Modeling transmission loss over stratified muddy sediments based on chirp sonar imagery

2015 ◽  
Vol 137 (4) ◽  
pp. 2282-2282
Author(s):  
Dajun Tang ◽  
Brian T. Hefner ◽  
Jie Yang ◽  
Darrell R. Jackson
Keyword(s):  
Transmission Loss ◽  
Muddy Sediments ◽  
Chirp Sonar

Effect of leakage and blockage on the acoustic behavior of particle filters

2019 ◽  
Vol 67 (6) ◽  
pp. 483-492
Author(s):  
Seonghyeon Baek ◽  
Iljae Lee
Keyword(s):  
Transfer Matrix ◽  
Particle Filters ◽  
Acoustic Analysis ◽  
Transmission Loss ◽  
One Dimensional ◽  
Filter System ◽  
The Difference ◽  
The One ◽  
Analytical Approaches ◽  
Good Agreement

The effects of leakage and blockage on the acoustic performance of particle filters have been examined by using one-dimensional acoustic analysis and experimental methods. First, the transfer matrix of a filter system connected to inlet and outlet pipes with conical sections is measured using a two-load method. Then, the transfer matrix of a particle filter only is extracted from the experiments by applying inverse matrices of the conical sections. In the analytical approaches, the one-dimensional acoustic model for the leakage between the filter and the housing is developed. The predicted transmission loss shows a good agreement with the experimental results. Compared to the baseline, the leakage between the filter and housing increases transmission loss at a certain frequency and its harmonics. In addition, the transmission loss for the system with a partially blocked filter is measured. The blockage of the filter also increases the transmission loss at higher frequencies. For the simplicity of experiments to identify the leakage and blockage, the reflection coefficients at the inlet of the filter system have been measured using two different downstream conditions: open pipe and highly absorptive terminations. The experiments show that with highly absorptive terminations, it is easier to see the difference between the baseline and the defects.

scholarly journals Exploring a New Adaptive Routing Based on the Dijkstra Algorithm in Optical Networks-on-Chip

Micromachines ◽  
2021 ◽  
Vol 12 (1) ◽  
pp. 54
Author(s):  
Yan-Li Zheng ◽  
Ting-Ting Song ◽  
Jun-Xiong Chai ◽  
Xiao-Ping Yang ◽  
Meng-Meng Yu ◽  
...  
Keyword(s):  
Power Consumption ◽  
Power Control ◽  
Optical Networks ◽  
Output Power ◽  
Network Performance ◽  
Transmission Loss ◽  
Adaptive Routing ◽  
Dijkstra Algorithm ◽  
Networks On Chip ◽  
On Chip

The photoelectric hybrid network has been proposed to achieve the ultrahigh bandwidth, lower delay, and less power consumption for chip multiprocessor (CMP) systems. However, a large number of optical elements used in optical networks-on-chip (ONoCs) generate high transmission loss which will influence network performance severely and increase power consumption. In this paper, the Dijkstra algorithm is adopted to realize adaptive routing with minimum transmission loss of link and reduce the output power of the link transmitter in mesh-based ONoCs. The numerical simulation results demonstrate that the transmission loss of a link in optimized power control based on the Dijkstra algorithm could be maximally reduced compared with traditional power control based on the dimensional routing algorithm. Additionally, it has a greater advantage in saving the average output power of optical transmitter compared to the adaptive power control in previous studies, while the network size expands. With the aid of simulation software OPNET, the network performance simulations in an optimized network revealed that the end-to-end (ETE) latency and throughput are not vastly reduced in regard to a traditional network. Hence, the optimized power control proposed in this paper can greatly reduce the power consumption of s network without having a big impact on network performance.

Sign in / Sign up

Export Citation Format

Share Document