step I) followed by reaction of reversible first order (step II). Treatment with acids, either hydrogen chloride or sulfuric acid, decreased adsorption rate constant for the step I from 15.2/min to a range of 6.4 - 9.4/min.  However, increasing concentration of acid (in a range of concentration investigated) did not give significant and constant change of adsorption rate constant. For step II process,  adsorption involved physical interaction with the sufficient low adsorption energy (in a range of 311.3 - 1001 J/mol).     Keywords: adsorption, cdmium, diatomaceous earth, kinetics.

Ligand substitution at five-coordinate copper(II) centres by cyanate, chloride and bromide ions

1980 ◽  
Vol 33 (6) ◽  
pp. 1381 ◽  
Author(s):  
JH Coates ◽  
PR Collins ◽  
SF Lincoln
Keyword(s):  
Aqueous Solution ◽  
Transition State ◽  
Ligand Substitution ◽  
Aqua Ligand ◽  
Stopped Flow ◽  
Bromide Ions ◽  
Ethyl Amine ◽  
Ligand Bond

The substitution of the aqua[tris{2-(dimethylamino)ethyl}amine]copper(II) ion by cyanate, chloride and bromide ions has been studied in aqueous solution by static and stopped-flow spectrophoto-metric techniques. This process is unusually slow for ligand substitution at a copper(II) centre and appears to proceed through an interchange mechanism in which the copper(II)-aqua ligand bond makes a major contribution to the transition state energetics.

Observation of a radical intermediate in the one electron oxidation of 5-methyl-1-thia-5-azacyclooctane by •Br2−

1984 ◽  
Vol 62 (9) ◽  
pp. 1874-1876 ◽  
Author(s):  
Warren Kenneth Musker ◽  
Parminder S. Surdhar ◽  
Rizwan Ahmad ◽  
David A. Armstrong
Keyword(s):  
Aqueous Solution ◽  
Rate Constant ◽  
Half Life ◽  
Cation Radical ◽  
Order Rate Constant ◽  
Type Structure ◽  
Radical Intermediate ◽  
Text Type ◽  
First Order ◽  
The One

The one electron oxidant •Br2− reacts with 5-methyl-1-thia-5-azacyclooctane (4) in aqueous solution at high pH with an overall rate constant of ~2 × 108 M s−1. The radical intermediate produced has a broad maximum at 500 nm with ε = 2400 M−1 cm−1 and at pH 10 decays with a first order rate constant of 2.3 ± 0.3 × 104 s−1, first half-life of 30 ± 5 μs. Its characteristics do not correspond to those of the [Formula: see text] species reported by Asmus and co-workers. The species appears to be the same as the cation radical reported earlier in the one electron oxidation of 4 in acetonitrile. This species is considered to have an [Formula: see text] type structure, which provides transannular stabilization.

Ambident nucleophiles. II. Nitrogen-bonded and carbon-bonded σ-complex formation in the reaction of pyrrolide anions with 1,3,5-trinitrobenzene

1982 ◽  
Vol 60 (15) ◽  
pp. 1988-1995 ◽  
Author(s):  
J. C. Halle ◽  
M. J. Pouet ◽  
M. P. Simonnin ◽  
F. Debleds ◽  
F. Terrier
Keyword(s):  
Aqueous Solution ◽  
Complex Formation ◽  
Rate Constant ◽  
Order Rate Constant ◽  
Reactive Species ◽  
Second Order ◽  
Potassium Salts ◽  
Strong Base ◽  
Order Rate

Reaction of 1,3,5-trinitrobenzene (TNB) with pyrrole, 2,5-dimethyl pyrrole, and 2,4-dimethyl-3-ethyl pyrrole in the presence of a strong base (CH3O−) yields nitrogen- and/or carbon-bonded 1:1 σ-complexes in dimethylsulphoxide (DMSO). Depending on the stoichiometry of the reagents, 1:2 and 2:1 pyrrole–TNB diadducts are also formed. Identification of all complexes was effected by nmr. The reactive species are shown to be the pyrrolide ions and the results emphasize the ambident character of these anions towards an aromatic electrophile. Some of the complexes have been isolated as crystalline potassium salts when experiments are performed in acetonitrile. Among the isolable complexes, the kineticallybutnotthermodynamicallyfavored nitrogen adduct of pyrrole (5a) is remarkably unreactive. The second-order rate constant kH+ for is H+-catalyzed decomposition in aqueous solution is only 1 L mol−1 s−1 (t = 25 °C).

Sign in / Sign up

Export Citation Format

Share Document