Nondestructive on-line density measurement of organic material on a steel conveyor belt using x-ray scattering

1993 ◽  
Author(s):  
Jacob F. Moskowitz
2014 ◽  
Vol 70 (a1) ◽  
pp. C1074-C1074
Author(s):  
Sylvio Haas ◽  
Thomás Plivelic ◽  
Cedric Dicko

Modern applications and basic research in medicine, biotechnology and materials are often concerned with hybrid (organic-inorganic) and synergetic systems. In other words, systems that brings enhanced properties and performances. The challenge is now in the understanding of the complex interactions leading to their assembly and operation. Due to their inherent chemical and structural complexities a combination of several techniques is necessary to determine unambiguously the molecular mechanisms of assembly and operation. [1, 2] To address this need, we have implemented a simultaneous measurement platform called SURF [3] that consists of SAXS, UV-Vis, Raman and fluorescence techniques. The SURF platform provides simultaneous measurements on the same sample volume and a multivariate framework to associate the spectroscopic and X-ray scattering information. Convex constraint analysis (CCA) and two dimensional correlation analyses (2DCOS and 2DHCOS) had been introduced to enhance the interpretation and integration of the data from the different techniques producing self-consistent models and resolving complex behaviour details (structure and chemistry). Additional benefits of the SURF are sample quality control and "on line" diagnostics. In this contribution, we illustrate the benefits of the SURF approach on selected examples. Acknowledgements: The SURF set-up has been mainly financial supported by MAX IV laboratory. S. Haas has a postdoctoral grant of MAX IV lab. S Canton and Q. Zhu are acknowledged for fruitful discussions.


2015 ◽  
Vol 27 (6) ◽  
pp. 64001
Author(s):  
朱鹏飞 Zhu Pengfei ◽  
叶雁 Ye Yan ◽  
李作友 Li Zuoyou ◽  
阳庆国 Yang Qingguo ◽  
祁双喜 Qi Shuangxi ◽  
...  

2020 ◽  
Vol 27 (1) ◽  
pp. 51-59
Author(s):  
Max Burian ◽  
Benedetta Marmiroli ◽  
Andrea Radeticchio ◽  
Christian Morello ◽  
Denys Naumenko ◽  
...  

A new setup for picosecond pump–probe X-ray scattering at the Austrian SAXS beamline at Elettra-Sincrotrone Trieste is presented. A high-power/high-repetion-rate laser has been installed on-site, delivering UV/VIS/IR femtosecond-pulses in-sync with the storage ring. Data acquisition is achieved by gating a multi-panel detector, capable of discriminating the single X-ray pulse in the dark-gap of the Elettra hybrid filling mode. Specific aspects of laser- and detection-synchronization, on-line beam steering as well protocols for spatial and temporal overlap of laser and X-ray beam are also described. The capabilities of the setup are demonstrated by studying transient heat-transfer in an In/Al/GaAs superlattice structure and results are confirmed by theoretical calculations.


2007 ◽  
Author(s):  
E. Ziegler ◽  
L. Peverini ◽  
I. V. Kozhevnikov ◽  
T. Weitkamp ◽  
C. David

Author(s):  
Eva-Maria Mandelkow ◽  
Eckhard Mandelkow ◽  
Joan Bordas

When a solution of microtubule protein is changed from non-polymerising to polymerising conditions (e.g. by temperature jump or mixing with GTP) there is a series of structural transitions preceding microtubule growth. These have been detected by time-resolved X-ray scattering using synchrotron radiation, and they may be classified into pre-nucleation and nucleation events. X-ray patterns are good indicators for the average behavior of the particles in solution, but they are difficult to interpret unless additional information on their structure is available. We therefore studied the assembly process by electron microscopy under conditions approaching those of the X-ray experiment. There are two difficulties in the EM approach: One is that the particles important for assembly are usually small and not very regular and therefore tend to be overlooked. Secondly EM specimens require low concentrations which favor disassembly of the particles one wants to observe since there is a dynamic equilibrium between polymers and subunits.


Author(s):  
Eva-Maria Mandelkow ◽  
Ron Milligan

Microtubules form part of the cytoskeleton of eukaryotic cells. They are hollow libers of about 25 nm diameter made up of 13 protofilaments, each of which consists of a chain of heterodimers of α-and β-tubulin. Microtubules can be assembled in vitro at 37°C in the presence of GTP which is hydrolyzed during the reaction, and they are disassembled at 4°C. In contrast to most other polymers microtubules show the behavior of “dynamic instability”, i.e. they can switch between phases of growth and phases of shrinkage, even at an overall steady state [1]. In certain conditions an entire solution can be synchronized, leading to autonomous oscillations in the degree of assembly which can be observed by X-ray scattering (Fig. 1), light scattering, or electron microscopy [2-5]. In addition such solutions are capable of generating spontaneous spatial patterns [6].In an earlier study we have analyzed the structure of microtubules and their cold-induced disassembly by cryo-EM [7]. One result was that disassembly takes place by loss of protofilament fragments (tubulin oligomers) which fray apart at the microtubule ends. We also looked at microtubule oscillations by time-resolved X-ray scattering and proposed a reaction scheme [4] which involves a cyclic interconversion of tubulin, microtubules, and oligomers (Fig. 2). The present study was undertaken to answer two questions: (a) What is the nature of the oscillations as seen by time-resolved cryo-EM? (b) Do microtubules disassemble by fraying protofilament fragments during oscillations at 37°C?


1992 ◽  
Vol 2 (6) ◽  
pp. 899-913 ◽  
Author(s):  
Patrick Davidson ◽  
Elisabeth Dubois-Violette ◽  
Anne-Marie Levelut ◽  
Brigitte Pansu

1996 ◽  
Vol 6 (8) ◽  
pp. 1085-1094 ◽  
Author(s):  
A. Gibaud ◽  
J. Wang ◽  
M. Tolan ◽  
G. Vignaud ◽  
S. K. Sinha

Sign in / Sign up

Export Citation Format

Share Document