scholarly journals Probability Density Function of the Time Average of Sound Pressure Level Measurements in a Reverberant Room Excited by Random Noise

1973 ◽  
Vol 53 (1) ◽  
pp. 302-302 ◽  
Author(s):  
Douglas J. Ingalls
Keyword(s):  
Probability Density Function ◽  
Probability Density ◽  
Density Function ◽  
Sound Pressure Level ◽  
Sound Pressure ◽  
Random Noise ◽  
Pressure Level ◽  
Time Average

scholarly journals Pengujian Alat Pemanen Energi Akustik Berbasis Loudspeaker Dengan Sumber Kebisingan Acak Dari Mesin Kendaraan Bermotor

2019 ◽  
Vol 4 ◽  
pp. 152
Author(s):  
Untung Adi Santosa ◽  
Ikhsan Setiawan ◽  
B.S. Utomo
Keyword(s):  
Sound Pressure Level ◽  
Sound Pressure ◽  
Random Noise ◽  
Electrical Power ◽  
Dominant Frequency ◽  
Pressure Level ◽  
Acoustic Energy ◽  
Noise Sources ◽  
Quarter Wavelength ◽  
The Impact

<p class="AbstractEnglish"><strong>Abstract: </strong>This paper reports the test results of a loudspeaker-based acoustic energy harvester with acoustic random noise sources from a motorcycle. The harvester consists of a quarter wavelength resonator and a subwoofer type loudspeaker with a nominal diameter of 6 inches. The motorcycle used in this experiment is 135 cc Bajaj Pulsar motorsport with modified exhaust from the GBS-Motosport Jakarta. The motor engine is operated at 3000 rpm, resulting in noise with a fluctuating Sound Pressure Level (SPL) in the range of (90-93) dB. Six variations of resonator lengths are used, those are 21 cm, 31 cm, 58 cm, 85 cm, 112 cm, and 139 cm. In this test, data of dominant frequency, SPL, and output rms voltage were taken for 15 minutes. The rms voltage is measured at 100 Ω load resistor. The results show that the 112 cm resonator produces the highest average rms electrical power, that is (0.21 ± 0.01) mW, which is obtained at frequency that fluctuates within (95-120) Hz. In addition, with random sound sources, SPL and its dominant frequency fluctuate greatly, so it will greatly affect the generated electric power. Further research is needed to enhance the output electrical power and anticipate the impact of frequency fluctuation which exists in random noise sources.</p><p class="AbstractEnglish"><strong>Abstrak: </strong>Paper ini memaparkan hasil pengujian alat pemanen energi akustik berbasis <em>loudspeaker </em>dengan sumber kebisingan acak dari mesin kendaraan bermotor. Alat pemanen energi akustik ini terdiri dari resonator seperempat panjang gelombang dan <em>loudspeaker</em> jenis <em>subwoofer</em> dengan diameter nominal 6 inci. Sumber kebisingan yang digunakan adalah motor Bajaj Pulsar 135 cc dengan knalpot modifikasi dari GBS-Motosport Jakarta. Mesin motor dioperasikan pada laju putaran tetap 3000 rpm, sehingga menghasilkan kebisingan dengan <em>SPL</em> (<em>sound pressure level</em>) yang berfluktuasi dalam interval (90-93) dB. Digunakan enam variasi panjang resonator, yaitu 21 cm, 31 cm, 58 cm, 85 cm, 112 cm, dan 139 cm. Dalam pengujian ini, data frekuensi dominan kebisingan, <em>SPL</em> kebisingan, dan tegangan keluaran alat pemanen energi akustik diambil selama 15 menit. Tegangan <em>rms</em> keluaran diukur pada resistor beban 100 Ω. Hasil eksperimen menunjukkan bahwa resonator dengan panjang 112 cm menghasilkan daya listrik <em>rms</em> rata-rata tertinggi yaitu sebesar (0,21 ± 0,01) mW, diperoleh pada frekuensi yang berfluktuasi antara 95 Hz sampai 120 Hz. Selain itu, hasil eksperimen ini menunjukkan bahwa dengan sumber bunyi acak, <em>SPL</em> kebisingan dan frekuensi dominannya sangat berfluktuasi, sehingga akan sangat berpengaruh terhadap daya listrik yang dihasilkan. Penelitian lebih lanjut diperlukan untuk meningkatkan daya listrik keluaran dan mengantisipasi dampak fluktuasi frekuensi sumber kebisingan acak.</p>

scholarly journals A computable evolution equation for the joint response-excitation probability density function of stochastic dynamical systems

