Determination of the optical parameters of dentin from spatially resolved reflectance and transmittance measurements

2001 ◽  
Author(s):  
Florian K. Forster ◽  
Alwin Kienle ◽  
Raimund Hibst
Keyword(s):  
Optical Parameters ◽  
Spatially Resolved

Determination of optical parameters of human breast tissue from spatially resolved fluorescence: a diffusion theory model

2002 ◽  
Vol 41 (19) ◽  
pp. 4024 ◽  
Author(s):  
Maya S. Nair ◽  
Nirmalya Ghosh ◽  
Narisetti Sundar Raju ◽  
Asima Pradhan
Keyword(s):  
Breast Tissue ◽  
Diffusion Theory ◽  
Theory Model ◽  
Optical Parameters ◽  
Human Breast ◽  
Human Breast Tissue ◽  
Spatially Resolved

Computer-Assisted High-Re Solution TEM

1990 ◽  
Vol 48 (1) ◽  
pp. 162-163
Author(s):  
F.A. Ponce ◽  
H. Hikashi
Keyword(s):  
Signal To Noise Ratio ◽  
Accurate Determination ◽  
Computer Software ◽  
Video Camera ◽  
Image Contrast ◽  
Objective Lens ◽  
Computer Assisted ◽  
Optical Parameters ◽  
Astigmatism Correction

The determination of the atomic positions from HRTEM micrographs is only possible if the optical parameters are known to a certain accuracy, and reliable through-focus series are available to match the experimental images with calculated images of possible atomic models. The main limitation in interpreting images at the atomic level is the knowledge of the optical parameters such as beam alignment, astigmatism correction and defocus value. Under ordinary conditions, the uncertainty in these values is sufficiently large to prevent the accurate determination of the atomic positions. Therefore, in order to achieve the resolution power of the microscope (under 0.2nm) it is necessary to take extraordinary measures. The use of on line computers has been proposed [e.g.: 2-5] and used with certain amount of success.We have built a system that can perform operations in the range of one frame stored and analyzed per second. A schematic diagram of the system is shown in figure 1. A JEOL 4000EX microscope equipped with an external computer interface is directly linked to a SUN-3 computer. All electrical parameters in the microscope can be changed via this interface by the use of a set of commands. The image is received from a video camera. A commercial image processor improves the signal-to-noise ratio by recursively averaging with a time constant, usually set at 0.25 sec. The computer software is based on a multi-window system and is entirely mouse-driven. All operations can be performed by clicking the mouse on the appropiate windows and buttons. This capability leads to extreme friendliness, ease of operation, and high operator speeds. Image analysis can be done in various ways. Here, we have measured the image contrast and used it to optimize certain parameters. The system is designed to have instant access to: (a) x- and y- alignment coils, (b) x- and y- astigmatism correction coils, and (c) objective lens current. The algorithm is shown in figure 2. Figure 3 shows an example taken from a thin CdTe crystal. The image contrast is displayed for changing objective lens current (defocus value). The display is calibrated in angstroms. Images are stored on the disk and are accessible by clicking the data points in the graph. Some of the frame-store images are displayed in Fig. 4.

Contactless and Spatially‐Resolved Determination of Current‐Voltage Curves in Perovskite Solar Cells via Photoluminescence

Solar RRL ◽  
2021 ◽  
Author(s):  
Anh Dinh Bui ◽  
Md Arafat Mahmud ◽  
Naeimeh Mozaffari ◽  
Rabin Basnet ◽  
The Duong ◽  
...  
Keyword(s):  
Solar Cells ◽  
Perovskite Solar Cells ◽  
Spatially Resolved ◽  
Current Voltage

scholarly journals Airborne determination of the temporo-spatial distribution of benzene, toluene, nitrogen oxides and ozone in the boundary layer across Greater London, UK

2015 ◽  
Vol 15 (9) ◽  
pp. 5083-5097 ◽  
Author(s):  
M. D. Shaw ◽  
J. D. Lee ◽  
B. Davison ◽  
A. Vaughan ◽  
R. M. Purvis ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Nitrogen Oxides ◽  
Linear Regression Analysis ◽  
Proton Transfer Reaction ◽  
Mixing Ratios ◽  
Spatially Resolved ◽  
Dual Channel ◽  
Benzene Toluene

