Aberrations in flower development in Silene

1979 ◽  
Vol 57 (3) ◽  
pp. 233-235 ◽  
Author(s):  
R. F. Lyndon
Keyword(s):  
Growth Rate ◽  
Flower Development ◽  
Low Temperatures ◽  
Floral Induction ◽  
The Other ◽  
High And Low Temperatures ◽  
Normal Flower ◽  
Floral Whorls

The occurrence of aberrant numbers of floral parts in Silene coeli-rosa was most frequent at high and low temperatures but was not obviously correlated with effectiveness of floral induction or with the growth rate of the flower. The stamens were more often aberrant than the other floral whorls. Aberrations seemed to occur independently in the different floral whorls, except in the case of the sepals and petals, since almost half the plants with aberrant numbers of sepals showed the same aberration in the petals. The findings are considered in relation to normal flower development.

Comparative Observations on the Morphology and Biology of some Hymenopterous Parasites of Carrion-infesting Diptera

1933 ◽  
Vol 24 (3) ◽  
pp. 385-405 ◽  
Author(s):  
A. C. Evans
Keyword(s):  
Comparative Study ◽  
Low Temperatures ◽  
Lucilia Sericata ◽  
The Other ◽  
Advanced Stage ◽  
Larval Morphology ◽  
Sense Organs ◽  
High And Low Temperatures

1. The biology and larval morphology of three Alysiine Braconids and one Chalcid, parasites of the pre-imaginal stages of some carrion-infesting Dipterous larvae, are described.2. The mode of hibernation of the parasites is recorded.3. The oviposition of Alysia manducator and Aphaereta minuta is discussed in detail, attention being drawn to the hitherto neglected sense-organs located in the tarsi of these two species and to their importance in the process of oviposition.4. The differing responses of full-grown Lucilia sericata larvae to parasitism by Alysia manducator at high and low temperatures are suggested to be due to differences in the physiological states of the host larvae at these temperatures.5. A comparative study of the three endoparasitic Alysiines suggests that Alysia manducator may have reached a state of endoparasitic life relatively later than the other species studied, or at least has not yet reached such an advanced stage of endoparasitic specialisation as have Aphaereta minuta and Aspilota nervosa.6. The growth of the egg in Aphaereta minuta and Alysia manducator and of the larvae of Mormoniella vitripennis is discussed.

Growth and Performance of Agriculture Sector in India

2015 ◽  
Vol 3 (2) ◽  
Author(s):  
Naresh Singla ◽  
Mamandeep Kaur
Keyword(s):  
Growth Rate ◽  
Capital Formation ◽  
The Other ◽  
Agricultural Credit ◽  
Agricultural Growth ◽  
Indian Economy ◽  
Agriculture Sector ◽  
Food Grain ◽  
And Performance ◽  
Agricultural Labourers

The growth of agriculture and allied sectors is critical for the Indian economy as about 49 percent of the population is directly or indirectly dependent on agriculture. During the last decade and so, the agriculture sector has undergone profound changes resulting in sharp deceleration in its growth. The study has attempted to analyze growth and performance of the agriculture sector in India since 1980-81 and tries to comprehend some of the factors responsible for the deceleration in growth. The study has shown that agriculture sector has been able to show tremendous improvement in expansion of area and production of food grain and non-food grain crops. However, there are so many underlying factors responsible for slowdown of the agricultural growth. Some of the factors identified include: Increase in area under non-agriculture uses, excessive dependence on rain fed farming, increase in number of agricultural labourers, reducing size of the operation holdings, over use of agri-inputs, inequity in the distribution of agriculture credit along with sharp deceleration in public gross capital formation in agriculture etc. The study pointed in order to achieve higher growth rate, there is a need to enhance the gross capital formation in agriculture sector particularly on irrigation so that more area can be brought under assured irrigation. Bringing equity in distribution of agricultural credit coupled with judicious and need-based agricultural inputs are some of the other recommendations drawn based upon the study.

