Numerical analysis and active control of wake/blade‐row interaction noise

1999 ◽  
Vol 105 (2) ◽  
pp. 1140-1140
Author(s):  
C. J. Hwang ◽  
J. Y. Kuo
Keyword(s):  
Numerical Analysis ◽  
Active Control ◽  
Blade Row ◽  
Blade Row Interaction

Active control of wake/blade-row interaction noise

AIAA Journal ◽  
1994 ◽  
Vol 32 (10) ◽  
pp. 1953-1960 ◽  
Author(s):  
Kenneth A. Kousen ◽  
Joseph M. Verdon
Keyword(s):  
Active Control ◽  
Blade Row ◽  
Blade Row Interaction

Dipole Active Control of Wake-Blade Row Interaction Noise

1999 ◽  
Vol 15 (1) ◽  
pp. 31-37 ◽  
Author(s):  
Stacey Myers ◽  
Sanford Fleeter
Keyword(s):  
Active Control ◽  
Blade Row ◽  
Blade Row Interaction

scholarly journals Navier-Stokes and Potential Calculations of Axial Spacing Effect on Vortical and Potential Disturbances and Gust Response in an Axial Compressor

1995 ◽  
Author(s):  
Meng-Hsuan Chung ◽  
Andrew M. Wo
Keyword(s):  
Lower Order ◽  
Spacing Effect ◽  
Axial Compressor ◽  
Interaction Effects ◽  
Moving Frame ◽  
Navier Stokes ◽  
Blade Row ◽  
Vortical Disturbance ◽  
Blade Row Interaction ◽  
Gust Response

The effect of blade row axial spacing on vortical and potential disturbances and gust response is studied for a compressor stator/rotor configuration near design and at high loadings using 2D incompressible Navier-Stokes and potential codes, both written for multistage calculations. First, vortical and potential disturbances downstream of the isolated stator in the moving frame are defined; these disturbances exclude blade row interaction effects. Then, vortical and potential disturbances for the stator/rotor configuration are calculated for axial gaps of 10%, 20%, and 30% chord. Results show that the potential disturbance is uncoupled; the potential disturbance calculated from the isolated stator configuration is a good approximation for that from the stator/rotor configuration for all three axial gaps. The vortical disturbance depends strongly on blade row interactions. Low order modes of vortical disturbance are of substantial magnitude and decay much more slowly downstream than do those of potential disturbance. Vortical disturbance decays linearly with increasing mode except very close to the stator trailing edge. For a small axial gap, lower order modes of both vortical and potential disturbances must be included to determine the rotor gust response.

Effects of Off-Design Operating Conditions on the Blade Row Interaction in a HP Turbine Stage

2007 ◽  
Author(s):  
G. Persico ◽  
P. Gaetani ◽  
C. Osnaghi
Keyword(s):  
Flow Field ◽  
Strong Dependence ◽  
Secondary Flows ◽  
Operating Conditions ◽  
Pressure Probe ◽  
Turbine Stage ◽  
Mixing Rate ◽  
Aerodynamic Pressure ◽  
Blade Row ◽  
Blade Row Interaction

An extensive experimental analysis on the subject of the unsteady periodic flow in a highly subsonic HP turbine stage has been carried out at the Laboratorio di Fluidodinamica delle Macchine (LFM) of the Politecnico di Milano (Italy). In this paper the blade row interaction is progressively enforced by increasing the stator and rotor blade loading and by reducing the stator-rotor axial gap from 100% (very large to smooth the rotor inlet unsteadiness) to 35% (design configuration) of the stator axial chord. The time-averaged three-dimensional flow field in the stator-rotor gap was investigated by means of a conventional five-hole probe for the nominal (0°) and an highly positive (+22°) stator incidences. The evolution of the viscous flow structures downstream of the stator is presented to characterize the rotor incoming flow. The blade row interaction was evaluated on the basis of unsteady aerodynamic measurements at the rotor exit, performed with a fast-response aerodynamic pressure probe. Results show a strong dependence of the time-averaged and phase-resolved flow field and of the stage performance on the stator incidence. The structure of the vortex-blade interaction changes significantly as the magnitude of the rotor inlet vortices increases, and very different residual traces of the stator secondary flows are found downstream of the rotor. On the contrary, the increase of rotor loading enhances the unsteadiness in the rotor secondary flows but has a little effect on the vortex-vortex interaction. For the large axial gap, a reduction of stator-related effects at the rotor exit is encountered when the stator incidence is increased as a result of the different mixing rate within the cascade gap.

Sign in / Sign up

Export Citation Format

Share Document