scholarly journals Identification of the Rayleigh surface waves for estimation of viscoelasticity using the surface wave elastography technique

2016 ◽  
Vol 140 (5) ◽  
pp. 3619-3622 ◽  
Author(s):  
Xiaoming Zhang
Keyword(s):  
Surface Wave ◽  
Surface Waves ◽  
Rayleigh Surface Waves

Effect of magnetic field and voids on Rayleigh waves in a nonlocal thermoelastic half-space

2021 ◽  
pp. 030932472110012
Author(s):  
AM Abd-Alla ◽  
SM Abo-Dahab ◽  
SM Ahmed ◽  
MM Rashid
Keyword(s):  
Magnetic Field ◽  
Surface Wave ◽  
Surface Waves ◽  
Wave Speed ◽  
Nonlocal Parameter ◽  
Mode Analysis ◽  
Rayleigh Surface Wave ◽  
Coupled Equations ◽  
Rayleigh Surface Waves ◽  
Dimensional Wave

This work is concerned with the propagation of surface waves is considered in an isotropic elastic homogeneous nonlocal generalized thermoelastic solid medium in the presence of a magnetic field and voids. The normal mode analysis and Lame’s potential theory are used to solve the resulting non-dimensional coupled equations. Dispersion relation for Rayleigh surface wave are derived for both thermally insulated and isothermal surfaces. The non-dimensional wave speed of Rayleigh surface wave is computed for a specific material. The non-dimensional wave speed of Rayleigh surface waves are found to be influenced by the presence of voids, magnetic field, thermal field, and elastic nonlocal parameter. For a particular model, the effect of magnetic field, void parameters, thermal parameter, and nonlocality has been studied numerically on the Rayleigh surface waves. All the computed results obtained have been depicted graphically and explained.

Guided Surface Waves on an Elastic Half Space

1971 ◽  
Vol 38 (4) ◽  
pp. 899-905 ◽  
Author(s):  
L. B. Freund
Keyword(s):  
Wave Propagation ◽  
Surface Wave ◽  
Surface Waves ◽  
Half Space ◽  
Body Wave ◽  
Three Dimensional ◽  
Elastic Half Space ◽  
Normal Displacement ◽  
Rigid Barrier ◽  
Wave Disturbances

Three-dimensional wave propagation in an elastic half space is considered. The half space is traction free on half its boundary, while the remaining part of the boundary is free of shear traction and is constrained against normal displacement by a smooth, rigid barrier. A time-harmonic surface wave, traveling on the traction free part of the surface, is obliquely incident on the edge of the barrier. The amplitude and the phase of the resulting reflected surface wave are determined by means of Laplace transform methods and the Wiener-Hopf technique. Wave propagation in an elastic half space in contact with two rigid, smooth barriers is then considered. The barriers are arranged so that a strip on the surface of uniform width is traction free, which forms a wave guide for surface waves. Results of the surface wave reflection problem are then used to geometrically construct dispersion relations for the propagation of unattenuated guided surface waves in the guiding structure. The rate of decay of body wave disturbances, localized near the edges of the guide, is discussed.

Assessment of material damage in a nickel-base superalloy using nonlinear Rayleigh surface waves

2006 ◽  
Vol 99 (12) ◽  
pp. 124913 ◽  
Author(s):  
Jan Herrmann ◽  
Jin-Yeon Kim ◽  
Laurence J. Jacobs ◽  
Jianmin Qu ◽  
Jerrol W. Littles ◽  
...  
Keyword(s):  
Surface Waves ◽  
Nickel Base Superalloy ◽  
Material Damage ◽  
Rayleigh Surface Waves ◽  
Nickel Base ◽  
Base Superalloy

Surface wave attenuation of seismic records with the co-core trace transform filter

