Analyzing Temperature Changes in Powered LEDs by Combining Thermal and Radiometric Characterization With Computational Fluid Dynamics

2015 ◽  
Author(s):  
Boris Marovic ◽  
Mathew Clark ◽  
James Petroski
Keyword(s):  
Fluid Dynamics ◽  
Computational Fluid Dynamics ◽  
Thermal Simulation ◽  
Temperature Changes ◽  
Measurement Results ◽  
Improved Accuracy ◽  
Led Luminaire

This paper describes the workflow and improved accuracy of a combined characterization and simulation of an LED luminaire. The achieved measurement results of the thermal and radiometric characterization, the process of implementing these results into a thermal simulation, and the benefit for the luminaire designer are presented.

scholarly journals Feasibility Evaluation of Computational Fluid Dynamics Approach for Inhalation Exposure Assessment: Case Study for Biocide Spray

2021 ◽  
Vol 11 (2) ◽  
pp. 634
Author(s):  
Donggeun Park ◽  
Jong-Hyeon Lee
Keyword(s):  
Fluid Dynamics ◽  
Computational Fluid Dynamics ◽  
Stokes Equations ◽  
Near Field ◽  
Inhalation Exposure ◽  
Consumer Products ◽  
Exposure Concentration ◽  
Experimental Conditions ◽  
Measured Concentration ◽  
Measurement Results

Consumer products contain chemical substances that threaten human health. The zero-dimensional modeling methods and experimental methods have been used to estimate the inhalation exposure concentration of consumer products. The model and measurement methods have a spatial property problem and time/cost-consuming problem, respectively. For solving the problems due to the conventional methodology, this study investigated the feasibility of applying computational fluid dynamics (CFD) for the evaluation of inhalation exposure by comparing the experiment results and the zero-dimensional results with CFD results. To calculate the aerosol concentration, the CFD was performed by combined the 3D Reynolds averaged Navier–Stokes equations and a discrete phased model using ANSYS FLUENT. As a result of comparing the three methodologies performed under the same simulation/experimental conditions, we found that the zero-dimensional spray model shows an approximately five times underestimated inhalation exposure concentration when compared with the CFD results and measurement results in near field. Additionally, the results of the measured concentration of aerosols at five locations and the CFD results at the same location were compared to show the possibility of evaluating inhalation exposure at various locations using CFD instead of the experimental method. The CFD results according to measurement positions can rationally predict the measurement results with low error. In conclusion, in the field of exposure science, a guideline for exposure evaluation using CFD, was found that complements the shortcomings of the conventional methodology, the zero-dimensional spray model and measurement method.

Sign in / Sign up

Export Citation Format

Share Document