CO2 Doppler lidar measurement of wind velocity and relative backscatter associated with the nocturnal boundary layer

1999 ◽  
Author(s):  
John R. Roadcap ◽  
Patrick J. McNicholl ◽  
Mitchell H. Laird ◽  
Robert A. Swirbalus
Keyword(s):  
Boundary Layer ◽  
Wind Velocity ◽  
Nocturnal Boundary Layer ◽  
Lidar Measurement ◽  
Doppler Lidar

Lidar Measurement of Wind Velocity Profiles in the Boundary Layer

1980 ◽  
Vol 19 (5) ◽  
pp. 598-605 ◽  
Author(s):  
Jeffery T. Sroga ◽  
Edwin W. Eloranta ◽  
Ted Barber
Keyword(s):  
Boundary Layer ◽  
Wind Velocity ◽  
Velocity Profiles ◽  
Lidar Measurement

scholarly journals STRUCTURE OF STABLE NOCTURNAL BOUNDARY LAYER IN URBAN AREA DETECTED IN A DOPPLER LIDAR OBSERVATION

2012 ◽  
Vol 68 (4) ◽  
pp. I_1777-I_1782
Author(s):  
Ryoko ODA ◽  
Hironori IWAI ◽  
Atsushi INAGAKI ◽  
Shoken ISHII ◽  
Shinsuke SATOH ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Urban Area ◽  
Nocturnal Boundary Layer ◽  
Doppler Lidar ◽  
Lidar Observation

scholarly journals Nocturnal Boundary Layer Erosion Analysis in the Amazon Using Large-Eddy Simulation during GoAmazon Project 2014/5

Atmosphere ◽  
2021 ◽  
Vol 12 (2) ◽  
pp. 240
Author(s):  
Rayonil Carneiro ◽  
Gilberto Fisch ◽  
Theomar Neves ◽  
Rosa Santos ◽  
Carlos Santos ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Large Eddy Simulation ◽  
Rainy Season ◽  
Nocturnal Boundary Layer ◽  
Enso Event ◽  
Dry Season ◽  
Dry Period ◽  
Additional Energy ◽  
Eddy Simulation ◽  
Large Eddy

This study investigated the erosion of the nocturnal boundary layer (NBL) over the central Amazon using a high-resolution model of large-eddy simulation (LES) named PArallel Les Model (PALM) and observational data from Green Ocean Amazon (GoAmazon) project 2014/5. This data set was collected during four intense observation periods (IOPs) in the dry and rainy seasons in the years 2014 (considered a typical year) and 2015, during which an El Niño–Southern Oscillation (ENSO) event predominated and provoked an intense dry season. The outputs from the PALM simulations represented reasonably well the NBL erosion, and the results showed that it has different characteristics between the seasons. During the rainy season, the IOPs exhibited slow surface heating and less intense convection, which resulted in a longer erosion period, typically about 3 h after sunrise (that occurs at 06:00 local time). In contrast, dry IOPs showed more intensive surface warming with stronger convection, resulting in faster NBL erosion, about 2 h after sunrise. A conceptual model was derived to investigate the complete erosion during sunrise hours when there is a very shallow mixed layer formed close to the surface and a stable layer above. The kinematic heat flux for heating this layer during the erosion period showed that for the rainy season, the energy emitted from the surface and the entrainment was not enough to fully heat the NBL layer and erode it. Approximately 30% of additional energy was used in the system, which could come from the release of energy from biomass. The dry period of 2014 showed stronger heating, but it was also not enough, requiring approximately 6% of additional energy. However, for the 2015 dry period, which was under the influence of the ENSO event, it was shown that the released surface fluxes were sufficient to fully heat the layer. The erosion time of the NBL probably influenced the development of the convective boundary layer (CBL), wherein greater vertical development was observed in the dry season IOPs (~1500 m), while the rainy season IOPs had a shallower layer (~1200 m).

scholarly journals Nocturnal Boundary Layer Evolution and Its Impacts on the Vertical Distributions of Pollutant Particulate Matter

Atmosphere ◽  
2021 ◽  
Vol 12 (5) ◽  
pp. 610
Author(s):  
Yu Shi ◽  
Lei Liu ◽  
Fei Hu ◽  
Guangqiang Fan ◽  
Juntao Huo
Keyword(s):  
Boundary Layer ◽  
Nitrate Concentration ◽  
Inversion Layer ◽  
Mixing Layer ◽  
Early Morning ◽  
Nocturnal Boundary Layer ◽  
Atmospheric Environment ◽  
Considerable Proportion ◽  
Surface Inversion ◽  
Vertical Distributions