Geophysics ◽  
2011 ◽  
Vol 76 (6) ◽  
pp. V115-V128 ◽  
Author(s):  
Ning Wu ◽  
Yue Li ◽  
Baojun Yang
Keyword(s):  
Surface Wave ◽  
Surface Waves ◽  
Field Data ◽  
Wave Attenuation ◽  
Seismic Events ◽  
Data Sets ◽  
Transform Domain ◽  
Recent Developments ◽  
Seismic Records ◽  
Trace Transform

To remove surface waves from seismic records while preserving other seismic events of interest, we introduced a transform and a filter based on recent developments in image processing. The transform can be seen as a weighted Radon transform, in particular along linear trajectories. The weights in the transform are data dependent and designed to introduce large amplitude differences between surface waves and other events such that surface waves could be separated by a simple amplitude threshold. This is a key property of the filter and distinguishes this approach from others, such as conventional ones that use information on moveout ranges to apply a mask in the transform domain. Initial experiments with synthetic records and field data have demonstrated that, with the appropriate parameters, the proposed trace transform filter performs better both in terms of surface wave attenuation and reflected signal preservation than the conventional methods. Further experiments on larger data sets are needed to fully assess the method.

Estimates of Surface Waves Using Subsurface EM-APEX Floats under Typhoon Fanapi 2010

2018 ◽  
Vol 35 (5) ◽  
pp. 1053-1075 ◽  
Author(s):  
Je-Yuan Hsu ◽  
Ren-Chieh Lien ◽  
Eric A. D’Asaro ◽  
Thomas B. Sanford
Keyword(s):  
Surface Wave ◽  
Surface Waves ◽  
Wave Spectrum ◽  
Nonlinear Least Squares ◽  
Peak Frequency ◽  
Wave Propagation Direction ◽  
Model Studies ◽  
Surface Wave Propagation ◽  
Left Quadrant ◽  
Field Inclination

AbstractSeven subsurface Electromagnetic Autonomous Profiling Explorer (EM-APEX) floats measured the voltage induced by the motional induction of seawater under Typhoon Fanapi in 2010. Measurements were processed to estimate high-frequency oceanic velocity variance associated with surface waves. Surface wave peak frequency fp and significant wave height Hs are estimated by a nonlinear least squares fitting to , assuming a broadband JONSWAP surface wave spectrum. The Hs is further corrected for the effects of float rotation, Earth’s geomagnetic field inclination, and surface wave propagation direction. The fp is 0.08–0.10 Hz, with the maximum fp of 0.10 Hz in the rear-left quadrant of Fanapi, which is ~0.02 Hz higher than in the rear-right quadrant. The Hs is 6–12 m, with the maximum in the rear sector of Fanapi. Comparing the estimated fp and Hs with those assuming a single dominant surface wave yields differences of more than 0.02 Hz and 4 m, respectively. The surface waves under Fanapi simulated in the WAVEWATCH III (ww3) model are used to assess and compare to float estimates. Differences in the surface wave spectra of JONSWAP and ww3 yield uncertainties of <5% outside Fanapi’s eyewall and >10% within the eyewall. The estimated fp is 10% less than the simulated before the passage of Fanapi’s eye and 20% less after eye passage. Most differences between Hs and simulated are <2 m except those in the rear-left quadrant of Fanapi, which are ~5 m. Surface wave estimates are important for guiding future model studies of tropical cyclone wave–ocean interactions.

Azimuthal multiple signal classification of dispersive and aliased surface waves recorded in 3D seismic acquisition

Geophysics ◽  
2021 ◽  
pp. 1-84
Author(s):  
Chunying Yang ◽  
Wenchuang Wang
Keyword(s):  
Surface Wave ◽  
Surface Waves ◽  
Body Waves ◽  
Signal Classification ◽  
Dispersion Pattern ◽  
Velocity Spectrum ◽  
Low Velocity ◽  
Surface Wave Dispersion ◽  
Multiple Signal Classification ◽  
Multiple Signal

