Investigation of local atmospheric processes with measuring instruments of JUC atmosphere and high-resolution mesoscale model

Author(s):  
Alexander V. Starchenko ◽  
Sergey L. Odintsov ◽  
Lubov I. Kizhner ◽  
Elena Shelmina ◽  
Sergey Prohanov ◽  
...  
2014 ◽  
Vol 15 (4) ◽  
pp. 1517-1531 ◽  
Author(s):  
Gerhard Smiatek ◽  
Harald Kunstmann ◽  
Andreas Heckl

Abstract The impact of climate change on the future water availability of the upper Jordan River (UJR) and its tributaries Dan, Snir, and Hermon located in the eastern Mediterranean is evaluated by a highly resolved distributed approach with the fifth-generation Pennsylvania State University–NCAR Mesoscale Model (MM5) run at 18.6- and 6.2-km resolution offline coupled with the Water Flow and Balance Simulation Model (WaSiM). The MM5 was driven with NCEP reanalysis for 1971–2000 and with Hadley Centre Coupled Model, version 3 (HadCM3), GCM forcings for 1971–2099. Because only one regional–global climate model combination was applied, the results may not give the full range of possible future projections. To describe the Dan spring behavior, the hydrological model was extended by a bypass approach to allow the fast discharge components of the Snir to enter the Dan catchment. Simulation results for the period 1976–2000 reveal that the coupled system was able to reproduce the observed discharge rates in the partially karstic complex terrain to a reasonable extent with the high-resolution 6.2-km meteorological input only. The performed future climate simulations show steadily rising temperatures with 2.2 K above the 1976–2000 mean for the period 2031–60 and 3.5 K for the period 2070–99. Precipitation trends are insignificant until the middle of the century, although a decrease of approximately 12% is simulated. For the end of the century, a reduction in rainfall ranging between 10% and 35% can be expected. Discharge in the UJR is simulated to decrease by 12% until 2060 and by 26% until 2099, both related to the 1976–2000 mean. The discharge decrease is associated with a lower number of high river flow years.


2012 ◽  
Vol 2012 ◽  
pp. 1-15 ◽  
Author(s):  
P. Goswami ◽  
J. Baruah

Concentrations of atmospheric pollutants are strongly influenced by meteorological parameters like rainfall, relative humidity and wind advection. Thus accurate specifications of the meteorological fields, and their effects on pollutants, are critical requirements for successful modelling of air pollution. In terms of their applications, pollutant concentration models can be used in different ways; in one, short term high resolution forecasts are generated to predict and manage urban pollution. Another application of dynamical pollution models is to generate outlook for a given airbasin, such as over a large city. An important question is application-specific model configuration for the meteorological simulations. While a meso-scale model provides a high-resolution configuration, a global model allows better simulation of large-sale fields through its global environment. Our objective is to comparatively evaluate a meso-scale atmospheric model (MM5) and atmospheric global circulation model (AGCM) in simulating different species of pollutants over different airbasins. In this study we consider four locations: ITO (Central Delhi), Sirifort (South Delhi), Bandra (Mumbai) and Karve Road (Pune). The results show that both the model configurations provide comparable skills in simulation of monthly and annual loads, although the skill of the meso-scale model is somewhat higher, especially at shorter time scales.


2012 ◽  
Vol 117 (C2) ◽  
pp. n/a-n/a ◽  
Author(s):  
Donald R. Thompson ◽  
Jochen Horstmann ◽  
Alexis Mouche ◽  
Nathaniel S. Winstead ◽  
Raymond Sterner ◽  
...  

2016 ◽  
Vol 125 (3) ◽  
pp. 475-498 ◽  
Author(s):  
P V Rajesh ◽  
S Pattnaik ◽  
D Rai ◽  
K K Osuri ◽  
U C Mohanty ◽  
...  

