Analytical transmission electron microscopy of thin films

1975 ◽  
Vol 12 (1) ◽  
pp. 140-143 ◽  
Author(s):  
R. H. Geiss ◽  
T. C. Huang
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Analytical Transmission Electron Microscopy ◽  
Transmission Electron

Microstructural evolution during pyrolysis of triol-based sol-gel single-layer Pb(Zr0.53Ti0.47)O3 thin films

2002 ◽  
Vol 17 (8) ◽  
pp. 2066-2074 ◽  
Author(s):  
Zhaoxia Zhou ◽  
Ian M. Reaney ◽  
David Hind ◽  
Steven J. Milne ◽  
Andy P. Brown ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Microstructural Evolution ◽  
Sol Gel ◽  
Pyrochlore Phase ◽  
Single Layer ◽  
Face Centered Cubic ◽  
Analytical Transmission Electron Microscopy ◽  
Transmission Electron

Advanced analytical transmission electron microscopy has been used to investigate microstructural evolution during pyrolysis in triol-based sol-gel thin films. At pyrolysis temperatures up to 300 °C, the films remained amorphous; however, nanometer-sized precipitates were observed in films heat-treated up to 400 °C for 10 min. Analytical transmission electron microscopy indicated that the precipitates were Pb-rich, as well as deficient in O, Ti, and Zr. Films pyrolyzed up to 500 °C for 10 min were composed of a nanocrystalline pyrochlore phase; however, pores could be observed, situated in the same position as the nanometer-sized precipitates at 400 °C. Face-centered cubic Pb-rich crystallites were also present on the surface of pyrolyzed films but absent in the fully crystallized films annealed at 650 °C. A tentative mechanism is proposed to explain these observations.

Transmission Electron Microscopy studies of texture of Cr underlayer of magnetic recording hard disk

1991 ◽  
Vol 49 ◽  
pp. 580-581
Author(s):  
L. Tang ◽  
G. Thomas ◽  
M. R. Khan ◽  
S. L. Duan
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Magnetic Recording ◽  
Magnetic Thin Films ◽  
Magnetic Films ◽  
Substrate Bias ◽  
Epitaxial Relationship ◽  
Transmission Electron

Cr thin films are often used as underlayers for Co alloy magnetic thin films, such as Co1, CoNi2, and CoNiCr3, for high density longitudinal magnetic recording. It is belived that the role of the Cr underlayer is to control the growth and texture of the Co alloy magnetic thin films, and, then, to increase the in plane coercivity of the films. Although many epitaxial relationship between the Cr underlayer and the magnetic films, such as ﹛1010﹜Co/ {110﹜Cr4, ﹛2110﹜Co/ ﹛001﹜Cr5, ﹛0002﹜Co/﹛110﹜Cr6, have been suggested and appear to be related to the Cr thickness, the texture of the Cr underlayer itself is still not understood very well. In this study, the texture of a 2000 Å thick Cr underlayer on Nip/Al substrate for thin films of (Co75Ni25)1-xTix dc-sputtered with - 200 V substrate bias is investigated by electron microscopy.

Transmission Electron Microscopy of Evaporated Perylene Thin Films

1990 ◽  
Vol 48 (2) ◽  
pp. 336-337
Author(s):  
C. Ewins ◽  
J.R. Fryer
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Molecular Electronics ◽  
High Vacuum ◽  
Amorphous Layer ◽  
Electric Heater ◽  
Transmission Electron ◽  
Polycyclic Aromatic

The preparation of thin films of organic molecules is currently receiving much attention because of the need to produce good quality thin films for molecular electronics. We have produced thin films of the polycyclic aromatic, perylene C10H12 by evaporation under high vacuum onto a potassium chloride (KCl) substrate. The role of substrate temperature in determining the morphology and crystallography of the films was then investigated by transmission electron microscopy (TEM).The substrate studied was the (001) face of a freshly cleaved crystal of KCl. The temperature of the KCl was controlled by an electric heater or a cold finger. The KCl was heated to 200°C under a vacuum of 10-6 torr and allowed to cool to the desired temperature. The perylene was then evaporated over a period of one minute from a molybdenum boat at a distance of 10cm from the KCl. The perylene thin film was then backed with an amorphous layer of carbon and floated onto copper microscope grids.

Epitaxy and texture analysis of Bi-Sr-Ca-Cu-O thin films on (100) MgO using Transmission Electron Microscopy

1990 ◽  
Vol 48 (4) ◽  
pp. 68-69
Author(s):  
J. T. Sizemore ◽  
D. G. Schlom ◽  
Z. J. Chen ◽  
J. N. Eckstein ◽  
I. Bozovic ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Critical Currents ◽  
Unit Cell ◽  
X Ray Diffraction ◽  
Cell Axis ◽  
Transmission Electron ◽  
Synthesis Procedure

Investigators observe large critical currents for superconducting thin films deposited epitaxially on single crystal substrates. The orientation of these films is often characterized by specifying the unit cell axis that is perpendicular to the substrate. This omits specifying the orientation of the other unit cell axes and grain boundary angles between grains of the thin film. Misorientation between grains of YBa2Cu3O7−δ decreases the critical current, even in those films that are c axis oriented. We presume that these results are similar for bismuth based superconductors and report the epitaxial orientations and textures observed in such films.Thin films of nominally Bi2Sr2CaCu2Ox were deposited on MgO using molecular beam epitaxy (MBE). These films were in situ grown (during growth oxygen was incorporated and the films were not oxygen post-annealed) and shuttering was used to encourage c axis growth. Other papers report the details of the synthesis procedure. The films were characterized using x-ray diffraction (XRD) and transmission electron microscopy (TEM).

Characterization of submicrometer fluid Inclusions in minerals by Analytical/Transmission Electron Microscopy and electron diffraction

1990 ◽  
Vol 48 (4) ◽  
pp. 424-424
Author(s):  
George Guthrie ◽  
David Veblen
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Electron Microscope ◽  
Electron Diffraction ◽  
Light Microscopy ◽  
Fluid Inclusions ◽  
Energy Dispersive Spectrometer ◽  
Analytical Transmission Electron Microscopy ◽  
Transmission Electron

The nature of a geologic fluid can often be inferred from fluid-filled cavities (generally <100 μm in size) that are trapped during the growth of a mineral. A variety of techniques enables the fluids and daughter crystals (any solid precipitated from the trapped fluid) to be identified from cavities greater than a few micrometers. Many minerals, however, contain fluid inclusions smaller than a micrometer. Though inclusions this small are difficult or impossible to study by conventional techniques, they are ideally suited for study by analytical/ transmission electron microscopy (A/TEM) and electron diffraction. We have used this technique to study fluid inclusions and daughter crystals in diamond and feldspar.Inclusion-rich samples of diamond and feldspar were ion-thinned to electron transparency and examined with a Philips 420T electron microscope (120 keV) equipped with an EDAX beryllium-windowed energy dispersive spectrometer. Thin edges of the sample were perforated in areas that appeared in light microscopy to be populated densely with inclusions. In a few cases, the perforations were bound polygonal sides to which crystals (structurally and compositionally different from the host mineral) were attached (Figure 1).

Sign in / Sign up

Export Citation Format

Share Document