Kinetics and Mechanism for the Hydrolysis of Chlorothionoformate and Chlorodithioformate Esters in Water and Aqueous Acetone

1972 ◽  
Vol 50 (9) ◽  
pp. 1401-1406 ◽  
Author(s):  
D. M. McKinnon ◽  
A. Queen

The effects of structural changes on the rates of hydrolysis of a series of chlorothionoformate esters and the analogous chlorodithioformate esters have been studied. For both classes of compound, the reactivity is enhanced by increased electron donation by the hydrocarbon group. These results, the activation parameters for the hydrolyses of the methyl compounds, and the solvent isotope effect are shown to be consistent with the operation of the SN1 mechanism.

1970 ◽  
Vol 48 (4) ◽  
pp. 522-527 ◽  
Author(s):  
A. Queen ◽  
T. A. Nour ◽  
M. N. Paddon-Row ◽  
K. Preston

The effects of structural changes on the rates of hydrolysis of a series of thiochloroformate esters in water have been investigated. The reactivity is enhanced by increased electron donation by the hydro carbon group. These results, the activation parameters for the hydrolysis of methyl thiochloroformate and the solvent deuterium isotope effect, are shown to be consistent with the operation of the SN1 mechanism.


1975 ◽  
Vol 53 (6) ◽  
pp. 869-877 ◽  
Author(s):  
B. Rossall ◽  
R. E. Robertson

The temperature dependence of the rate of hydrolysis of benzoic, phthalic, and succinic anhydrides have been determined in H2O and D2O under "neutral" conditions. Corresponding data have been obtained for methyl trifluoroacetate. While both series supposedly react by the same BAc2 mechanism, remarkable differences are made obvious by this investigation. Possible sources of such differences are proposed.


1988 ◽  
Vol 254 (3) ◽  
pp. 899-901 ◽  
Author(s):  
T Selwood ◽  
M L Sinnott

1. Michaelis-Menten parameters for the hydrolysis of p-nitrophenyl alpha-L-arabinofuranoside were measured as a function of pL (pH or pD) in both 1H2O and 2H2O. 2. The variation of both Vmax. and Vmax./Km with pL is sigmoid, the pK governing Vmax. shifting from 6.34 +/- 0.05 in 1H2O to 6.84 +/- 0.07 in 2H2O, and that governing Vmax./Km from 5.89 +/- 0.03 in 1H2O to 6.38 +/- 0.05 in 2H2O. 3. In the plateau regions there is a small inverse solvent isotope effect on Vmax./Km (0.92), and one of 1.45 on Vmax. 4. The variation of Vmax. with isotopic composition is strictly linear, indicating that the isotope effect arises from the transfer of a single proton.


1999 ◽  
Vol 77 (5-6) ◽  
pp. 997-1004 ◽  
Author(s):  
X L Armesto ◽  
M Canle L. ◽  
V García ◽  
J A Santaballa

A kinetic study of the mechanism of oxidation of Ala-Gly and Pro-Gly by aqueous chlorine has been carried out. Among other experimental facts, the deuterium solvent isotope effects were used to clarify the mechanisms involved. In a first stage, N-chlorination takes place, and then the (N-Cl)-dipeptide decomposes through two possible mechanisms, depending on the acidity of the medium. The initial chlorination step shows a small isotope effect. In alkaline medium, two consecutive processes take place: first, the general base-catalyzed formation of an azomethine (β ca. 0.27), which has an inverse deuterium solvent isotope effect (kOH-/kOD- ~ 0.8). In a second step, the hydrolysis of the azomethine intermediate takes place, which is also general base-catalyzed, without deuterium solvent isotope effect, the corresponding uncatalyzed process having a normal deuterium solvent isotope effect (kH2O/kD2O ~ 2). In acid medium, the (N-Cl)-dipeptide undergoes disproportionation to a (N,N)-di-Cl-dipeptide, the very fast decomposition of the latter in deuterium oxide preventing a reliable estimation of the solvent isotope effect.Key words: chlorination, deuterium isotope effects, fractionation factors, peptide oxidation, water treatment.


1970 ◽  
Vol 23 (12) ◽  
pp. 2427
Author(s):  
ML Tonnet ◽  
AN Hambly

The values of the thermodynamic parameters of activation have been determined for the solvolysis of methanesulphonyl chloride in H2O and D2O and their mixtures with moderate amounts of dioxan. Some of the data are not in agreement with the postulate that the kinetic solvent isotope effect and the maximum in the rate of solvolysis produced by the addition of dioxan are due to changes in the initial state of the reacting system rather than to changes in the transition state. The addition of dioxan does not produce a large reduction in the solvent isotope effect as reported for the hydrolysis of t-butyl chloride and predicted to be general. The relative rates of solvolysis in mixtures of H2O and D2O are not in agreement with the analysis of such reactions by Swain and Thornton.


2021 ◽  
Author(s):  
Amani Alhifthi ◽  
Spencer Williams

1,2-<i>trans</i>-Glycosides hydrolyze through different mechanisms at different pH values, but systematic studies are lacking. Here we report the pH-rate constant profile for the hydrolysis of<i> </i>4-nitrophenyl β-D-glucoside. An inverse kinetic isotope effect (<i>k</i>(H<sub>3</sub>O<sup>+</sup>)/<i>k</i>(D<sub>3</sub>O<sup>+</sup>) = 0.63) in the acidic region indicates that the mechanism requires the formation of the conjugate acid of the substrate for the reaction to proceed, with heterolytic cleavage of the glycosidic C-O bond. Reactions in the pH-independent region exhibit general catalysis with a single proton in flight, a normal solvent isotope effect of <i>k</i><sub>H</sub>/<i>k</i><sub>D</sub> = 1.5, and when extrapolated to zero buffer concentration show a small solvent isotope effect <i>k</i>(H<sub>2</sub>O)/<i>k</i>(D<sub>2</sub>O) = 1.1, consistent with water attack through a dissociative mechanism. In the basic region, solvolysis in <sup>18</sup>O-labelled water and H<sub>2</sub>O/MeOH mixtures allowed detection of bimolecular hydrolysis and neighboring group participation, with a minor contribution of nucleophilic aromatic substitution. Under mildly basic conditions, a bimolecular concerted mechanism is implicated through an inverse solvent isotope effect of <i>k</i>(HO<sup>–</sup>)/<i>k</i>(DO<sup>–</sup>) = 0.5 and a strongly negative entropy of activation (D<i>S</i><sup>‡</sup> = –13.6 cal mol<sup>–1</sup> K<sup>–1</sup>). Finally, at high pH, an inverse solvent isotope effect of <i>k</i>(HO<sup>–</sup>)/<i>k</i>(DO<sup>–</sup>) = 0.6 indicates that the formation of 1,2-anhydrosugar is the rate determining step.<br>


1971 ◽  
Vol 49 (22) ◽  
pp. 3665-3670 ◽  
Author(s):  
R. E. Robertson ◽  
B. Rossall ◽  
W. A. Redmond

The large kinetic solvent isotope effects for the neutral hydrolysis of acetic and propionic anhydride show unusual temperature dependency; the former passing through a maximum at about 15°, the latter showing a minimum at 30°. This unusual temperature dependency is the consequence of widely different values of the apparent ΔCp≠ in H2O and D2O: the value for acetic anhydride in H2O being −74 ± 2 cal deg−1 mol−1 but −32 ± 4 in D2O. The corresponding values for propionic anhydride being −31 ± 2 in H2O but −94 ± 10 in D2O. The implications of these differences are discussed.


Sign in / Sign up

Export Citation Format

Share Document