2014 ◽  
Vol 71 (4) ◽  
pp. 1353-1370 ◽  
Author(s):  
Sabrina Gentile ◽  
Rossella Ferretti ◽  
Frank Silvio Marzano

Abstract One event of a tropical thunderstorm typically observed in northern Australia, known as Hector, is investigated using high-resolution model output from the fifth-generation Pennsylvania State University–National Center for Atmospheric Research (PSU–NCAR) Mesoscale Model (MM5) observations from a ground-based weather radar located in Berrimah (Australia) and data from the Tropical Rainfall Measuring Mission (TRMM) satellite. The analysis is carried out by tracking the full life cycle of Hector from prestorm stage to the decaying stage. In both the prestorm stage, characterized by nonprecipitating cells, and the triggering stage, when the Hector storm is effectively initiated, an analysis is performed with the aid of high-spatial-and-temporal-resolution MM5 output and the Berrimah ground-based radar imagery. During the mature (“old”) stage of Hector, considering the conceptual model for tropical convection suggested by R. Houze, TRMM Microwave Imager satellite-based data were added to ground-based radar data to analyze the storm vertical structure (dynamics, thermodynamics, and hydrometeor contents). Model evaluation with respect to observations (radar reflectivity and TRMM data) suggests that MM5 performed fairly well in reproducing the dynamics of Hector, providing support to the assertion that the strength of convection, in terms of vertical velocity, largely contributes to the vertical distribution of hydrometeors. Moreover, the stages of the storm and its vertical structure display good agreement with Houze’s aforementioned conceptual model. Finally, it was found that the most important triggering mechanisms for this Hector event are topography, the sea breeze, and a gust front produced by previous convection.


Author(s):  
Darko Koracin ◽  
Richard L. Reinhardt ◽  
Marshall B. Liddle ◽  
Travis McCord ◽  
Domagoj Podnar ◽  
...  

The main objectives of the study were to support wind energy assessment for all of Nevada by providing two annual cycles of high-resolution mesoscale modeling evaluated by data from surface stations and towers, estimating differences between these annual cycles and standard wind maps, and providing wind and wind power density statistics at elevations relevant to turbine operations. In addition to the 65 existing Remote Automated Weather Stations in Nevada, four 50-m-tall meteorological towers were deployed in western Nevada to capture long-term wind characteristics and provide database input to verify and improve modeling results. The modeling methodology using Mesoscale Model 5 (MM5) was developed to provide wind and wind power density estimates representing mesoscale effects that include actual synoptic forcing during the two annual cycles (horizontal resolution on the order of 2 and 3 km). The results from the two annual simulation cycles show similar wind statistics with an average difference of less than 100 W/m2. The available TrueWind results for the wind power density at 50 m show greater values of wind power density compared to both MM5-simulated annual cycles for most of the area. However, mainly in the Sierras and the mountainous regions of southern and eastern Nevada, the MM5 simulations indicate greater values for wind power density. The results of this study suggest that the synthesis of the data from a network of tower observations and high-resolution mesoscale modeling is a crucial tool for assessing the wind power density in Nevada and, more generally, other topographically developed areas.


2008 ◽  
Vol 136 (7) ◽  
pp. 2488-2506 ◽  
Author(s):  
Qingqing Li ◽  
Yihong Duan ◽  
Hui Yu ◽  
Gang Fu

Abstract In this study, the fifth-generation Pennsylvania State University–National Center for Atmospheric Research (PSU–NCAR) Mesoscale Model (MM5) is used to simulate Typhoon Rananim (2004) at high resolution (2-km grid size). The simulation agrees well with a variety of observations, especially for intensification, maintenance, landfall, and inner-core structures, including the echo-free eye, the asymmetry in eyewall convection, and the slope of the eyewall during landfall. The asymmetric feature of surface winds is also captured reasonably well by the model, as well as changes in surface winds and pressure near the storm center. The shear-induced vortex tilt and storm-relative asymmetric winds are examined to investigate how vertical shear affects the asymmetric convection in the inner-core region. The inner-core vertical shear is found to be nonunidirectional, and to induce a nonunidirectional vortex tilt. The distribution of asymmetric convection is, however, inconsistent with the typical downshear-left pattern for a deep-layer shear. Qualitative agreement is found between the divergence pattern and the storm-relative flow, with convergence (divergence) generally associated with asymmetric inflow (outflow) in the eyewall. The collocation of the inflow-induced lower-level convergence in the boundary layer and the lower troposphere and the midlevel divergence causes shallow updrafts in the western and southern parts of the eyewall, while the deep and strong upward motion in the southeastern portion of the eyewall is due to the collocation of the net convergence associated with the strong asymmetric flow in the midtroposphere and the inflow near 400 hPa and its associated divergence in the outflow layer above 400 hPa.


2012 ◽  
Vol 65 (1) ◽  
pp. 331-357 ◽  
Author(s):  
C. V. Srinivas ◽  
V. Yesubabu ◽  
K. B. R. R. Hariprasad ◽  
S. S. V. Ramakrishna ◽  
B. Venkatraman

Sign in / Sign up

Export Citation Format

Share Document