Importance of heterogeneous termination in the pyrolysis of ethane

1967 ◽  
Vol 45 (24) ◽  
pp. 3165-3167 ◽  
Author(s):  
M. C. Lin ◽  
M. H. Back
Keyword(s):  
Thermal Decomposition ◽  
Ethyl Radical ◽  
Termination Process

It is shown that the increase in the order of the thermal decomposition of ethane that is observed below about 200 mm is partly the result of the changes in the order of the unimolecular dissociations of ethane and the ethyl radical that occur in the same range of pressures, and partly the result of the increasing importance of a heterogeneous termination process as the pressure is lowered.

Ethyl radical initiated thermal decomposition of biacetyl

1976 ◽  
Vol 5 (2) ◽  
pp. 141-147 ◽  
Author(s):  
R. Schliebs ◽  
H. Knoll ◽  
K. Scherzer
Keyword(s):  
Thermal Decomposition ◽  
Ethyl Radical

THE THERMAL DECOMPOSITION OF ETHANE: PART I. INITIATION AND TERMINATION STEPS

1966 ◽  
Vol 44 (4) ◽  
pp. 505-514 ◽  
Author(s):  
M C. Lin ◽  
M. H. Back
Keyword(s):  
Thermal Decomposition ◽  
High Pressure ◽  
Rate Coefficients ◽  
First Order ◽  
Temperature Range ◽  
Order Rate ◽  
Ethyl Radical ◽  
Initiation Reaction ◽  
Ethyl Radicals

The rates of production of methane and butane in the pyrolysis of ethane have been measured over the temperature range 550–620 °C and at pressures of 40–600 mm. At high pressure the rates of formation of both products were first order in ethane, but below 200 mm the first-order rate coefficients decreased. The ratio of methane to butane was consistent with the interpretation that methane is a measure of the initiation reaction and that the combination and disproportionation of ethyl radicals is the main termination step. The order of the decomposition of the ethyl radical with respect to ethane varied between 0.38 and 0.59. The results are discussed in terms of the mechanism of the overall process.

Thermal decomposition of the ethyl radical

1967 ◽  
Vol 45 (22) ◽  
pp. 2795-2803 ◽  
Author(s):  
L. F. Loucks ◽  
K. J. Laidler
Keyword(s):  
Thermal Decomposition ◽  
Entire Range ◽  
Pressure Range ◽  
Heat Of Formation ◽  
Unimolecular Decomposition ◽  
Kcal Mole ◽  
Ethyl Radical ◽  
A Value ◽  
Kinetics Of ◽  
Best Fit

The kinetics of the thermal decomposition of the ethyl radical to give an ethylene molecule and a hydrogen atom were studied over the pressure range 4 to 650 mm Hg and the temperature range 400 to 500 °C; the mercury-photosensitized decomposition of ethane was used to generate the ethyl radical. The unimolecular decomposition of the ethyl radical was found to be pressure dependent over the entire range of pressures studied, with the order of reaction varying from 1.6 for the lowest pressures to 1.4 at the highest pressures. The extrapolated high-pressure and low-pressure rate constants for the decomposition of the ethyl radical are given by [Formula: see text] [Formula: see text]A best fit of the Kassel equation to the observed pressure dependence shows that s = 8 for this reaction. The results lead to a value of 98 1 kcal/mole for the bond dissociation energy D(C2H5—H). The heat of formation of the ethyl radical was calculated to be 30.0 and 26.2 kcal/mole for 0 °K and 25 °C respectively.

Applications of Photoelectron Microscopy

1976 ◽  
Vol 34 ◽  
pp. 506-507
Author(s):  
William J. Baxter
Keyword(s):  
Electron Microscopy ◽  
Thermal Decomposition ◽  
Chemical Composition ◽  
Ultraviolet Radiation ◽  
Thin Layer ◽  
Edge Effects ◽  
Electron Optics ◽  
Surface Layers ◽  
Crystalline Orientation ◽  
Fluorescent Screen

In this form of electron microscopy, photoelectrons emitted from a metal by ultraviolet radiation are accelerated and imaged onto a fluorescent screen by conventional electron optics. image contrast is determined by spatial variations in the intensity of the photoemission. The dominant source of contrast is due to changes in the photoelectric work function, between surfaces of different crystalline orientation, or different chemical composition. Topographical variations produce a relatively weak contrast due to shadowing and edge effects.Since the photoelectrons originate from the surface layers (e.g. ∼5-10 nm for metals), photoelectron microscopy is surface sensitive. Thus to see the microstructure of a metal the thin layer (∼3 nm) of surface oxide must be removed, either by ion bombardment or by thermal decomposition in the vacuum of the microscope.

