PIV Measurements of Jet Flow Mixing in the Vicinity of Rod Bundles Using Matched-Index of Refraction

2008 ◽  
Author(s):  
Noushin Amini ◽  
Elvis E. Dominguez-Ontiveros ◽  
Carlos E. Estrada-Perez ◽  
Stephen D. Fortenberry ◽  
Yassin A. Hassan
Keyword(s):  
Particle Image ◽  
Flow Characteristics ◽  
Impinging Jets ◽  
Index Of Refraction ◽  
Velocity Measurements ◽  
Rod Bundles ◽  
Piv Measurements ◽  
Rod Bundle ◽  
Flow Mixing ◽  
Image Velocimetry

In this study, the velocity field of impinging jets within a rod bundle was developed. Velocity measurements were accomplished using Particle Image Velocimetry (PIV). Additionally, Matched-Index of Refraction (MIR) techniques were implemented to allow the visualization of flow characteristics within interior areas of the rod bundle which would typically be obstructed. Such measurements are of importance and essential to the development of new models to predict the systems’ hydraulic behavior.

A Versatile Fully Submersible Stereo-PIV Probe for Tow Tank Applications

2003 ◽  
Author(s):  
Francisco Pereira ◽  
Tiziano Costa ◽  
Mario Felli ◽  
Guido Calcagno ◽  
Fabio Di Felice
Keyword(s):  
Particle Image ◽  
Water Channel ◽  
Three Dimensional ◽  
Stereoscopic Particle Image Velocimetry ◽  
Velocity Measurements ◽  
Piv Measurements ◽  
Circulating Water ◽  
Image Velocimetry ◽  
Out Of Plane ◽  
Yaw Angle

A unique, highly modular and flexible underwater system for stereoscopic particle image velocimetry (PIV) measurements has been designed, manufactured and tested. The instrument is intended for planar three-dimensional velocity measurements in large facilities such as water tow tanks and tunnels. The performance of the system is assessed in four major stereoscopic configurations. Errors under 2% for the in-plane components and 4% for the out-of-plane components are found. The system is tested in the INSEAN large circulating water channel where the measurement of the flow around a model ship oriented at a moderate yaw angle is performed and puts into evidence the main features of the flow.

Experimental Study of Jet Flow Impingement Within a Rod Bundle Using PIV Technique

2008 ◽  
Author(s):  
Noushin Amini ◽  
Yassin A. Hassan
Keyword(s):  
Particle Image ◽  
Rectangular Channel ◽  
Flow Characteristics ◽  
Reynolds Numbers ◽  
Reynolds Stresses ◽  
Particle Image Velocimetry Technique ◽  
Time Resolved ◽  
Rod Bundle ◽  
Piv Technique ◽  
Image Velocimetry

In this investigation Particle Image Velocimetry technique was implemented to a matched refractive index facility which was placed in a rectangular channel of L:1016 mm×W:76.2 mm×H:76.2 mm. Water was pumped into either one or both of the inlet jets which were entering the channel’s top wall with several different Reynolds numbers. The instantaneous and time-resolved velocity fields were successfully obtained from which several flow characteristics such as vorticity, turbulence instabilities and Reynolds stresses can be calculated.

Flow Characteristics of Pressure-Driven Water in Serpentine Micro-Channels

2006 ◽  
Author(s):  
Renqiang Xiong ◽  
J. N. Chung
Keyword(s):  
Particle Image Velocimetry ◽  
Particle Image ◽  
Flow Characteristics ◽  
Flow Structures ◽  
Micro Channel ◽  
Pressure Drops ◽  
Micro Particle Image Velocimetry ◽  
Image Velocimetry ◽  
Micro Channels ◽  
Shape And Size

Flow structures and pressure drops were investigated in rectangular serpentine micro-channels with miter bends which had hydraulic diameters of 0.209mm, 0.395mm and 0.549mm respectively. To evaluate the bend effect, the additional pressure drop due to the miter bend must be obtained. Three groups of micro-channels were fabricated to remove the inlet and outlet losses. A validated micro-particle image velocimetry (μPIV) system was used to achieve the flow structure in a serpentine micro-channel with hydraulic diameter of 0.173mm. The experimental results show the vortices around the outer and inner walls of the bend do not form when Re<100. Those vortices appear and continue to develop with the Re number when Re> 100-300, and the shape and size of the vortices almost remain constant when Re>1000. The bend loss coefficient Kb was observed to be related with the Re number when Re<100, with the Re number and channel size when Re>100. It almost keeps constant and changes in the range of ± 10% When Re is larger than some value in 1300-1500. And a size effect on Kb was also observed.

