Effect of grain size on the vapour phase hydration of monoclinic and triclinic modifications of tricalcium silicate; role of high temperature activation

1991 ◽  
Vol 56 (10) ◽  
pp. 1993-2008
Author(s):  
S. Hanafi ◽  
G. M. S. El-Shafei ◽  
B. Abd El-Hamid
Keyword(s):  
Particle Size ◽  
Vapour Phase ◽  
Tricalcium Silicate ◽  
Active Centers ◽  
Thermally Activated ◽  
Grain Sizes ◽  
Intermediate Size ◽  
Surface Active ◽  
Temperature Activation

The hydration of tricalcium silicate (C3S) with three grain sizes of monoclinic (M) and triclinic (T) modifications and on their thermally activated samples were investigated by exposure to water vapour at 80°C for 60 days. The products were investigated by XRD, TG and N2 adsorption. The smaller the particle size the greater was the hydration for both dried and activated samples from (M). In the activated samples a hydrate with 2θ values of 38.4°, 44.6° and 48.6° could be identified. Hydration increased with particle size for the unactivated (T) samples but after activation the intermediate size exhibited enhanced hydration. Thermal treatment at 950°C of (T) samples increased the surface active centers on the expense of those in the bulk. Changes produced in surface texture upon activation and/or hydration are discussed.

scholarly journals RELATION OF PARTICLE SIZE OF C POLYSACCHARIDE COMPLEXES OF GROUP A STREPTOCOCCI TO TOXIC EFFECTS ON CONNECTIVE TISSUE

1960 ◽  
Vol 112 (5) ◽  
pp. 751-764 ◽  
Author(s):  
Bob S. Roberson ◽  
John H. Schwab ◽  
William J. Cromartie
Keyword(s):  
Particle Size ◽  
Cell Wall ◽  
Connective Tissue ◽  
Large Cell ◽  
Group A Streptococci ◽  
Toxic Activity ◽  
Group A ◽  
Intermediate Size ◽  
The Relationship

The component of Group A streptococci which is responsible for the chronic, remittent, multinodular lesion of connective tissue is derived from the cell wall. Further evidence is given to support the essential role of the group-specific C polysaccharide in the production of this lesion. A series of particles containing the group-specific C polysaccharide was prepared, ranging in size from large cell wall fragments to the relatively small hapten. A comparison of the lesion producing capacity of the particles in this spectrum revealed that maximum toxic activity is associated with C polysaccharide complexes of intermediate size. The discussion considers colloidal properties associated with C polysaccharide complexes of a certain size, and the influence particle size has on persistence in tissue, as possible explanations of the relationship between the size of the C polysaccharide complex and its ability to produce the chronic lesion of connective tissue.

Fibrin Formation: The Role of the Fibrinogen-Fibrin Monomer Complex

1976 ◽  
Vol 36 (01) ◽  
pp. 037-048 ◽  
Author(s):  
Eric P. Brass ◽  
Walter B. Forman ◽  
Robert V. Edwards ◽  
Olgierd Lindan
Keyword(s):  
Particle Size ◽  
Induction Period ◽  
Fibrin Clot ◽  
Clot Formation ◽  
Appreciable Amount ◽  
Buffer System ◽  
Homeostatic Mechanism ◽  
Fibrin Formation ◽  
Fibrin Monomer

SummaryThe process of fibrin formation using highly purified fibrinogen and thrombin was studied using laser fluctuation spectroscopy, a method that rapidly determines particle size in a solution. Two periods in fibrin clot formation were noted: an induction period during which no fibrin polymerization occurred and a period of rapid increase in particle size. Direct measurement of fibrin monomer polymerization and fibrinopeptide release showed no evidence of an induction period. These observations were best explained by a kinetic model for fibrin clot formation incorporating a reversible fibrinogen-fibrin monomer complex. In this model, the complex serves as a buffer system during the earliest phase of fibrin formation. This prevents the accumulation of free polymerizable fibrin monomer until an appreciable amount of fibrinogen has reacted with thrombin, at which point the fibrin monomer level rises rapidly and polymerization proceeds. Clinically, the complex may be a homeostatic mechanism preventing pathological clotting during periods of elevated fibrinogen.

Positive Role of Synthesis Method and Hard Template on the Catalytic Performance of SAPO-34 in Methanol to Olefin Reaction.

2020 ◽  
Vol 23 ◽  
Author(s):  
Sajjad Rimaz ◽  
Reza Katal
Keyword(s):  
Particle Size ◽  
Synthesis Method ◽  
Catalytic Performance ◽  
Hard Template ◽  
Structure Directing Agent ◽  
Positive Role ◽  
Methanol To Olefin ◽  
Dg Method ◽  
Synthesis Procedure

: In the present study, SAPO-34 particles were synthesized using hydrothermal (HT) and dry gel (DG) conversion methods in the presence of diethyl amine (DEA) as an organic structure directing agent (SDA). Carbon nanotubes (CNT) were used as hard template in the synthesis procedure to introduce transport pores into the structures of the synthesized samples. The synthesized samples were characterized with different methods to reveal effects of synthesis method and using hard template on their structure and catalytic performance in methanol to olefin reaction (MTO). DG conversion method results in smaller particle size in comparison with hydrothermal method, resulting in enhancing catalytic performance. On the other side, using CNT in the synthesis procedure with DG method results in more reduction in particle size and formation of hierarchical structure which drastically improves catalytic performance.

