An empirical evaluation of pressuremeter test data

1981 ◽  
Vol 18 (3) ◽  
pp. 455-459 ◽  
Author(s):  
M. Arnold

In situ pressuremeter tests have in recent years come into wide use in the determination of the parameters to be used for foundation design. Although theoretically correct analytical expressions have been developed for the radial expansion pressure versus radial strain relationship, these are generally cumbersome and difficult to use and in practice a graphical procedure is commonly used to derive the maximum undrained shear stress and the undrained modulus value from the test data.To overcome the disadvantages that this graphical procedure involves an empirically-derived analytical relationship based on Kondner's hyperbolic stress–strain relationship is presented here, by means of which all the derived parameters can be obtained simply and without recourse to graphical construction.

2001 ◽  
Author(s):  
Chi Hsiang Pan ◽  
Chien Li Tung

Abstract In this paper, we present a simple method to determine thermal conductivity coefficients (TCC) of thin films with a compact characterization microstructure and by using common measuring apparatus. The microstructure can be fabricated by a simple surface micromachining technique and in situ along with active devices on the same chip. Analytical expressions are derived to calculate the thermal conductivity coefficients of thin films from the experimental data. Experimental results with a heavily n-doped LPCVD poly crystalline silicon film are used herein to demonstrate the effectiveness of the proposed method. The obtained thermal conductivity coefficient seems to decrease a little as temperature increase and the average is around 39 Wm−1 °C−1 at 400°C below.


2018 ◽  
Vol 14 (2) ◽  
Author(s):  
Marcos Fábio Porto de Aguiar ◽  
Fernando Feitosa Monteiro ◽  
Francisco Heber Lacerda de Oliveira ◽  
Yago Machado Pereira de Matos

RESUMO: Em meio aos diversos métodos utilizados no Brasil para determinação da capacidade de carga de fundações, a grande maioria parte do índice de resistência à penetração (NSPT). Para o caso de pequenas edificações, devido a fatores geralmente econômicos, a experiência ou a prática regional costumam prevalecer. Sendo assim, são elaborados, muitas vezes, projetos sem um procedimento de cálculo fundamentado em parâmetros comprovados por ensaios geotécnicos, podendo ocasionar problemas na edificação, como recalques excessivos, ou, até mesmo, comprometer a segurança da estrutura. Dessa forma, técnicas mais simples e de baixo custo, como o DPL (Dynamic Probing Light), podem ser uma opção para situações de pequenas cargas, viabilizando projetos fundamentados em ensaios in situ. Partindo de investigações com o DPL, este trabalho tem o objetivo de dimensionar fundações superficiais e profundas para edificações de pequeno porte através de algumas das principais metodologias disponíveis na literatura e verificar a sua eficiência. Por meio de resultados de campanhas de sondagens SPT (Standard Penetration Test) e DPL no campo experimental da Universidade de Fortaleza (UNIFOR), determinou-se a capacidade de carga de fundações superficiais e profundas fazendo aplicação dos índices NSPT e NSPT equivalente obtido pela correlação com o DPL. Identificou-se que essa correlação apresentou coeficiente de determinação satisfatório entre os parâmetros obtidos nos ensaios SPT e DPL para o terreno em questão, mostrando-se o DPL ser uma alternativa pertinente, em termos técnicos para projetos de fundações de obras de pequeno porte.ABSTRACT: Among the various methods used in Brazil of the determination of the bearing capacity on foundations, most part uses the standard penetration resistance (NSPT). For small constructions, due to economic factors generally, experience or regional practice usually prevails. Thus, projects without a reasoned calculation procedure in parameters supported by geotechnical tests are often designed, and may cause problems in the building, as excessive settlements, or even compromise the safety of the structure. In this way, simple and low cost techniques such as DPL (Dynamic Probing Light) may be an option for small loads situations, enabling projects based on in situ tests. This paper proposes to calculate the dimensions of shallow and deep foundations for small constructions and check its efficiency using DPL tests. Through the results of SPT (Standard Penetration Test) and DPL tests in the experimental field of the University of Fortaleza (UNIFOR), the determination of the bearing capacity in shallow and deep foundations was done using NSPT index and equivalent NSPT index obtained by the correlation with DPL. A correlation with satisfactory coefficient of determination was obtained between SPT and DPL tests parameters for the analyzed field, showing up the DPL as an appropriate alternative in technical terms for foundation design of small constructions.


2006 ◽  
Vol 43 (9) ◽  
pp. 915-927 ◽  
Author(s):  
Vincenzo Silvestri

A method is proposed for assessing the effect of strain rate on pressuremeter test results in clay. The approach takes into account the strain rate used to expand the cavity and its variation within the soil mass, both of which influence the value of the undrained shear strength deduced from the pressuremeter expansion curve. The method is applied to quantify strain-rate effects in idealized materials and in model pressuremeter test results. The pressuremeter-deduced stress–strain curve is also used to predict the total pressure – radial strain relationship observed in one of the model tests.Key words: pressuremeter test, clays, strain rate, idealized materials, model tests.


1961 ◽  
Vol 38 (4) ◽  
pp. 545-562 ◽  
Author(s):  
L. Kecskés ◽  
F. Mutschler ◽  
I. Glós ◽  
E. Thán ◽  
I. Farkas ◽  
...  

ABSTRACT 1. An indirect paperchromatographic method is described for separating urinary oestrogens; this consists of the following steps: acidic hydrolysis, extraction with ether, dissociation of phenol-fractions with partition between the solvents. Previous purification of phenol fraction with the aid of paperchromatography. The elution of oestrogen containing fractions is followed by acetylation. Oestrogen acetate is isolated by re-chromatography. The chromatogram was developed after hydrolysis of the oestrogens 'in situ' on the paper. The quantity of oestrogens was determined indirectly, by means of an iron-reaction, after the elution of the iron content of the oestrogen spot, which was developed by the Jellinek-reaction. 2. The method described above is satisfactory for determining urinary oestrogen, 17β-oestradiol and oestriol, but could include 16-epioestriol and other oestrogenic metabolites. 3. The sensitivity of the method is 1.3–1.6 μg/24 hours. 4. The quantitative and qualitative determination of urinary oestrogens with the above mentioned method was performed in 50 pregnant and 9 non pregnant women, and also in 2 patients with granulosa cell tumour.


2020 ◽  
Author(s):  
Keishiro Yamashita ◽  
Kazuki Komatsu ◽  
Hiroyuki Kagi

An crystal-growth technique for single crystal x-ray structure analysis of high-pressure forms of hydrogen-bonded crystals is proposed. We used alcohol mixture (methanol: ethanol = 4:1 in volumetric ratio), which is a widely used pressure transmitting medium, inhibiting the nucleation and growth of unwanted crystals. In this paper, two kinds of single crystals which have not been obtained using a conventional experimental technique were obtained using this technique: ice VI at 1.99 GPa and MgCl<sub>2</sub>·7H<sub>2</sub>O at 2.50 GPa at room temperature. Here we first report the crystal structure of MgCl2·7H2O. This technique simultaneously meets the requirement of hydrostaticity for high-pressure experiments and has feasibility for further in-situ measurements.


1983 ◽  
Author(s):  
K. Arulanandan ◽  
Y. Dafalias ◽  
L. R. Herrmann ◽  
A. Anandarajah ◽  
N. Meegoda

Sign in / Sign up

Export Citation Format

Share Document