Preliminary Analysis of Geophysical Measurements North of Juan de Fuca Ridge

1971 ◽  
Vol 8 (10) ◽  
pp. 1265-1281 ◽  
Author(s):  
S. P. Srivastava ◽  
D. L. Barrett ◽  
C. E. Keen ◽  
K. S. Manchester ◽  
K. G. Shih ◽  
...  

Preliminary analyses of gravity, magnetic, seismic reflection and refraction, dredging, and heat flow measurements off Queen Charlotte Islands and Vancouver Island are presented. Seismic reflection and gravity measurements show the presence of a sedimentary basin at the foot of the continental slope in which the sediments are progressively more intensely deformed from north to south, indicating the interactions between the lithospheric plates. Heat flow values in the northern part of Explorer Ridge, and recovery of fresh basalts with little mineral coating in this region suggest that Explorer Ridge is a presently active spreading segment of East Pacific Rise. Seismic Refraction results in the deep ocean basin west of Queen Charlotte Islands show a marked anisotropic mantle P wave velocity, the direction of maximum velocity being 107° east of north and the maximum change in velocity being about 0.6 km/s.

2010 ◽  
Vol 47 (4) ◽  
pp. 389-408 ◽  
Author(s):  
Claire Perry ◽  
Carmen Rosieanu ◽  
Jean-Claude Mareschal ◽  
Claude Jaupart

Geothermal studies were conducted within the framework of Lithoprobe to systematically document variations of heat flow and surface heat production in the major geological provinces of the Canadian Shield. One of the main conclusions is that in the Shield the variations in surface heat flow are dominated by the crustal heat generation. Horizontal variations in mantle heat flow are too small to be resolved by heat flow measurements. Different methods constrain the mantle heat flow to be in the range of 12–18 mW·m–2. Most of the heat flow anomalies (high and low) are due to variations in crustal composition and structure. The vertical distribution of radioelements is characterized by a differentiation index (DI) that measures the ratio of the surface to the average crustal heat generation in a province. Determination of mantle temperatures requires the knowledge of both the surface heat flow and DI. Mantle temperatures increase with an increase in surface heat flow but decrease with an increase in DI. Stabilization of the crust is achieved by crustal differentiation that results in decreasing temperatures in the lower crust. Present mantle temperatures inferred from xenolith studies and variations in mantle seismic P-wave velocity (Pn) from seismic refraction surveys are consistent with geotherms calculated from heat flow. These results emphasize that deep lithospheric temperatures do not always increase with an increase in the surface heat flow. The dense data coverage that has been achieved in the Canadian Shield allows some discrimination between temperature and composition effects on seismic velocities in the lithospheric mantle.


1971 ◽  
Vol 8 (9) ◽  
pp. 1056-1064 ◽  
Author(s):  
C. E. Keen ◽  
D. L. Barrett

A seismic refraction experiment was conducted in the Pacific Ocean basin, off the coast of British Columbia, Canada. The purpose of these measurements was to obtain an estimate of the anisotropy of the mantle P-wave velocity in the area and to relate this parameter to the direction of sea floor spreading. The results show that the crustal structure is similar to that measured elsewhere in the Pacific basin. Significant anisotropy of the mantle rocks is observed; the direction in which the maximum velocity occurs being 107° and the change of velocity, about 8% of the mean value, 8.07 km/s. The direction of maximum velocity does not coincide exactly with the direction of sea floor spreading, 090°, inferred from magnetic lineations.


1973 ◽  
Vol 10 (8) ◽  
pp. 1267-1278 ◽  
Author(s):  
C. E. Keen ◽  
D. L. Barrett