To investigate the evolution of the nocturnal boundary layer (NBL) and its impacts on the vertical distributions of pollutant particulates, a combination of in situ observations from a large tethered balloon, remote sensing instruments (aerosol lidar and Doppler wind lidar) and an atmospheric environment-monitoring vehicle were utilized. The observation site was approximately 100 km southwest of Beijing, the capital of China. Results show that a considerable proportion of pollutant particulates were still suspended in the residual layer (RL) (e.g., the nitrate concentration reached 30 μg m−3) after sunset. The NBL height calculated by the aerosol lidar was closer to the top of the RL before midnight because of the pollutants stored aloft in the RL and the shallow surface inversion layer; after midnight, the NBL height was more consistent with the top of the surface inversion layer. As the convective mixing layer gradually became established after sunrise the following day, the pollutants stored in the nocturnal RL of the preceding night were entrained downward into the mixing layer. The early morning PM2.5 concentration near 700 m in the RL on 20 December decreased by 83% compared with the concentration at 13:34 on 20 December at the same height. The nitrate concentration also decreased significantly in the RL, and the mixing down of nitrate from the RL could contribute about 37% to the nitrate in the mixing layer. Turbulence activities still existed in the RL with the bulk Richardson number (Rb) below the threshold value. The corresponding increase in PM2.5 was likely to be correlated with the weak turbulence in the RL in the early morning.

Observations of Small-Scale Turbulence and Energy Dissipation Rates in the Cloudy Boundary Layer

2006 ◽  
Vol 63 (5) ◽  
pp. 1451-1466 ◽  
Author(s):  
Holger Siebert ◽  
Katrin Lehmann ◽  
Manfred Wendisch
Keyword(s):  
Boundary Layer ◽  
Energy Dissipation ◽  
Wind Velocity ◽  
Turbulence Theory ◽  
Horizontal Wind ◽  
Inertial Subrange ◽  
Intermittent Flow ◽  
Small Scale ◽  
Dissipation Rates ◽  
Wide Range

Abstract Tethered balloon–borne measurements with a resolution in the order of 10 cm in a cloudy boundary layer are presented. Two examples sampled under different conditions concerning the clouds' stage of life are discussed. The hypothesis tested here is that basic ideas of classical turbulence theory in boundary layer clouds are valid even to the decimeter scale. Power spectral densities S( f ) of air temperature, liquid water content, and wind velocity components show an inertial subrange behavior down to ≈20 cm. The mean energy dissipation rates are ∼10−3 m2 s−3 for both datasets. Estimated Taylor Reynolds numbers (Reλ) are ∼104, which indicates the turbulence is fully developed. The ratios between longitudinal and transversal S( f ) converge to a value close to 4/3, which is predicted by classical turbulence theory for local isotropic conditions. Probability density functions (PDFs) of wind velocity increments Δu are derived. The PDFs show significant deviations from a Gaussian distribution with longer tails typical for an intermittent flow. Local energy dissipation rates ɛτ are derived from subsequences with a duration of τ = 1 s. With a mean horizontal wind velocity of 8 m s−1, τ corresponds to a spatial scale of 8 m. The PDFs of ɛτ can be well approximated with a lognormal distribution that agrees with classical theory. Maximum values of ɛτ ≈ 10−1 m2 s−3 are found in the analyzed clouds. The consequences of this wide range of ɛτ values for particle–turbulence interaction are discussed.

scholarly journals Simulation of Doppler Lidar Measurement Range and Data Availability

2016 ◽  
Vol 33 (5) ◽  
pp. 977-987 ◽  
Author(s):  
Matthieu Boquet ◽  
Philippe Royer ◽  
Jean-Pierre Cariou ◽  
Mehdi Machta ◽  
Matthieu Valla
Keyword(s):  
Measurement Range ◽  
Data Availability ◽  
Lidar Measurement ◽  
Doppler Lidar ◽  
New Approach ◽  
Density Distributions ◽  
Time Period ◽  
Atmospheric Observations ◽  
Type Size ◽  
Weather Stations

AbstractThe measurement range of a coherent wind Doppler lidar (CWDL) along a laser beam is the maximum distance from the lidar where wind speed data are accurately retrieved. It means that, at this distance, a sufficient number of emitted laser photons are backscattered and received by the lidar. Understanding of the propagation of the laser through the atmosphere, and particularly the backscattering and extinction processes from aerosols, is therefore important to estimate the metrological performances of a CWDL instrument. The range is directly related to specific instrument characteristics and atmospheric content, such as the aerosols type, size, and density distributions. Associated with the measurement range is the notion of data availability, which can be defined, at a given range and over a time period, as the percentage number of data retrieved correctly by the CWDL over the total number of measurement attempts.This paper proposes a new approach to predict the CWDL data availability and range of measurement using both instrumental simulation and atmospheric observations of aerosol optical properties from weather stations and simulations. This method is applied in several CWDL measurement campaigns during which estimated data availabilities and ranges are compared with the observations. It is shown that it is fairly possible to anticipate the data availability and the range coverage of CWDL technology at any site of interest where atmospheric data are available. The method also offers an additional way to diagnose the operation of the instrument and will help in the design of future instruments.

Sign in / Sign up

Export Citation Format

Share Document