Preparation and characterisation of vanadium pentoxide supported rhodium catalyst

1988 ◽  
Vol 46 ◽  
pp. 946-947
Author(s):  
A. Legrouri
Keyword(s):  
Aqueous Solution ◽  
Thermal Decomposition ◽  
Physicochemical Properties ◽  
Surface Area ◽  
Vanadium Pentoxide ◽  
High Purity ◽  
Gas Adsorption ◽  
Rhodium Catalyst ◽  
Optical Methods ◽  
Reducible Oxides

The industrial importance of metal catalysts supported on reducible oxides has stimulated considerable interest during the last few years. This presentation reports on the study of the physicochemical properties of metallic rhodium supported on vanadium pentoxide (Rh/V2O5). Electron optical methods, in conjunction with other techniques, were used to characterise the catalyst before its use in the hydrogenolysis of butane; a reaction for which Rh metal is known to be among the most active catalysts.V2O5 powder was prepared by thermal decomposition of high purity ammonium metavanadate in air at 400 °C for 2 hours. Previous studies of the microstructure of this compound, by HREM, SEM and gas adsorption, showed it to be non— porous with a very low surface area of 6m2/g3. The metal loading of the catalyst used was lwt%Rh on V2Q5. It was prepared by wet impregnating the support with an aqueous solution of RhCI3.3H2O.

Observations of the Thermal Decomposition of Brucite

1968 ◽  
Vol 26 ◽  
pp. 446-447
Author(s):  
P. L. Burnett ◽  
W. R. Mitchell ◽  
C. L. Houck
Keyword(s):  
Thermal Decomposition ◽  
Magnesium Oxide ◽  
Basal Plane ◽  
Magnesium Ions ◽  
A Value ◽  
Reaction Proceeds

Natural Brucite (Mg(OH)2) decomposes on heating to form magnesium oxide (MgO) having its cubic ﹛110﹜ and ﹛111﹜ planes respectively parallel to the prism and basal planes of the hexagonal brucite lattice. Although the crystal-lographic relation between the parent brucite crystal and the resulting mag-nesium oxide crystallites is well known, the exact mechanism by which the reaction proceeds is still a matter of controversy. Goodman described the decomposition as an initial shrinkage in the brucite basal plane allowing magnesium ions to shift their original sites to the required magnesium oxide positions followed by a collapse of the planes along the original <0001> direction of the brucite crystal. He noted that the (110) diffraction spots of brucite immediately shifted to the positions required for the (220) reflections of magnesium oxide. Gordon observed separate diffraction spots for the (110) brucite and (220) magnesium oxide planes. The positions of the (110) and (100) brucite never changed but only diminished in intensity while the (220) planes of magnesium shifted from a value larger than the listed ASTM d spacing to the predicted value as the decomposition progressed.

A magnetic super lattice

1987 ◽  
Vol 45 ◽  
pp. 360-361 ◽  
Author(s):  
M.D. Bentzon ◽  
J. v. Wonterghem ◽  
A. Thölén
Keyword(s):  
Thermal Decomposition ◽  
Oleic Acid ◽  
Magnetic Fluid ◽  
Magnetic Particles ◽  
Carbon Film ◽  
Thick Layer ◽  
Amorphous Iron ◽  
Super Lattice ◽  
Carrier Liquid ◽  
Median Diameter

We report on the oxidation of a magnetic fluid. The oxidation results in magnetic super lattice crystals. The “atoms” are hematite (α-Fe2O3) particles with a diameter ø = 6.9 nm and they are covered with a 1-2 nm thick layer of surfactant molecules.Magnetic fluids are homogeneous suspensions of small magnetic particles in a carrier liquid. To prevent agglomeration, the particles are coated with surfactant molecules. The magnetic fluid studied in this work was produced by thermal decomposition of Fe(CO)5 in Declin (carrier liquid) in the presence of oleic acid (surfactant). The magnetic particles consist of an amorphous iron-carbon alloy. For TEM investigation a droplet of the fluid was added to benzine and a carbon film on a copper net was immersed. When exposed to air the sample starts burning. The oxidation and electron irradiation transform the magnetic particles into hematite (α-Fe2O3) particles with a median diameter ø = 6.9 nm.

Supersonic jet spectrometry of chemical species resulting from thermal decomposition of polystyrene and polycarbonate

1992 ◽  
Vol 64 (19) ◽  
pp. 931A-940A ◽  
Author(s):  
Totaro Imasaka ◽  
Masami Hozumi ◽  
Nobuhiko Ishibashi
Keyword(s):  
Thermal Decomposition ◽  
Supersonic Jet ◽  
Chemical Species
Sign in / Sign up

Export Citation Format

Share Document