Irregular acquisition geometry causes discontinuities in the appearance of surface wave events, and a large offset causes seismic records to appear as aliased surface waves. The conventional method of sampling data affects the accuracy of the dispersion spectrum and reduces the resolution of surface waves. At the same time, ”mode kissing” of the low-velocity layer and inhomogeneous scatterers requires a high-resolution method for calculating surface wave dispersion. This study tested the use of the multiple signal classification (MUSIC) algorithm in 3D multichannel and aliased wavefield separation. Azimuthal MUSIC is a useful method to estimate the phase velocity spectrum of aliased surface wave data, and it represent the dispersion spectra of low-velocity and inhomogeneous models. The results of this study demonstrate that mode-kissing affects dispersion imaging, and inhomogeneous scatterers change the direction of surface-wave propagation. Surface waves generated from the new propagation directions are also dispersive. The scattered surface wave has a new dispersion pattern different to that of the entire record. Diagonal loading was introduced to improve the robustness of azimuthal MUSIC, and numerical experiments demonstrate the resultant effectiveness of imaging aliasing surface waves. A phase-matched filter was applied to the results of azimuthal MUSIC, and phase iterations were unwrapped in a fast and stable manner. Aliased surface waves and body waves were separated during this process. Overall, field data demonstrate that azimuthal MUSIC and phase-matched filters can successfully separate aliased surface waves.

Errors Introduced in Estimation of Surface Wave Phase and Group Velocities Due to Wrong Assumptions: An Assessment Using a Simple Model For Love Wave

2021 ◽  
Author(s):  
Akash Kharita ◽  
Sagarika Mukhopadhyay
Keyword(s):  
Surface Wave ◽  
Surface Waves ◽  
Love Wave ◽  
Arrival Time ◽  
Epicentral Distance ◽  
Horizontal Distance ◽  
Wave Analysis ◽  
Time Period ◽  
Phase And Group Velocities ◽  
Group Velocities

&lt;p&gt;The surface wave phase and group velocities are estimated by dividing the epicentral distance by phase and group travel times respectively in all the available methods, this is based on the assumptions that (1) surface waves originate at the epicentre and (2) the travel time of the particular group or phase of the surface wave is equal to its arrival time to the station minus the origin time of the causative earthquake; However, both assumptions are wrong since surface waves generate at some horizontal distance away from the epicentre. We calculated the actual horizontal distance from the focus at which they generate and assessed the errors caused in the estimation of group and phase velocities by the aforementioned assumptions in a simple isotropic single layered homogeneous half space crustal model using the example of the fundamental mode Love wave. We took the receiver locations in the epicentral distance range of 100-1000 km, as used in the regional surface wave analysis, varied the source depth from 0 to 35 Km with a step size of 5 km and did the forward modelling to calculate the arrival time of Love wave phases at each receiver location. The phase and group velocities are then estimated using the above assumptions and are compared with the actual values of the velocities given by Love wave dispersion equation. We observed that the velocities are underestimated and the errors are found to be; decreasing linearly with focal depth, decreasing inversely with the epicentral distance and increasing parabolically with the time period. We also derived empirical formulas using MATLAB curve fitting toolbox that will give percentage errors for any realistic combination of epicentral distance, time period and depths of earthquake and thickness of layer in this model. The errors are found to be more than 5% for all epicentral distances lesser than 500 km, for all focal depths and time periods indicating that it is not safe to do regional surface wave analysis for epicentral distances lesser than 500 km without incurring significant errors. To the best of our knowledge, the study is first of its kind in assessing such errors.&lt;/p&gt;

scholarly journals Rayleigh surface waves propagating in (111) Si substrate decorated with Ni phononic nanostructure

2012 ◽  
Author(s):  
B. Graczykowski ◽  
S. Mielcarek ◽  
A. Trzaskowska ◽  
P. Patoka ◽  
M. Giersig
Keyword(s):  
Surface Waves ◽  
Si Substrate ◽  
Rayleigh Surface Waves
Sign in / Sign up

Export Citation Format

Share Document