scholarly journals Ultraselective glassy polymer membranes with unprecedented performance for energy-efficient sour gas separation

2019 ◽  
Vol 5 (5) ◽  
pp. eaaw5459 ◽  
Author(s):  
Shouliang Yi ◽  
Bader Ghanem ◽  
Yang Liu ◽  
Ingo Pinnau ◽  
William J. Koros

Membrane-based separation of combined acid gases carbon dioxide and hydrogen sulfide from natural gas streams has attracted increasing academic and commercial interest. These feeds are referred to as “sour,” and herein, we report an ultra H2S-selective and exceptionally permeable glassy amidoxime-functionalized polymer of intrinsic microporosity for membrane-based separation. A ternary feed mixture (with 20% H2S:20% CO2:60% CH4) was used to demonstrate that a glassy amidoxime-functionalized membrane provides unprecedented separation performance under challenging feed pressures up to 77 bar. These membranes show extraordinary H2S/CH4 selectivity up to 75 with ultrahigh H2S permeability >4000 Barrers, two to three orders of magnitude higher than commercially available glassy polymeric membranes. We demonstrate that the postsynthesis functionalization of hyper-rigid polymers with appropriate functional polar groups provides a unique design strategy for achieving ultraselective and highly permeable membrane materials for practical natural gas sweetening and additional challenging gas pair separations.

2019 ◽  
Vol 25 (1) ◽  
pp. 77-87 ◽  
Author(s):  
Santos dos ◽  
Lima de ◽  
Lobato de ◽  
Caetano Moraes ◽  
Severo Baptista ◽  
...  

The presence of elemental sulfur (S8) in natural gas streams has caused several problems at the delivery points, one of the most recurrent being the deposit of "yellow powder" in the pilots of pressure control valves. The presence of H2S in the natural gas stream may serve as the source for the S8 and/or increase the solubility thereof in the gas. Studies have shown that adsorption control mechanisms are more attractive for use in pipelines to control S8 deposition. In this study, computational simulations were performed in the software COMSOL Multiphysics, using the computational fluid dynamics (CFD) technique and 13X zeolite as adsorbent. The isotherm models of Langmuir, BET, Freundlich, Toth and Sips were tested in the modeling and simulation and the results obtained showed that the isotherm models presented the following decreasing order of precision in relation to the experimental results: Sips = = Freundlich > Toth > Langmuir > BET. In addition, it was possible to verify that the variation of the coefficient of axial dispersion significantly influences the size of the mass transfer zone.


2015 ◽  
Vol 3 (45) ◽  
pp. 22794-22806 ◽  
Author(s):  
Shouliang Yi ◽  
Xiaohua Ma ◽  
Ingo Pinnau ◽  
William J. Koros

Sorption and permeation properties of a hydroxyl-functionalized polymer with intrinsic microporosity are reported for aggressive sour natural gas separations.


2014 ◽  
Vol 459 ◽  
pp. 264-276 ◽  
Author(s):  
Ondřej Vopička ◽  
Maria Grazia De Angelis ◽  
Naiying Du ◽  
Nanwen Li ◽  
Michael D. Guiver ◽  
...  

Adsorption ◽  
2020 ◽  
Vol 26 (7) ◽  
pp. 1083-1091
Author(s):  
Mi Tian ◽  
Sébastien Rochat ◽  
Hamish Fawcett ◽  
Andrew D. Burrows ◽  
Christopher R. Bowen ◽  
...  

Abstract A detailed investigation has been carried out of the pre-polymerisation modification of the polymer of intrinsic microporosity PIM-1 by the addition of two methyl (Me) groups to its spirobisindane unit to create a new chemically modified PIM-1 analogue, termed MePIM. Our work explores the effects of this modification on the porosity of PIM-1 and hence on its gas sorption properties. MePIM was successfully synthesised using either low (338 K) or high (423 K) temperature syntheses. It was observed that introduction of methyl groups to the spirobisindane part of PIM-1 generates additional microporous spaces, which significantly increases both surface area and hydrogen storage capacity. The BET surface area (N2 at 77 K) was increased by ~ 12.5%, resulting in a ~ 25% increase of hydrogen adsorption after modification. MePIM also maintains the advantages of good processability and thermal stability. This work provides new insights on a facile polymer modification that enables enhanced gas sorption properties.


2015 ◽  
Vol 7 (1) ◽  
pp. 70-78 ◽  
Author(s):  
Sunyhik D. Ahn ◽  
Adam Kolodziej ◽  
Richard Malpass-Evans ◽  
Mariolino Carta ◽  
Neil B. McKeown ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document