Abstract. Highly spatially resolved mixing ratios of benzene and toluene, nitrogen oxides (NOx) and ozone (O3) were measured in the atmospheric boundary layer above Greater London during the period 24 June to 9 July 2013 using a Dornier 228 aircraft. Toluene and benzene were determined in situ using a proton transfer reaction mass spectrometer (PTR-MS), NOx by dual-channel NOx chemiluminescence and O3 mixing ratios by UV absorption. Average mixing ratios observed over inner London at 360 ± 10 m a.g.l. were 0.20 ± 0.05, 0.28 ± 0.07, 13.2 ± 8.6, 21.0 ± 7.3 and 34.3 ± 15.2 ppbv for benzene, toluene, NO, NO2 and NOx respectively. Linear regression analysis between NO2, benzene and toluene mixing ratios yields a strong covariance, indicating that these compounds predominantly share the same or co-located sources within the city. Average mixing ratios measured at 360 ± 10 m a.g.l. over outer London were always lower than over inner London. Where traffic densities were highest, the toluene / benzene (T / B) concentration ratios were highest (average of 1.8 ± 0.5 ppbv ppbv-1), indicative of strong local sources. Daytime maxima in NOx, benzene and toluene mixing ratios were observed in the morning (~ 40 ppbv NOx, ~ 350 pptv toluene and ~ 200 pptv benzene) and in the mid-afternoon for ozone (~ 40 ppbv O3), all at 360 ± 10 m a.g.l.

scholarly journals Radiative forcing of the desert aerosol at Ouarzazate (Morocco)

2018 ◽  
Vol 37 ◽  
pp. 03004
Author(s):  
Abdelouahid Tahiri ◽  
Mohamed Diouri
Keyword(s):  
Optical Properties ◽  
Atmospheric Aerosol ◽  
Radiative Forcing ◽  
Cloud Formation ◽  
Optical Parameters ◽  
Aerosol Radiative Forcing ◽  
Daily Average ◽  
Definition Of ◽  
Aerosol Radiative

The atmospheric aerosol contributes to the definition of the climate with direct effect, the diffusion and absorption of solar and terrestrial radiations, and indirect, the cloud formation process where aerosols behave as condensation nuclei and alter the optical properties. Satellites and ground-based networks (solar photometers) allow the terrestrial aerosol observation and the determination of impact. Desert aerosol considered among the main types of tropospheric aerosols whose optical property uncertainties are still quite important. The analysis concerns the optical parameters recorded in 2015 at Ouarzazate solar photometric station (AERONET/PHOTONS network, http://aeronet.gsfc.nasa.gov/) close to Saharan zone. The daily average aerosol optical depthτaer at 0.5μm, are relatively high in summer and less degree in spring (from 0.01 to 1.82). Daily average of the Angstrom coefficients α vary between 0.01 and 1.55. The daily average of aerosol radiative forcing at the surface range between -150W/m2 and -10 W/m2 with peaks recorded in summer, characterized locally by large loads of desert aerosol in agreement with the advections of the Southeast of Morocco. Those recorded at the Top of the atmosphere show a variation from -74 W/m2 to +24 W/m2

Photo-acoustic determination of optical parameters of tissue-like media with reference to opto-acoustic diffraction

1997 ◽  
Vol 12 (4) ◽  
pp. 357-363 ◽  
Author(s):  
S. Lohmann ◽  
Chr. Ruff ◽  
Chr. Schmitz ◽  
H. Lubatschowski ◽  
W. Ertmer
Keyword(s):  
Optical Parameters ◽  
Acoustic Diffraction

Simple method for the determination of optical parameters of inhomogeneous thin films

1999 ◽  
Vol 342 (1-2) ◽  
pp. 153-159 ◽  
Author(s):  
Liberato De Caro ◽  
Maria Cristina Ferrara
Keyword(s):  
Thin Films ◽  
Optical Parameters ◽  
Simple Method
Sign in / Sign up

Export Citation Format

Share Document