Role of the Structure and Electronic Properties of Fe2O3-MoO3 Catalyst on the Dehydration of Isopropyl Alcohol

1993 ◽  
Vol 58 (7) ◽  
pp. 1591-1599 ◽  
Author(s):  
Abd El-Aziz A. Said
Keyword(s):  
Active Sites ◽  
Isopropyl Alcohol ◽  
Oxide Catalyst ◽  
Flow System ◽  
Charge Carriers ◽  
X Ray Diffraction ◽  
X Ray ◽  
Catalyst Composition ◽  
Surface Active

Molybdenum oxide catalyst doped or mixed with (1 - 50) mole % Fe3+ ions were prepared. The structure of the original samples and the samples calcined at 400 °C were characterized using DTA, X-ray diffraction and IR spectra. Measurements of the electrical conductivity of calcined samples with and without isopropyl alcohol revealed that the conductance increases on increasing the content of Fe3+ ions up to 50 mole %. The activation energies of charge carriers were determined in presence and absence of the alcohol. The catalytic dehydration of isopropyl alcohol was carried out at 250 °C using a flow system. The results obtained showed that the doped or mixed catalysts are active and selective towards propene formation. However, the catalyst containing 40 mole % Fe3+ ions exhibited the highest activity and selectivity. Correlations were attempted to the catalyst composition with their electronic and catalytic properties. Probable mechanism for the dehydration process is proposed in terms of surface active sites.

scholarly journals Investigating the Feasibility of Mefenamic Acid Nanosuspension for Pediatric Delivery: Preparation, Characterization, and Role of Excipients

Processes ◽  
2021 ◽  
Vol 9 (4) ◽  
pp. 574
Author(s):  
Nikhat Perween ◽  
Sultan Alshehri ◽  
T. S. Easwari ◽  
Vivek Verma ◽  
Md. Faiyazuddin ◽  
...  
Keyword(s):  
Particle Size ◽  
Mefenamic Acid ◽  
Hydroxypropyl Methylcellulose ◽  
Sodium Dodecyl ◽  
Aqueous Solubility ◽  
Oral Route ◽  
Precipitation Method ◽  
Antisolvent Precipitation

Molecules with poor aqueous solubility are difficult to formulate using conventional approaches and are associated with many formulation delivery issues. To overcome these obstacles, nanosuspension technology can be one of the promising approaches. Hence, in this study, the feasibility of mefenamic acid (MA) oral nanosuspension was investigated for pediatric delivery by studying the role of excipients and optimizing the techniques. Nanosuspensions of MA were prepared by adopting an antisolvent precipitation method, followed by ultrasonication with varying concentrations of polymers, surfactants, and microfluidics. The prepared nanosuspensions were evaluated for particle size, morphology, and rheological measures. Hydroxypropyl methylcellulose (HPMC) with varying concentrations and different stabilizers including Tween® 80 and sodium dodecyl sulfate (SLS) were used to restrain the particle size growth of the developed nanosuspension. The optimized nanosuspension formula was stable for more than 3 weeks and showed a reduced particle size of 510 nm with a polydispersity index of 0.329. It was observed that the type and ratio of polymer stabilizers were responsive on the particle contour and dimension and stability. We have developed a biologically compatible oral nanoformulation for a first-in-class drug beautifully designed for pediatric delivery that will be progressed toward further in vivo enabling studies. Finally, the nanosuspension could be considered a promising carrier for pediatric delivery of MA through the oral route with enhanced biological impact.

Unveiling the role of Mn-interstitial defect and particle size on the Jahn-Teller distortion of the LiMn2O4 cathode material

2021 ◽  
Vol 490 ◽  
pp. 229519
Author(s):  
Renier Arabolla Rodríguez ◽  
Nelcy Della Santina Mohallem ◽  
Manuel Avila Santos ◽  
Demetrio A. Sena Costa ◽  
Luciano Andrey Montoro ◽  
...  
Keyword(s):  
Particle Size ◽  
Cathode Material ◽  
Teller Distortion ◽  
Interstitial Defect ◽  
Jahn Teller ◽  
Limn2o4 Cathode ◽  
Jahn Teller Distortion

scholarly journals The possible role of the Surface Active Substances (SAS) in the airborne transmission of SARS-CoV-2

2021 ◽  
pp. 111215
Author(s):  
Irena Ciglenečki ◽  
Palma Orlović-Leko ◽  
Kristijan Vidović ◽  
Viša Tasić
Keyword(s):  
Airborne Transmission ◽  
Surface Active ◽  
Active Substances
Sign in / Sign up

Export Citation Format

Share Document