Investigation of low leakage current radiation detectors on n-type 4H-SiC epitaxial layers

2014 ◽  
Author(s):  
Khai V. Nguyen ◽  
Sandeep K. Chaudhuri ◽  
Krishna C. Mandal
2005 ◽  
Vol 483-485 ◽  
pp. 429-432 ◽  
Author(s):  
Francesco La Via ◽  
Fabrizio Roccaforte ◽  
Salvatore di Franco ◽  
Alfonso Ruggiero ◽  
L. Neri ◽  
...  

The effects of the Si/H2 ratio on the growth of the epitaxial layer and on the epitaxial defects was studied in detail. A large increase of the growth rate has been observed with the increase of the silicon flux in the CVD reactor. Close to a Si/H2 ratio of 0.05 % silicon nucleation in the gas phase occurs producing a great amount of silicon particles that precipitate on the wafers. The epitaxial layers grown with a Si/H2 ratio of 0.03% show a low defect density and a low leakage current of the Schottky diodes realized on these wafers. For these diodes the DLTS spectra show thepresence of several peaks at 0.14, 0.75, 1.36 and 1.43 eV. For epitaxial layers grown with higher values of the Si/H2 ratio and then with an higher growth rate, the leakage current of the Schottky diodes increases considerably.


2021 ◽  
Vol 285 ◽  
pp. 129120
Author(s):  
Wenxin Liang ◽  
Hongfeng Zhao ◽  
Xiaoji Meng ◽  
Shaohua Fan ◽  
Qingyun Xie

2013 ◽  
Vol 1538 ◽  
pp. 291-302
Author(s):  
Edward Yi Chang ◽  
Hai-Dang Trinh ◽  
Yueh-Chin Lin ◽  
Hiroshi Iwai ◽  
Yen-Ku Lin

ABSTRACTIII-V compounds such as InGaAs, InAs, InSb have great potential for future low power high speed devices (such as MOSFETs, QWFETs, TFETs and NWFETs) application due to their high carrier mobility and drift velocity. The development of good quality high k gate oxide as well as high k/III-V interfaces is prerequisite to realize high performance working devices. Besides, the downscaling of the gate oxide into sub-nanometer while maintaining appropriate low gate leakage current is also needed. The lack of high quality III-V native oxides has obstructed the development of implementing III-V based devices on Si template. In this presentation, we will discuss our efforts to improve high k/III-V interfaces as well as high k oxide quality by using chemical cleaning methods including chemical solutions, precursors and high temperature gas treatments. The electrical properties of high k/InSb, InGaAs, InSb structures and their dependence on the thermal processes are also discussed. Finally, we will present the downscaling of the gate oxide into sub-nanometer scale while maintaining low leakage current and a good high k/III-V interface quality.


2018 ◽  
Vol 65 (2) ◽  
pp. 680-686 ◽  
Author(s):  
Cheng-Jung Lee ◽  
Ke-Jing Lee ◽  
Yu-Chi Chang ◽  
Li-Wen Wang ◽  
Der-Wei Chou ◽  
...  

2021 ◽  
pp. 106413
Author(s):  
Yuexin Yang ◽  
Zhuohui Xu ◽  
Tian Qiu ◽  
Honglong Ning ◽  
Jinyao Zhong ◽  
...  

2021 ◽  
Vol 15 (1) ◽  
pp. 016501
Author(s):  
Fumio Otsuka ◽  
Hironobu Miyamoto ◽  
Akio Takatsuka ◽  
Shinji Kunori ◽  
Kohei Sasaki ◽  
...  

Abstract We fabricated high forward and low leakage current trench MOS-type Schottky barrier diodes (MOSSBDs) in combination with a field plate on a 12 μm thick epitaxial layer grown by halide vapor phase epitaxy on β-Ga2O3 (001) substrate. The MOSSBDs, measuring 1.7 × 1.7 mm2, exhibited a forward current of 2 A (70 A cm−2) at 2 V forward voltage and a leakage current of 5.7 × 10–10 A at −1.2 kV reverse voltage (on/off current ratio of > 109) with an ideality factor of 1.05 and wafer-level specific on-resistance of 17.1 mΩ · cm2.


2018 ◽  
Vol 44 (10) ◽  
pp. 862-864 ◽  
Author(s):  
N. A. Maleev ◽  
M. A. Bobrov ◽  
A. G. Kuzmenkov ◽  
A. P. Vasil’ev ◽  
M. M. Kulagina ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document