A polycentric growth model of gallium arsenide epitaxial layers from the gas phase with simultaneous diffusion, adsorption and chemical reaction

1988 ◽  
Vol 53 (12) ◽  
pp. 2995-3013
Author(s):  
Emerich Erdös ◽  
Jindřich Leitner ◽  
Petr Voňka ◽  
Josef Stejskal ◽  
Přemysl Klíma
Keyword(s):  
Growth Rate ◽  
Gallium Arsenide ◽  
Epitaxial Growth ◽  
Gas Phase ◽  
Surface Reaction ◽  
Quantitative Description ◽  
The Other ◽  
Rate Equations ◽  
Impact Interaction ◽  
Partial Pressures

For a quantitative description of the epitaxial growth rate of gallium arsenide, two models are proposed including two rate controlling steps, namely the diffusion of components in the gas phase and the surface reaction. In the models considered, the surface reaction involves a reaction triple - or quadruple centre. In both models three mechanisms are considered which differ one from the other by different adsorption - and impact interaction of reacting particles. In every of the six cases, the pertinent rate equations were derived, and the models have been confronted with the experimentally found dependences of the growth rate on partial pressures of components in the feed. The results are discussed with regard to the plausibility of individual mechanisms and of both models, and also with respect to their applicability and the direction of further investigations.

Simple Systems

2017 ◽  
Author(s):  
Jochen Rau
Keyword(s):  
Magnetic Field ◽  
Low Temperatures ◽  
General Framework ◽  
Gibbs State ◽  
Macroscopic System ◽  
Basic Model ◽  
System A ◽  
Paramagnetic Salt ◽  
High And Low Temperatures ◽  
Simple Systems

Even though the general framework of statistical mechanics is ultimately targeted at the description of macroscopic systems, it is illustrative to apply it first to some simple systems: a harmonic oscillator, a rotor, and a spin in a magnetic field. These applications serve to illustrate how a key function associated with the Gibbs state, the so-called partition function, is calculated in practice, how the entropy function is obtained via a Legendre transformation, and how such systems behave in the limits of high and low temperatures. After discussing these simple systems, this chapter considers a first example where multiple constituents are assembled into a macroscopic system: a basic model of a paramagnetic salt. It also investigates the size of energy fluctuations and how—in the case of the paramagnet—these fluctuations scale with the number of constituents.

scholarly journals Catalytic Conversion of n-C7 Asphaltenes and Resins II into Hydrogen Using CeO2-Based Nanocatalysts

Nanomaterials ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 1301
Author(s):  
Oscar E. Medina ◽  
Jaime Gallego ◽  
Sócrates Acevedo ◽  
Masoud Riazi ◽  
Raúl Ocampo-Pérez ◽  
...  
Keyword(s):  
Hydrogen Production ◽  
Low Temperatures ◽  
Gaseous Mixture ◽  
H2 Production ◽  
The Other ◽  
Hydrogen Release ◽  
Catalytic Gasification ◽  
Three Samples ◽  
Main Decomposition ◽  
Catalytic Capacity

This study focuses on evaluating the volumetric hydrogen content in the gaseous mixture released from the steam catalytic gasification of n-C7 asphaltenes and resins II at low temperatures (<230 °C). For this purpose, four nanocatalysts were selected: CeO2, CeO2 functionalized with Ni-Pd, Fe-Pd, and Co-Pd. The catalytic capacity was measured by non-isothermal (from 100 to 600 °C) and isothermal (220 °C) thermogravimetric analyses. The samples show the main decomposition peak between 200 and 230 °C for bi-elemental nanocatalysts and 300 °C for the CeO2 support, leading to reductions up to 50% in comparison with the samples in the absence of nanoparticles. At 220 °C, the conversion of both fractions increases in the order CeO2 < Fe-Pd < Co-Pd < Ni-Pd. Hydrogen release was quantified for the isothermal tests. The hydrogen production agrees with each material’s catalytic activity for decomposing both fractions at the evaluated conditions. CeNi1Pd1 showed the highest performance among the other three samples and led to the highest hydrogen production in the effluent gas with values of ~44 vol%. When the samples were heated at higher temperatures (i.e., 230 °C), H2 production increased up to 55 vol% during catalyzed n-C7 asphaltene and resin conversion, indicating an increase of up to 70% in comparison with the non-catalyzed systems at the same temperature conditions.

scholarly journals Limitation of current probe design for oligo-cross-FISH, exemplified by chromosome evolution studies in duckweeds

Chromosoma ◽  
2021 ◽  
Vol 130 (1) ◽  
pp. 15-25
Author(s):  
Phuong T. N. Hoang ◽  
Jean-Marie Rouillard ◽  
Jiří Macas ◽  
Ivona Kubalová ◽  
Veit Schubert ◽  
...  
Keyword(s):  
Growth Rate ◽  
Chromosome Number ◽  
Chromosome Evolution ◽  
Sequence Similarity ◽  
Flowering Plants ◽  
The Other ◽  
Probe Design ◽  
Congeneric Species ◽  
Specific Design ◽  
Spirodela Polyrhiza