Geophysical measurements along tracks crossing some of the main structural features of the northern Baffin Bay shelf are described. The data consist of seismic reflection, seismic refraction, gravity, and magnetic measurements. Results in four areas—Lancaster Sound, Melville Bay, Smith Sound and Jones Sound—are presented. Magnetic and gravity data are used to define the extent of sedimentary basins in these areas. Seismic reflection measurements delineate the structural characteristics of the upper 2 km of the sedimentary strata and allow comparisons between them to be made. Seismic refraction measurements show that the upper 2 km of sediment exhibit low velocities—less than 3.2 km/s. Little deformation of the sediments is observed in any of these areas, however, the strata in Lancaster Sound and in the Melville Bay graben appear to have experienced less faulting than those in Jones Sound and Smith Sound. Normal faults are characteristic of the latter two areas. Jones Sound is a structurally complex area and is filled by a lesser thickness of sediments than is found in the other basins. These sediments are terminated near the entrance to the sound by Precambrian basement. A deeper sedimentary basin occupies Smith Sound and trends across the Nares Strait lineament. Although the data are insufficient to allow a detailed structural analysis of the strata in these regions, we speculate that the differences in sedimentary structures can be related to the formation of the Baffin Bay ocean basin.


1964 ◽  
Vol 54 (1) ◽  
pp. 41-50
Author(s):  
A. R. Milne

abstract The data from two reversed seismic refraction profiles in the Northeast Pacific are presented as two separate structure sections. One profile was located at the southern limit of the Alaskan Abyssal Plain near 48°N and 136°W. At this location the crustal thickness was abnormally thin, 5.0 kilometers. A second profile was located on the Continental Shelf at the west end of Dixon Entrance, northwest of the Queen Charlotte Islands. This profile indicated the absence of oceanic layering and the presence of a layer with a velocity of 6.16 km/sec, typical of continental granites.


Geophysics ◽  
2014 ◽  
Vol 79 (3) ◽  
pp. B123-B134 ◽  
Author(s):  
Fabienne Reiser ◽  
Joel E. Podgorski ◽  
Cedric Schmelzbach ◽  
Heinrich Horstmeyer ◽  
Alan G. Green ◽  
...  

Electrical resistivity models derived from exceptionally high-quality helicopter transient electromagnetic data recorded across the Okavango Delta in Botswana, one of the world’s great inland deltas or megafans, include three principal layers: (1) an upper heterogeneous layer of dry and water-saturated sand, (2) an intermediate electrically conductive layer that likely comprises saline-water-saturated sand and clay, and (3) a lower fan-shaped electrically resistive layer of freshwater-saturated sand/gravel and/or crystalline basement. If part of the lower layer comprises a freshwater aquifer, it would be evidence for a recently proposed Paleo Okavango Megafan and a major new source of freshwater. In an attempt to constrain the interpretation of the lower layer, we acquired two high-resolution seismic refraction and reflection data sets at each of two investigation sites: one near the center of the delta and one along its western edge. The interface between unconsolidated sediments and basement near the center of the delta is well defined by an [Formula: see text] to [Formula: see text] increase in P-wave velocities, a change in seismic reflection facies, and a strong continuous reflection. This interface is about 45 m deeper than the top of the lower resistive layer, thus providing support for the Paleo Okavango Megafan hypothesis. Subhorizontal seismic reflectors are additional evidence for a sedimentary origin of the upper part of the lower resistive layer. In contrast to the observations at the delta’s center, the interface between unconsolidated sediments and basement along its western edge, which is also defined by a [Formula: see text] to [Formula: see text] increase in P-wave velocities and a continuous reflection, coincides with the top of the resistive layer.


2020 ◽  
Vol 25 (3) ◽  
pp. 415-423
Author(s):  
Ahmed Lachhab ◽  
El Mehdi Benyassine ◽  
Mohamed Rouai ◽  
Abdelilah Dekayir ◽  
Jean C. Parisot ◽  
...  

