Experimental calibration of x-ray camera performance: spatial resolution, flat field response, and radiation sensitivity

2014 ◽  
Author(s):  
Hongwei Xie ◽  
Jinchuan Chen ◽  
Linbo Li ◽  
Faqiang Zhang ◽  
Dingyang Chen
Keyword(s):  
Spatial Resolution ◽  
Radiation Sensitivity ◽  
Experimental Calibration ◽  
X Ray ◽  
Field Response ◽  
Flat Field

DESIGN OF A FLAT FIELD SPECTROMETER FOR SOFT X-RAY EMISSION SPECTROSCOPY

2002 ◽  
Vol 09 (01) ◽  
pp. 503-508 ◽  
Author(s):  
T. TOKUSHIMA ◽  
Y. HARADA ◽  
M. WATANABE ◽  
Y. TAKATA ◽  
E. ISHIGURO ◽  
...  
Keyword(s):  
Spatial Resolution ◽  
Energy Resolution ◽  
Emission Spectroscopy ◽  
Detection Efficiency ◽  
Maximum Energy ◽  
X Ray ◽  
Compact Size ◽  
Spectral Dispersion ◽  
Ccd Detector ◽  
Flat Field

A spectrometer for soft X-ray emission spectroscopy was designed and constructed. The aims of this spectrometer are high detection efficiency and realizing the energy resolution of 1000 (E/ΔE) in a compact size. To satisfy these requirements, a flat field spectrometer with a varied line spacing grating and a CCD detector was chosen. Furthermore, the configuration without the entrance slit was employed. For compact flat field spectrometers, the spectral dispersion on the detector is sometimes smaller than the spatial resolution of existing detectors restricting maximum energy resolution. The spectral dispersion on the detector was optimized to balance with the spatial resolution of CCD. Optical performance was tested with a ray-tracing program. The spectrometer covers 250–900 eV, with two gratings. Taking into account the spatial resolution of a CCD detector, the maximum energy resolution of the spectrometer is estimated to be about 1000 (E/ΔE) for the beam size of 10 μm. Using the constructed spectrometer, test experiments were performed at the beamline BL27SU in SPring-8.

Spatial resolution of X-ray microanalysis in thin foils

1978 ◽  
Vol 36 (1) ◽  
pp. 544-545
Author(s):  
R. Hutchings ◽  
I.P. Jones ◽  
M.H. Loretto ◽  
R.E. Smallman
Keyword(s):  
Spatial Resolution ◽  
Electron Probe ◽  
Beam Divergence ◽  
Inelastic Interaction ◽  
Specimen Thickness ◽  
High Current ◽  
Beam Spreading ◽  
X Ray ◽  
Thin Foils ◽  
Complex Calculation

There is increasing interest in X-ray microanalysis of thin specimens and the present paper attempts to define some of the factors which govern the spatial resolution of this type of microanalysis. One of these factors is the spreading of the electron probe as it is transmitted through the specimen. There will always be some beam-spreading with small electron probes, because of the inevitable beam divergence associated with small, high current probes; a lower limit to the spatial resolution is thus 2αst where 2αs is the beam divergence and t the specimen thickness.In addition there will of course be beam spreading caused by elastic and inelastic interaction between the electron beam and the specimen. The angle through which electrons are scattered by the various scattering processes can vary from zero to 180° and it is clearly a very complex calculation to determine the effective size of the beam as it propagates through the specimen.

