Radiation-Sensitized Thermal Cracking of n-Butane. II. Ionic Reactions

1975 ◽  
Vol 53 (1) ◽  
pp. 92-97 ◽  
Author(s):  
Shingo Matsuoka ◽  
Takaaki Tamura ◽  
Keichi Oshima ◽  
Yunosuke Oshima

Ionic reactions in the radiolysis of n-butane were studied at temperatures ranging from 17 to 548 °C. Ionic chain reactions were found for the first time to take part in the radiation-sensitized thermal cracking mechanism of hydrocarbon system.The isobutane and isobutene yields increased with increasing temperature and at 548 °C their G-values reached 31.2 and 12.1, respectively, though they were not formed by the thermal cracking of n-butane. The formation was completely suppressed by the addition of 0.15 mol% ammonia. They were produced with high yields irrespective of the kind of wall of the irradiation cells. It was concluded from these results that isobutane and isobutene were formed by homogeneous ionic chain reactions with activation energies. Part of the propane product was also found to have been formed by ionic chain reactions. From the effect of adding n-pentane on the yields of the ionic products, C4H9+ ion was inferred as the carrier ion.In the vicinity of room temperature, formation by ionic reactions of polymers with more than 14 carbon atoms was inferred from the material balance of the products from H2 to C14.

2010 ◽  
Vol 2010 (HITEC) ◽  
pp. 000167-000173
Author(s):  
R. Singh ◽  
S. Creamer ◽  
E. Lieser ◽  
S. Jeliazkov ◽  
S. Sundaresan

Through a systematic study, Silicon Carbide Gate Turn Off (GTO) Thyristors with record performance are demonstrated. Several Anode-Gate interdigitation schemes (raster, hex and involute) were explored to investigate their effect on the static as well as switching characteristics. An optimized edge-termination was employed that resulted in the achievement of near-theoretical forward blocking voltages (>8.1kV), and high yields (>60% on 8mm×8mm) on GTO Thyristors with 60μm/5×1014 cm−3 voltage-blocking epitaxial layers. A low differential specific on-resistance of 2.55 mΩ-cm2, and low on-state voltage drop were measured at 500 A/cm2. High Temperature forward I-V and reverse I-V characteristics show extremely stable performance with temperature, in contrast to state-of-the-art Si GTO Thyristors. Turn-on transient characteristics show a stable delay time of about 400 nano-seconds, and a rise-time that decreases with increasing temperature. Detailed high temperature turn-off measurements conducted using Anode-Switched mode was used to extract the value of minority carrier lifetimes as a function of temperature for the first time.


2021 ◽  
Vol 11 (2-S) ◽  
pp. 89-97
Author(s):  
Vishal Mane ◽  
Dhanjay Mane

The [DBN][HSO4] -promoted Knoevenagel condensation followed by cyclization protocol has been developed for the first time by a successive reaction of aldehydes, dimedone and malononitrile to afford 2-Amino-4H-pyrans derivatives in high to excellent yields at room temperature. The synergic couple of microwave and ionic liquid provided the capability to allow a variability of functional groups, short reaction times, easy workup, high yields, recyclability of the catalyst, and solvent-free conditions, thus providing economic and environmental advantages. Keywords: [DBN][HSO4], Environmentally benign, 2-Amino-4H-pyrans, Knoevenagel condensation, Microwave irradiation


2020 ◽  
Vol 23 (23) ◽  
pp. 2626-2634
Author(s):  
Saiedeh Kamalifar ◽  
Hamzeh Kiyani

: An efficient and facial one-pot synthesis of 4-aryl-3,4-dihydrobenzo[g]quinoline- 2,5,10(1H)-triones was developed for the first time. The process proceeded via the three-component cyclocondensation of 2-amino-1,4-naphthoquinone with Meldrum’s acid and substituted benzaldehydes under green conditions. The fused 3,4-dihydropyridin-2(1H)- one-ring naphthoquinones have been synthesized with good to high yields in refluxing ethanol as a green reaction medium. This protocol is simple and effective as well as does not involve the assistance of the catalyst, additive, or hazardous solvents.