The tailings of Zeida's abandoned mine are found near the city of Midelt, in the middle of the high Moulouya watershed between the Middle and the High Atlas of Morocco. The tailings occupy an area of about 100 ha and are stored either in large mining pit lakes with clay-marl substratum or directly on a heavily fractured granite bedrock. The high contents of lead and arsenic in these tailings have transformed them into sources of pollution that disperse by wind, runoff, and seepage to the aquifer through faults and fractures. In this work, the main goal is to identify the pathways of contaminated water with heavy metals and arsenic to the local aquifers, water ponds, and Moulouya River. For this reason, geophysical surveys including electrical resistivity tomography (ERT), seismic refraction tomography (SRT) and very low-frequency electromagnetic (VLF-EM) methods were carried out over the tailings, and directly on the substratum outside the tailings. The result obtained from combining these methods has shown that pollutants were funneled through fractures, faults, and subsurface paleochannels and contaminated the hydrological system connecting groundwater, ponds, and the river. The ERT profiles have successfully shown the location of fractures, some of which extend throughout the upper formation to depths reaching the granite. The ERT was not successful in identifying fractures directly beneath the tailings due to their low resistivity which inhibits electrical current from propagating deeper. The seismic refraction surveys have provided valuable details on the local geology, and clearly identified the thickness of the tailings and explicitly marked the boundary between the Triassic formation and the granite. It also aided in the identification of paleochannels. The tailings materials were easily identified by both their low resistivity and low P-wave velocity values. Also, both resistivity and seismic velocity values rapidly increased beneath the tailings due to the compaction of the material and lack of moisture and have proven to be effective in identifying the upper limit of the granite. Faults were found to lie along the bottom of paleochannels, which suggest that the locations of these channels were caused by these same faults. The VLF-EM surveys have shown tilt angle anomalies over fractured areas which were also evinced by low resistivity area in ERT profiles. Finally, this study showed that the three geophysical methods were complementary and in good agreement in revealing the pathways of contamination from the tailings to the local aquifer, nearby ponds and Moulouya River.


Geophysics ◽  
2001 ◽  
Vol 66 (6) ◽  
pp. 1838-1842 ◽  
Author(s):  
C. M. Schmeissner ◽  
K. T. Spikes ◽  
D. W. Steeples

Ultrashallow seismic reflection surveys require dense spatial sampling during data acquisition, which increases their cost. In previous efforts to find ways to reduce these costs, we connected geophones rigidly to pieces of channel iron attached to a farm implement. This method allowed us to plant the geophones in the ground quickly and automatically. The rigidly interconnected geophones used in these earlier studies detected first‐arrival energy along with minor interfering seismic modes, but they did not detect seismic reflections. To examine further the feasibility of developing rigid geophone emplacement systems to detect seismic reflections, we experimented with four pieces of channel iron, each 2.7 m long and 10 cm wide. Each segment was equipped with 18 geophones rigidly attached to the channel iron at 15‐cm intervals, and the spikes attached to all 18 geophones were pushed into the ground simultaneously. The geophones detected both refracted and reflected energy; however, no significant signal distortion or interference attributable to the rigid coupling of the geophones to the channel iron was observed in the data. The interfering seismic modes mentioned from the previous experiments were not detected, nor was any P‐wave propagation noted within the channel iron. These results show promise for automating and reducing the cost of ultrashallow seismic reflection and refraction surveys.


2017 ◽  
Vol 479 ◽  
pp. 340-353 ◽  
Author(s):  
Florian Neumann ◽  
Raquel Negrete-Aranda ◽  
Robert N. Harris ◽  
Juan Contreras ◽  
John G. Sclater ◽  
...  

1984 ◽  
Vol 74 (4) ◽  
pp. 1263-1274
Author(s):  
Lawrence H. Jaksha ◽  
David H. Evans

Abstract A velocity model of the crust in northwestern New Mexico has been constructed from an interpretation of direct, refracted, and reflected seismic waves. The model suggests a sedimentary section about 3 km thick with an average P-wave velocity of 3.6 km/sec. The crystalline upper crust is 28 km thick and has a P-wave velocity of 6.1 km/sec. The lower crust below the Conrad discontinuity has an average P-wave velocity of about 7.0 km/sec and a thickness near 17 km. Some evidence suggests that velocity in both the upper and lower crust increases with depth. The P-wave velocity in the uppermost mantle is 7.95 ± 0.15 km/sec. The total crustal thickness near Farmington, New Mexico, is about 48 km (datum = 1.6 km above sea level), and there is evidence for crustal thinning to the southeast.


Sign in / Sign up

Export Citation Format

Share Document