High spatial resolution x-ray microanalysis of interfaces

1995 ◽  
Vol 53 ◽  
pp. 284-285
Author(s):  
J. R. Michael
Keyword(s):  
Spatial Resolution ◽  
Electron Probe ◽  
Solid Angle ◽  
Collection Efficiency ◽  
Spatial Scales ◽  
Energy Dispersive Spectrometer ◽  
X Rays ◽  
X Ray ◽  
Probe Size ◽  
Brightness Field

X-ray microanalysis in the analytical electron microscope (AEM) refers to a technique by which chemical composition can be determined on spatial scales of less than 10 nm. There are many factors that influence the quality of x-ray microanalysis. The minimum probe size with sufficient current for microanalysis that can be generated determines the ultimate spatial resolution of each individual microanalysis. However, it is also necessary to collect efficiently the x-rays generated. Modern high brightness field emission gun equipped AEMs can now generate probes that are less than 1 nm in diameter with high probe currents. Improving the x-ray collection solid angle of the solid state energy dispersive spectrometer (EDS) results in more efficient collection of x-ray generated by the interaction of the electron probe with the specimen, thus reducing the minimum detectability limit. The combination of decreased interaction volume due to smaller electron probe size and the increased collection efficiency due to larger solid angle of x-ray collection should enhance our ability to study interfacial segregation.

Scanning x-ray fluorescence microscopy and principal component analysis

1992 ◽  
Vol 50 (2) ◽  
pp. 1752-1753
Author(s):  
Brian Cross
Keyword(s):  
Principal Component Analysis ◽  
Fluorescence Microscopy ◽  
Spatial Resolution ◽  
High Speed ◽  
Image Acquisition ◽  
Principal Component ◽  
Fluorescence Microscope ◽  
Acquisition Rate ◽  
X Ray ◽  
Speed Up

A relatively new entry, in the field of microscopy, is the Scanning X-Ray Fluorescence Microscope (SXRFM). Using this type of instrument (e.g. Kevex Omicron X-ray Microprobe), one can obtain multiple elemental x-ray images, from the analysis of materials which show heterogeneity. The SXRFM obtains images by collimating an x-ray beam (e.g. 100 μm diameter), and then scanning the sample with a high-speed x-y stage. To speed up the image acquisition, data is acquired "on-the-fly" by slew-scanning the stage along the x-axis, like a TV or SEM scan. To reduce the overhead from "fly-back," the images can be acquired by bi-directional scanning of the x-axis. This results in very little overhead with the re-positioning of the sample stage. The image acquisition rate is dominated by the x-ray acquisition rate. Therefore, the total x-ray image acquisition rate, using the SXRFM, is very comparable to an SEM. Although the x-ray spatial resolution of the SXRFM is worse than an SEM (say 100 vs. 2 μm), there are several other advantages.

Practical Importance of Spatial Resolution and Analytical Sensitivity in AEM X-ray Microanalysis

1990 ◽  
Vol 48 (2) ◽  
pp. 432-433
Author(s):  
J. Zhang ◽  
D.B. Williams ◽  
J.I. Goldstein
Keyword(s):  
Spatial Resolution ◽  
Practical Importance ◽  
Beam Current ◽  
Specimen Thickness ◽  
Analytical Sensitivity ◽  
Related Factors ◽  
X Ray ◽  
Probe Size ◽  
Excitation Volume ◽  
Two Parameters

Analytical sensitivity and spatial resolution are important and closely related factors in x-ray microanalysis using the AEM. Analytical sensitivity is the ability to distinguish, for a given element under given conditions, between two concentrations that are nearly equal. The analytical sensitivity is directly related to the number of x-ray counts collected and, therefore, to the probe current, specimen thickness and counting time. The spatial resolution in AEM analysis is determined by the probe size and beam broadening in the specimen. A finer probe and a thinner specimen give a higher spatial resolution. However, the resulting lower beam current and smaller X-ray excitation volume degrade analytical sensitivity. A compromise must be made between high spatial resolution and an acceptable analytical sensitivity. In this paper, we show the necessity of evaluating these two parameters in order to determine the low temperature Fe-Ni phase diagram.A Phillips EM400T AEM with an EDAX/TN2000 EDS/MCA system and a VG HB501 FEG STEM with a LINK AN10 EDS/MCA system were used.