A particle image velocimetry study on the pulsatile flow characteristics in straight tubes with an asymmetric bulge

2000 ◽  
Vol 214 (5) ◽  
pp. 655-671 ◽  
Author(s):  
S C M Yu ◽  
J B Zhao
Keyword(s):  
Particle Image Velocimetry ◽  
Steady Flow ◽  
Pulsatile Flow ◽  
Flow Condition ◽  
Particle Image ◽  
Flow Characteristics ◽  
Reynolds Numbers ◽  
Working Fluid ◽  
Flow Conditions ◽  
Image Velocimetry

Flow characteristics in straight tubes with an asymmetric bulge have been investigated using particle image velocimetry (PIV) over a range of Reynolds numbers from 600 to 1200 and at a Womersley number of 22. A mixture of glycerine and water (approximately 40:60 by volume) was used as the working fluid. The study was carried out because of their relevance in some aspects of physiological flows, such as arterial flow through a sidewall aneurysm. Results for both steady and pulsatile flow conditions were obtained. It was found that at a steady flow condition, a weak recirculating vortex formed inside the bulge. The recirculation became stronger at higher Reynolds numbers but weaker at larger bulge sizes. The centre of the vortex was located close to the distal neck. At pulsatile flow conditions, the vortex appeared and disappeared at different phases of the cycle, and the sequence was only punctuated by strong forward flow behaviour (near the peak flow condition). In particular, strong flow interactions between the parent tube and the bulge were observed during the deceleration phase. Stents and springs were used to dampen the flow movement inside the bulge. It was found that the recirculation vortex could be eliminated completely in steady flow conditions using both devices. However, under pulsatile flow conditions, flow velocities inside the bulge could not be suppressed completely by both devices, but could be reduced by more than 80 per cent.

Large Eddy Simulations of Jet Flow Interaction Within Staggered Rod Bundles

2010 ◽  
Author(s):  
Nathaniel Salpeter ◽  
Yassin Hassan
Keyword(s):  
Wavelet Transforms ◽  
Gas Flow ◽  
Jet Flow ◽  
Sensitivity Study ◽  
Impinging Jets ◽  
Large Eddy Simulations ◽  
Rod Bundle ◽  
Flow Mixing ◽  
Large Eddy ◽  
Turbulent Jet Flow

The present work investigates the turbulent jet flow mixing of downward impinging jets within a staggered rod bundle based on previous experimental work. Two inlet jets had Reynold’s numbers of 11,160 and 6,250 and were chosen to coincide with available data [Amini and Hassan 2009]. Steady state simulations were initially carried out on a semi-structured polyhedral mesh of roughly 13.2 million cells following a sensitivity study over six different discretized meshes. Very large eddy simulations were carried out over the most refined mesh and continuous 1D wavelet transforms were used to analyze the dominant instabilities and how they propagate through the system in an effort to provide some insight into potential problems relating to structural vibrations due to turbulent instabilities. The presence of strong standing horseshoe vorticies near the base of each cylinder adjacent to an inlet jet was noted and is of potential importance in the abrasion wear of the graphite support columns of the VHTR if sufficient wear particles are present in the gas flow.

PIV Measurements Within the Waves of Wavy and Wavy-Annular Horizontal Two-Phase Flow

2005 ◽  
Author(s):  
R. E. Foster ◽  
T. A. Shedd
Keyword(s):  
Particle Image ◽  
Image Processing Algorithm ◽  
Two Phase ◽  
Piv Measurements ◽  
Post Process ◽  
Image Velocimetry ◽  
Processed Form ◽  
Image Pairs ◽  
Particle Images ◽  
The Waves

A novel technique of microscopic Particle Image Velocimetry (PIV) is presented for two-phase annular, wavy-annular and stratified flow. Seeding of opaque particles in a water/dye flow allows the acquisition of instantaneous film velocity data in the film cross-section at the center of the tube in the form of digital image pairs. An image processing algorithm is also described that allows numerical velocities to be distilled from particle images by commercial PIV software. The approach yields promising results for stratified and wavy-annular flows, however highly bubbly flows remain difficult to image and post-process. Initial data images are presented in raw and processed form.

Time-Resolved Particle Image Velocimetry (PIV) Measurements in a Radial Diffuser Pump

2009 ◽  
Author(s):  
Jianjun Feng ◽  
Friedrich-Karl Benra ◽  
Hans Josef Dohmen
Keyword(s):  
Particle Image Velocimetry ◽  
Particle Image ◽  
Time Resolved ◽  
Piv Measurements ◽  
Part Load ◽  
Channel Characteristic ◽  
Image Velocimetry ◽  
Pump Stage ◽  
Low Specific Speed ◽  
Load Conditions

The truly time-variant unsteady flow in a low specific speed radial diffuser pump stage has been investigated by time-resolved Particle Image Velocimetry (PIV) measurements. The measurements are conducted at the midspan of the blades for the design condition and also for some severe part-load conditions. The instantaneous flow fields among different impeller channels are analyzed and compared in detail, and more attention has been paid to flow separations at part-load conditions. The analysis of the measured results shows that the flow separations at two adjacent impeller channels are quite different at some part-load conditions. The separations generally exhibit a two-channel characteristic.

Sign in / Sign up

Export Citation Format

Share Document