2021 ◽  
Vol 9 (9) ◽  
pp. 3257-3263
Author(s):  
Jianwei Liu ◽  
Zhimin Ma ◽  
Zewei Li ◽  
Yan Liu ◽  
Xiaohua Fu ◽  
...  

Two isomers pDCzPyCN and oDCzPyCN are designed and synthesized. Amazingly, oDCzPyCN manifest white afterglow at room temperature. This is the first time that single-component white afterglow has finally been realized.


2021 ◽  
Author(s):  
Kinga Mlekodaj ◽  
Mariia Lemishka ◽  
Stepan Sklenak ◽  
Jiri Dedecek ◽  
Edyta Tabor

Here we demonstrate for the first time the splitting of dioxygen at RT over distant binuclear transition metal (M = Ni, Mn, and Co) centers stabilized in ferrierite zeolite. Cleaved...


Antibiotics ◽  
2021 ◽  
Vol 10 (8) ◽  
pp. 893
Author(s):  
Olufunto T. Fanoro ◽  
Sundararajan Parani ◽  
Rodney Maluleke ◽  
Thabang C. Lebepe ◽  
Jose R. Varghese ◽  
...  

We herein report a facile, green, cost-effective, plant-mediated synthesis of gold nanoparticles (AuNPs) for the first time using Combretum erythrophyllum (CE) plant leaves. The synthesis was conducted at room temperature using CE leaf extract serving as a reducing and capping agent. The as-synthesized AuNPs were found to be crystalline, well dispersed, and spherical in shape with an average diameter of 13.20 nm and an excellent stability of over 60 days. The AuNPs showed broad-spectrum antibacterial activities against both pathogenic Gram-positive (Staphylococcus epidermidis (ATCC14990), Staphylococcus aureus (ATCC 25923), Mycobacterium smegmatis (MC 215)) and Gram-negative bacteria (Proteus mirabilis (ATCC 7002), Escherichia coli (ATCC 25922), Klebsiella pneumoniae (ATCC 13822), Klebsiella oxytoca (ATCC 8724)), with a minimum inhibition concentration of 62.5 µg/mL. In addition, the as-synthesized AuNPs were highly stable with exceptional cell viability towards normal cells (BHK- 21) and cancerous cancer cell lines (cervical and lung cancer).


2019 ◽  
Vol 7 (36) ◽  
pp. 11085-11089
Author(s):  
Iwona Lazar ◽  
Monika Oboz ◽  
Jerzy Kubacki ◽  
Andrzej Majchrowski ◽  
Julita Piecha ◽  
...  

For the first time, a weak ferromagnetic hysteresis loop at room temperature has been observed in PbZr1−xTixO3 (PZT) single crystals.


2021 ◽  
Vol 12 (5) ◽  
pp. 645-649
Author(s):  
Yu Gu ◽  
Yuqing Qiao ◽  
Yusen Meng ◽  
Ming Yu ◽  
Bowu Zhang ◽  
...  

Herein, we report for the first time the synthesis of polypyrrole copolymers with good solvent-dispersibility under gamma-ray irradiation at room temperature in air.


1985 ◽  
Vol 25 (06) ◽  
pp. 945-953 ◽  
Author(s):  
Mark A. Miller ◽  
H.J. Ramey

