Dispersion control in a 100-kHz repetition rate 35-fs laser system

2003 ◽  
Author(s):  
F. Lindner ◽  
M. G. Schaetzel ◽  
F. Grasbon ◽  
Aleksander A. Dreischuh ◽  
G. G. Paulus ◽  
...  
2021 ◽  
Vol 255 ◽  
pp. 10003
Author(s):  
Kore Hasse ◽  
Detlef Kip ◽  
Christian Kränkel

We investigated fs-laser structuring of YAG crystals at high writing velocities up to 100 mm/s using a commercial 10 MHz fs-laser system supplied by Coherent Inc. and selective etching of these structures for fabrication of ultrahigh aspect ratio microchannels. Usage of a diluted acid mixture of 22% H3PO4 and 24% H2SO4 accelerated the etching process significantly to an etching parameter D of 11.2 μm2/s, which is three times higher than previously reported. Additionally, the selectivity of the etching process was increased by an order of magnitude.


2008 ◽  
Vol 16 (19) ◽  
pp. 15109 ◽  
Author(s):  
Bingwei Xu ◽  
Yves Coello ◽  
Giovana T. Nogueira ◽  
Flavio C. Cruz ◽  
Marcos Dantus

2012 ◽  
Author(s):  
J. C. Balzer ◽  
T. Schlauch ◽  
A. Klehr ◽  
G. Erbert ◽  
M. R. Hofmann

2021 ◽  
pp. 103930
Author(s):  
Yaoyao Qi ◽  
Yu Zhang ◽  
Song Yang ◽  
Xiaowei Huo ◽  
Zhenxu Bai ◽  
...  

2010 ◽  
Vol 101 (3) ◽  
pp. 523-534 ◽  
Author(s):  
Y. Nabekawa ◽  
A. Amani Eilanlou ◽  
Y. Furukawa ◽  
K. L. Ishikawa ◽  
H. Takahashi ◽  
...  

2015 ◽  
Vol 13 (6) ◽  
pp. 061401-61404 ◽  
Author(s):  
Qi Yang Qi Yang ◽  
Xiaolei Zhu Xiaolei Zhu ◽  
Jian Ma Jian Ma ◽  
Tingting Lu Tingting Lu ◽  
Xiuhua Ma Xiuhua Ma ◽  
...  

2020 ◽  
Vol 8 ◽  
Author(s):  
Lian Zhou ◽  
Yang Liu ◽  
Gehui Xie ◽  
Chenglin Gu ◽  
Zejiang Deng ◽  
...  

Abstract We report on the generation of a mid-infrared (mid-IR) frequency comb with a maximum average output power of 250 mW and tunability in the 2.7–4.0 μm region. The approach is based on a single-stage difference frequency generation (DFG) starting from a compact Yb-doped fiber laser system. The repetition rate of the near-infrared (NIR) comb is locked at 75 MHz. The phase noise of the repetition rate in the offset-free mid-IR comb system is measured and analyzed. Except for the intrinsic of NIR comb, environmental noise at low frequency and quantum noise at high frequency from the amplifier chain and nonlinear spectral broadening are the main noise sources of broadening the linewidth of comb teeth, which limits the precision of mid-IR dual-comb spectroscopy.


2018 ◽  
Vol 48 (4) ◽  
pp. 358-362 ◽  
Author(s):  
V V Petrov ◽  
G V Kuptsov ◽  
V A Petrov ◽  
A V Laptev ◽  
A V Kirpichnikov ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document