KI stress intensity factor of cracks with a hard inclusion by finite element method and reflection photoelasticity technique

2009 ◽  
Author(s):  
Wiroj Limtrakarn ◽  
Anocha Namlaow
Keyword(s):  
Finite Element Method ◽  
Stress Intensity Factor ◽  
Finite Element ◽  
Stress Intensity ◽  
Intensity Factor ◽  
Hard Inclusion ◽  
Element Method

Application of Extended Finite Element Method (XFEM) to Stress Intensity Factor Calculations

2015 ◽  
Author(s):  
Do-Jun Shim ◽  
Mohammed Uddin ◽  
Sureshkumar Kalyanam ◽  
Frederick Brust ◽  
Bruce Young
Keyword(s):  
Finite Element Method ◽  
Stress Intensity Factor ◽  
Finite Element ◽  
Stress Intensity ◽  
Intensity Factor ◽  
Degrees Of Freedom ◽  
Extended Finite Element Method ◽  
Partition Of Unity ◽  
Extended Finite Element ◽  
Element Method

The extended finite element method (XFEM) is an extension of the conventional finite element method based on the concept of partition of unity. In this method, the presence of a crack is ensured by the special enriched functions in conjunction with additional degrees of freedom. This approach also removes the requirement for explicitly defining the crack front or specifying the virtual crack extension direction when evaluating the contour integral. In this paper, stress intensity factors (SIF) for various crack types in plates and pipes were calculated using the XFEM embedded in ABAQUS. These results were compared against handbook solutions, results from conventional finite element method, and results obtained from finite element alternating method (FEAM). Based on these results, applicability of the ABAQUS XFEM to stress intensity factor calculations was investigated. Discussions are provided on the advantages and limitations of the XFEM.

scholarly journals ANALYSIS OF CRACKS AT THE TORSION VALLARS CAUSED WITHOUT LOADING

2021 ◽  
Vol 07 (03) ◽  
pp. 72-79
Author(s):  
Tehran Mammadli Tehran Mammadli
Keyword(s):  
Finite Element Method ◽  
Fracture Toughness ◽  
Stress Intensity Factor ◽  
Finite Element ◽  
Stress Intensity ◽  
Intensity Factor ◽  
Fracture Criterion ◽  
Fatigue Cracks ◽  
Tracked Vehicles ◽  
Element Method

Nowadays, the hull suspension systems that use torsion shafts as elastic suspension elements are fitted to the majority of modern tracked vehicles. The main type of failure in such systems is the fracture of the torsion shafts due to the formation of fatigue cracks, which leads to failure of the suspension assemblies. This work presents an analysis of fracture toughness of torsion shafts of a standard tracked chassis used to develop a family of multipurpose transport vehicles GT-TM, GT-TMS, etc. The analysis is carried out under an operating load level for a crack located on the cylindrical part of the torsion shaft, the plane of which is at an angle to the torsion shaft axis and coincides with the position of the main areas of the stress state. The calculation of fracture toughness is based on Irwin fracture criterion. The calculations of the maximum stress intensity factor along the crack front are performed using the finite element method in the ANSYS software package. The results of the analysis of fracture toughness are presented in the form of dependences of the critical depth of the crack on the ratio of the fracture half-length to its depth. The data obtained can be used to determine the residual life of torsion shafts of the tracked vehicles based on the chassis under consideration. Keywords: suspension system, fracture toughness of torsion shafts, edge crack, stress intensity factor, finite element method, Irwin fracture criterion.

Sign in / Sign up

Export Citation Format

Share Document