The performance test results for engineering model (EM) of thermal and near infrared sensor for carbon observation (TANSO) on GOSAT

2007 ◽  
Author(s):  
Hiroshi Suto ◽  
Takahiro Kawashima ◽  
Kei Shiomi ◽  
Tomoko Kina ◽  
Akihiko Kuze ◽  
...  
2006 ◽  
Author(s):  
Akihiko Kuze ◽  
Tomoyuki Urabe ◽  
Hiroshi Suto ◽  
Yutaka Kaneko ◽  
Takashi Hamazaki

2008 ◽  
Author(s):  
Hiroshi Suto ◽  
Takahiro Kawashima ◽  
Jun Yoshida ◽  
Juro Ishida ◽  
Akihiko Kuze ◽  
...  

Author(s):  
Wirda Linda

This research is motivated by the low desire of students in writing travel reports. The lack of students' knowledge of the report concept, the lack of students' knowledge of the 5W + 1H report points of good and correct language, the lack of students' knowledge of the spatial, time and topic pattern and not yet reached KKM 75. The method used by the teacher has not been interesting, lecture method. The purpose of this study is to describe the skills of writing travel reports by using Round Club learning model which is viewed from the aspect of understanding the report concept, the use of 5W +1H report points, the spatial, time, and topic pattern.The population of this study is the students of class V Lessons Year 2017/2018 which amounted to 2 classes with the number 80. The sample of research as much as two classes taken by the sample of propotional.Class V.1 as experimental class and class V.2 as control class. The research instrument used is performance test. Provide an assessment by specifying the subject of the 5W + 1H report, as well as the spatial, time and topic pattern. Data were analyzed by 't' test by first testing normality, homogeneity, and hypothesis testing.The results showed that the average control class 68 with more than enough qualifications with standard deviation 16.96. 83 experimental class with good qualification and standard deviation of 15.42 and there is a significant influence on the result of writing skill of class V SDN 01 Nagari Bukik SikumpaSubdistrict, Lima Puluh Kota. This is evidenced by the average value of writing skills in the experiment class higher than the average value in the control class. Normality test results indicate that the two sample classes of  Lo  values in the control class -0.2141 are smaller than the normal 0.190 Lt distributed. Homogeneity test results that the variation of this study is homogeneous at a real level of 0.05, because Ftable 2.16 > Fhitung 1.21 and the results of data analysis then obtained = 2.78 > 1.70 t table, so H0 rejected and H1 accepted. It can be concluded that there is Influence. Using  Learning  Model of Student Group Writing  Skills Travel Report of students of class V SDN 01 Nagari Bukik Sikumpa Subdistrict, Kabupaten Lima Puluh Kota.KeyWords: model pembelajaran round club, menulis laporan perjalanan.


2021 ◽  
pp. 1-8
Author(s):  
Junta Iguchi ◽  
Minoru Matsunami ◽  
Tatsuya Hojo ◽  
Yoshihiko Fujisawa ◽  
Kenji Kuzuhara ◽  
...  

BACKGROUND: Few studies have investigated the variations in body composition and performance in Japanese collegiate American-football players. OBJECTIVE: To clarify what characterizes competitors at the highest levels – in the top division or on the starting lineup – we compared players’ body compositions and performance test results. METHODS: This study included 172 players. Each player’s body composition and performance (one-repetition maximum bench press, one-repetition maximum back squat, and vertical jump height) were measured; power was estimated from vertical jump height and body weight. Players were compared according to status (starter vs. non-starter), position (skill vs. linemen), and division (1 vs. 2). Regression analysis was performed to determine characteristics for being a starter. RESULTS: Players in higher divisions and who were starters were stronger and had more power, greater body size, and better performance test results. Players in skill positions were relatively stronger than those in linemen positions. Vertical jump height was a significant predictor of being a starter in Division 1. CONCLUSION: Power and vertical jump may be a deciding factor for playing as a starter or in a higher division.


2009 ◽  
Vol 103 (1) ◽  
pp. 144-152 ◽  
Author(s):  
A.M. Mouazen ◽  
M.R. Maleki ◽  
L. Cockx ◽  
M. Van Meirvenne ◽  
L.H.J. Van Holm ◽  
...  

2016 ◽  
Vol 9 (6) ◽  
pp. 2445-2461 ◽  
Author(s):  
Akihiko Kuze ◽  
Hiroshi Suto ◽  
Kei Shiomi ◽  
Shuji Kawakami ◽  
Makoto Tanaka ◽  
...  

Abstract. A data set containing more than 6 years (February 2009 to present) of radiance spectra for carbon dioxide (CO2) and methane (CH4) observations has been acquired by the Greenhouse gases Observing SATellite (GOSAT, available at http://data.gosat.nies.go.jp/GosatUserInterfaceGateway/guig/GuigPage/open.do), nicknamed “Ibuki”, Thermal And Near infrared Sensor for carbon Observation Fourier Transform Spectrometer (TANSO-FTS). This paper provides updates on the performance of the satellite and TANSO-FTS sensor and describes important changes to the data product, which has recently been made available to users. With these changes the typical accuracy of retrieved column-averaged dry air mole fractions of CO2 and CH4 (XCO2 and XCH4, respectively) are 2 ppm or 0.5 % and 13 ppb or 0.7 %, respectively. Three major anomalies of the satellite system affecting TANSO-FTS are reported: a failure of one of the two solar paddles in May 2014, a switch to the secondary pointing system in January 2015, and most recently a cryocooler shutdown and restart in August 2015. The Level 1A (L1A) (raw interferogram) and the Level 1B (L1B) (radiance spectra) of version V201 described here have long-term uniform quality and provide consistent retrieval accuracy even after the satellite system anomalies. In addition, we discuss the unique observation abilities of GOSAT made possible by an agile pointing mechanism, which allows for optimization of global sampling patterns.


2013 ◽  
Vol 690-693 ◽  
pp. 2371-2378
Author(s):  
Wei Pu Xu ◽  
Yi Ting Liu

A brief overview is given in the conventional domed bursting disc structure and manufacturing method. 316L stainless steel as a template is selected. With the investigation on bursting disc material tensile test method, the test results are summarized,also the burst results of disc burst pressure in different sizes. With the help of bursting disc material performance test and bursting disc burst pressure test of 316L , the test results provide a reference for other types of bursting disc.


NIR news ◽  
2016 ◽  
Vol 27 (4) ◽  
pp. 8-10 ◽  
Author(s):  
Matthew Driller ◽  
Daniel Plews ◽  
Nattai Borges

Sign in / Sign up

Export Citation Format

Share Document