Abstract Over the past 20 years, a number of studies have reported temperature effects on two-phase relative permeabilities in porous media. Some of the reported results, however, have been contradictory. Also, observed effects have not been explained in terms of fundamental properties known to govern two-phase flow. The purpose of this study was to attempt to isolate the fundamental properties affecting two-phase relative permeabilities at elevated temperatures. Laboratory dynamic-displacement relative permeability measurements were made on unconsolidated and consolidated sand cores with water and a refined white mineral oil. Experiments were run on 2-in. [5.1-cm] -diameter, 20-in. [52.-cm] -long cores from room temperature to 300F [149C]. Unlike previous researchers, we observed essentially no changes with temperature in either residual saturations or relative permeability relationships. We concluded that previous results may have been affected by viscous previous results may have been affected by viscous instabilities, capillary end effects, and/or difficulties in maintaining material balances. Introduction Interest in measuring relative permeabilities at elevated temperatures began in the 1960's with petroleum industry interest in thermal oil recovery. Early thermal oil recovery field operations (well heaters, steam injection, in-situ combustion) indicated oil flow rate increases far in excess of what was predicted by viscosity reductions resulting from heating. This suggested that temperature affects relative permeabilities. One of the early studies of temperature effects on relative permeabilities was presented by Edmondson, who performed dynamic displacement measurements with crude performed dynamic displacement measurements with crude and white oils and distilled water in Berea sandstone cores. Edmondson reported that residual oil saturations (ROS's) (at the end of 10 PV's of water injected) decreased with increasing temperature. Relative permeability ratios decreased with temperature at high water saturations but increased with temperature at low water saturations. A series of elevated-temperature, dynamic-displacement relative permeability measurements on clean quartz and "natural" unconsolidated sands were reported by Poston et al. Like Edmondson, Poston et al. reported a decrease in the "practical" ROS (at less than 1 % oil cut) as temperature increased. Poston et al. also reported an increase in irreducible water saturation. Although irreducible water saturations decreased with decreasing temperature, they did not revert to the original room temperature values. It was assumed that the cores became increasingly water-wet with an increase in both temperature and time; measured changes of the IFT and the contact angle with temperature increase, however, were not sufficient to explain observed effects. Davidson measured dynamic-displacement relative permeability ratios on a coarse sand and gravel core with permeability ratios on a coarse sand and gravel core with white oil displaced by distilled water, nitrogen, and superheated steam at temperatures up to 540F [282C]. Starting from irreducible water saturation, relative permeability ratio curves were similar to Edmondson's. permeability ratio curves were similar to Edmondson's. Starting from 100% oil saturation, however, the curves changed significantly only at low water saturations. A troublesome aspect of Davidson's work was that he used a hydrocarbon solvent to clean the core between experiments. No mention was made of any consideration of wettability changes, which could explain large increases in irreducible water saturations observed in some runs. Sinnokrot et al. followed Poston et al.'s suggestion of increasing water-wetness and performed water/oil capillary pressure measurements on consolidated sandstone and limestone cores from room temperature up to 325F [163C]. Sinnokrot et al confirmed that, for sandstones, irreducible water saturation appeared to increase with temperature. Capillary pressures increased with temperature, and the hysteresis between drainage and imbibition curves reduced to essentially zero at 300F [149C]. With limestone cores, however, irreducible water saturations remained constant with increase in temperature, as did capillary pressure curves. Weinbrandt et al. performed dynamic displacement experiments on small (0.24 to 0.49 cu in. [4 to 8 cm3] PV) consolidated Boise sandstone cores to 175F [75C] PV) consolidated Boise sandstone cores to 175F [75C] with distilled water and white oil. Oil relative permeabilities shifted toward high water saturations with permeabilities shifted toward high water saturations with increasing temperature, while water relative permeabilities exhibited little change. Weinbrandt et al. confirmed the findings of previous studies that irreducible water saturation increases and ROS decreases with increasing temperature. SPEJ P. 945


2014 ◽  
Vol 69 (11-12) ◽  
pp. 1229-1236
Author(s):  
Matthias Wörsching ◽  
Constantin Hoch

Abstract Cesium hydroxide, CsOH, was for the first time characterised on the basis of single-crystal data. The structure is isotypic to the one of the room-temperature modification of NaOH and can be derived from the NaCl structure type thus allowing the comparison of all alkali metal hydroxide structures. Raman spectroscopic investigations show the hydroxide anion to behave almost as a free ion as in the gas phase. The X-ray investigations indicate possible H atom positions.


Sign in / Sign up

Export Citation Format

Share Document