2011 ◽  
Vol 468 (2139) ◽  
pp. 759-783 ◽  
Author(s):  
D. Venturi ◽  
T. P. Sapsis ◽  
H. Cho ◽  
G. E. Karniadakis
Keyword(s):  
Probability Density Function ◽  
Evolution Equation ◽  
Probability Density ◽  
Density Function ◽  
Random Noise ◽  
Functional Integral ◽  
Excitation Density ◽  
Numerical Verification ◽  
Markovian Systems ◽  
Excitation Probability

By using functional integral methods, we determine a computable evolution equation for the joint response-excitation probability density function of a stochastic dynamical system driven by coloured noise. This equation can be represented in terms of a superimposition of differential constraints, i.e. partial differential equations involving unusual limit partial derivatives, the first one of which was originally proposed by Sapsis & Athanassoulis. A connection with the classical response approach is established in the general case of random noise with arbitrary correlation time, yielding a fully consistent new theory for non-Markovian systems. We also address the question of computability of the joint response-excitation probability density function as a solution to a boundary value problem involving only one differential constraint. By means of a simple analytical example, it is shown that, in general, such a problem is undetermined, in the sense that it admits an infinite number of solutions. This issue can be overcome by completing the system with additional relations yielding a closure problem, which is similar to the one arising in the standard response theory. Numerical verification of the equations for the joint response-excitation density is obtained for a tumour cell growth model under immune response.

Contributions of Voice and Nonverbal Communication to Perceived Masculinity–Femininity for Cisgender and Transgender Communicators

2020 ◽  
Vol 63 (4) ◽  
pp. 931-947
Author(s):  
Teresa L. D. Hardy ◽  
Carol A. Boliek ◽  
Daniel Aalto ◽  
Justin Lewicke ◽  
Kristopher Wells ◽  
...  
Keyword(s):  
Fundamental Frequency ◽  
Sound Pressure Level ◽  
Sound Pressure ◽  
Vocal Tract ◽  
Presentation Mode ◽  
Pressure Level ◽  
Presentation Modes ◽  
Audiovisual Stimuli ◽  
Vocal Tract Resonance ◽  
Point Light

Purpose The purpose of this study was twofold: (a) to identify a set of communication-based predictors (including both acoustic and gestural variables) of masculinity–femininity ratings and (b) to explore differences in ratings between audio and audiovisual presentation modes for transgender and cisgender communicators. Method The voices and gestures of a group of cisgender men and women ( n = 10 of each) and transgender women ( n = 20) communicators were recorded while they recounted the story of a cartoon using acoustic and motion capture recording systems. A total of 17 acoustic and gestural variables were measured from these recordings. A group of observers ( n = 20) rated each communicator's masculinity–femininity based on 30- to 45-s samples of the cartoon description presented in three modes: audio, visual, and audio visual. Visual and audiovisual stimuli contained point light displays standardized for size. Ratings were made using a direct magnitude estimation scale without modulus. Communication-based predictors of masculinity–femininity ratings were identified using multiple regression, and analysis of variance was used to determine the effect of presentation mode on perceptual ratings. Results Fundamental frequency, average vowel formant, and sound pressure level were identified as significant predictors of masculinity–femininity ratings for these communicators. Communicators were rated significantly more feminine in the audio than the audiovisual mode and unreliably in the visual-only mode. Conclusions Both study purposes were met. Results support continued emphasis on fundamental frequency and vocal tract resonance in voice and communication modification training with transgender individuals and provide evidence for the potential benefit of modifying sound pressure level, especially when a masculine presentation is desired.

Sign in / Sign up

Export Citation Format

Share Document