Low-voltage EDS of magnesium ferrite Dendrites in a FEG-SEM

1996 ◽  
Vol 54 ◽  
pp. 478-479
Author(s):  
Matthew T. Johnson ◽  
Ian M. Anderson ◽  
Jim Bentley ◽  
C. Barry Carter
Keyword(s):  
Monte Carlo ◽  
Quantitative Analysis ◽  
Monte Carlo Simulations ◽  
Cross Section ◽  
Spatial Resolution ◽  
Low Voltage ◽  
Magnesium Ferrite ◽  
X Ray ◽  
Interaction Volume ◽  
Ferrite Spinel

Energy-dispersive X-ray spectrometry (EDS) performed at low (≤ 5 kV) accelerating voltages in the SEM has the potential for providing quantitative microanalytical information with a spatial resolution of ∼100 nm. In the present work, EDS analyses were performed on magnesium ferrite spinel [(MgxFe1−x)Fe2O4] dendrites embedded in a MgO matrix, as shown in Fig. 1. spatial resolution of X-ray microanalysis at conventional accelerating voltages is insufficient for the quantitative analysis of these dendrites, which have widths of the order of a few hundred nanometers, without deconvolution of contributions from the MgO matrix. However, Monte Carlo simulations indicate that the interaction volume for MgFe2O4 is ∼150 nm at 3 kV accelerating voltage and therefore sufficient to analyze the dendrites without matrix contributions.Single-crystal {001}-oriented MgO was reacted with hematite (Fe2O3) powder for 6 h at 1450°C in air and furnace cooled. The specimen was then cleaved to expose a clean cross-section suitable for microanalysis.

scholarly journals High-Spatial-Resolution Bone Densitometry with Dual-Energy X-ray Absorptiometric Region-free Analysis

Radiology ◽  
2015 ◽  
Vol 275 (1) ◽  
pp. 310-310 ◽  
Author(s):  
Richard M. Morris ◽  
Lang Yang ◽  
Miguel A. Martín-Fernández ◽  
Jose M. Pozo ◽  
Alejandro F. Frangi ◽  
...  
Keyword(s):  
Spatial Resolution ◽  
Bone Densitometry ◽  
High Spatial Resolution ◽  
Dual Energy ◽  
X Ray

scholarly journals Visualization Ability of Phase-Contrast Synchrotron-Based X-Ray Imaging Using an X-Ray Interferometer in Soft Tissue Tumors

2021 ◽  
Vol 20 ◽  
pp. 153303382110101
Author(s):  
Thet-Thet Lwin ◽  
Akio Yoneyama ◽  
Hiroko Maruyama ◽  
Tohoru Takeda
Keyword(s):  
Computed Tomography ◽  
Soft Tissue ◽  
Spatial Resolution ◽  
Phase Contrast ◽  
Soft Tissue Tumors ◽  
X Ray ◽  
3 Dimensional ◽  
Computed Tomography Images ◽  
X Ray Imaging ◽  
X Ray Computed

Phase-contrast synchrotron-based X-ray imaging using an X-ray interferometer provides high sensitivity and high spatial resolution, and it has the ability to depict the fine morphological structures of biological soft tissues, including tumors. In this study, we quantitatively compared phase-contrast synchrotron-based X-ray computed tomography images and images of histopathological hematoxylin-eosin-stained sections of spontaneously occurring rat testicular tumors that contained different types of cells. The absolute densities measured on the phase-contrast synchrotron-based X-ray computed tomography images correlated well with the densities of the nuclear chromatin in the histological images, thereby demonstrating the ability of phase-contrast synchrotron-based X-ray imaging using an X-ray interferometer to reliably identify the characteristics of cancer cells within solid soft tissue tumors. In addition, 3-dimensional synchrotron-based phase-contrast X-ray computed tomography enables screening for different structures within tumors, such as solid, cystic, and fibrous tissues, and blood clots, from any direction and with a spatial resolution down to 26 μm. Thus, phase-contrast synchrotron-based X-ray imaging using an X-ray interferometer shows potential for being useful in preclinical cancer research by providing the ability to depict the characteristics of tumor cells and by offering 3-dimensional information capabilities.

Sign in / Sign up

Export Citation Format

Share Document