AbstractDuckweeds represent a small, free-floating aquatic family (Lemnaceae) of the monocot order Alismatales with the fastest growth rate among flowering plants. They comprise five genera (Spirodela, Landoltia, Lemna, Wolffiella, and Wolffia) varying in genome size and chromosome number. Spirodela polyrhiza had the first sequenced duckweed genome. Cytogenetic maps are available for both species of the genus Spirodela (S. polyrhiza and S. intermedia). However, elucidation of chromosome homeology and evolutionary chromosome rearrangements by cross-FISH using Spirodela BAC probes to species of other duckweed genera has not been successful so far. We investigated the potential of chromosome-specific oligo-FISH probes to address these topics. We designed oligo-FISH probes specific for one S. intermedia and one S. polyrhiza chromosome (Fig. 1a). Our results show that these oligo-probes cross-hybridize with the homeologous regions of the other congeneric species, but are not suitable to uncover chromosomal homeology across duckweeds genera. This is most likely due to too low sequence similarity between the investigated genera and/or too low probe density on the target genomes. Finally, we suggest genus-specific design of oligo-probes to elucidate chromosome evolution across duckweed genera.

scholarly journals The Consequences of Budding versus Binary Fission on Adaptation and Aging in Primitive Multicellularity

Genes ◽  
2021 ◽  
Vol 12 (5) ◽  
pp. 661
Author(s):  
Hanna Isaksson ◽  
Peter L. Conlin ◽  
Ben Kerr ◽  
William C. Ratcliff ◽  
Eric Libby
Keyword(s):  
Cell Cycle ◽  
Growth Rate ◽  
Cellular Senescence ◽  
Carrying Capacity ◽  
The Other ◽  
Binary Fission ◽  
Fundamental Aspect ◽  
Accumulated Damage ◽  
Cell Age ◽  
Multicellular Organisms

Early multicellular organisms must gain adaptations to outcompete their unicellular ancestors, as well as other multicellular lineages. The tempo and mode of multicellular adaptation is influenced by many factors including the traits of individual cells. We consider how a fundamental aspect of cells, whether they reproduce via binary fission or budding, can affect the rate of adaptation in primitive multicellularity. We use mathematical models to study the spread of beneficial, growth rate mutations in unicellular populations and populations of multicellular filaments reproducing via binary fission or budding. Comparing populations once they reach carrying capacity, we find that the spread of mutations in multicellular budding populations is qualitatively distinct from the other populations and in general slower. Since budding and binary fission distribute age-accumulated damage differently, we consider the effects of cellular senescence. When growth rate decreases with cell age, we find that beneficial mutations can spread significantly faster in a multicellular budding population than its corresponding unicellular population or a population reproducing via binary fission. Our results demonstrate that basic aspects of the cell cycle can give rise to different rates of adaptation in multicellular organisms.

scholarly journals Processes of hypernuclei formation in relativistic ion collisions

2018 ◽  
Vol 171 ◽  
pp. 13001
Author(s):  
Alexander Botvina ◽  
Marcus Bleicher
Keyword(s):  
Experimental Research ◽  
Statistical Models ◽  
Low Temperatures ◽  
Particle Physics ◽  
Broad Distribution ◽  
High Energies ◽  
Intermediate Energies ◽  
Ion Collisions ◽  
High And Low Temperatures

The study of hypernuclei in relativistic ion collisions open new opportunities for nuclear and particle physics. The main processes leading to the production of hypernuclei in these reactions are the disintegration of large excited hyper-residues (target- and projectile-like), and the coalescence of hyperons with other baryons into light clusters. We use the transport, coalescence and statistical models to describe the whole reaction, and demonstrate the effectiveness of this approach: These reactions lead to the abundant production of multi-strange nuclei and new hypernuclear states. A broad distribution of predicted hypernuclei in masses and isospin allows for investigating properties of exotic hypernuclei, as well as the hypermatter both at high and low temperatures. There is a saturation of the hypernuclei production at high energies, therefore, the optimal way to pursue this experimental research is to use the accelerator facilities of intermediate energies, like FAIR (Darmstadt) and NICA (Dubna).

Sign in / Sign up

Export Citation Format

Share Document