Improved Correlations for Counting the Effect of Natural Convection on Laminar Flow of Nanofluids

Author(s):  
Si-pu Guo ◽  
Zhao-zan Feng ◽  
Ze-cong Fang ◽  
Wei Li ◽  
Jin-liang Xu ◽  
...  

Nanofluids are colloidal suspensions of nano-scale particles in water, or other base fluids. In this paper, the effect of natural convection on laminar flow of nanofluids in a horizontal tube has been addressed. The obtained experimental data could not be reconciled with existing correlations over a wide range of Prandtl number under laminar mixed convection. Three improved correlations have been derived by using single-phase fluid approach. These correlations fit our data to within ± 10 % and also agree with the data in literature quite well. Such results verify that nanofluids can be treated as a homogeneous mixture with effective thermophysical properties. Utimately, the new correlations have grasped the essence of natural convection and can reduce to both normal forced convection and pure natural convection equations at limiting cases.

Author(s):  
Wei Li ◽  
Si-Pu Guo ◽  
Zhao-Zan Feng ◽  
Zhao-Yan Zhang ◽  
Ze-Cong Fang

This paper describes an experimental investigation into combined forced and natural convection heat transfer for large-Prandtl-number nanofluids flow in a horizontal tube at low Reynolds number (9 < Re < 450). By the inclusion of nanoparticles, the contribution of natural convection to the overall convective heat transfer can be either deteriorated under the same heat flux or enhanced under a given Grashof number. The huge increasing of the viscosity and Prandtl number were turned out to be the major reason for the observed deterioration and enhancement, respectively. Moreover, the measured heat transfer behavior of nanofluids was illustrated to be in good agreement with the single-phase-based evaluation. However, the experimental data obtained could not be totally reconciled with existing correlations, which relate mainly to specific pure liquids or relatively higher Reynolds number. Therefore, new correlations have been derived by using single-phase fluid approach. These correlations fit our data to within ± 10 percent and also agree with the data in literature quite well. Such results verify that nanofluids can be treated as a homogeneous mixture with effective thermophysical properties. In addition, the new correlations grasp the essence of natural convection and can reduce to both normal forced convection and pure natural convection equations at limiting cases. Whether a flow can be treated as pure forced flow or not (i.e., natural convection effects cannot be neglected) is a crucial problem remains to be determined for the assessment of performance of nanofluids in low-Reynolds-number convection heat transfer application. Generally, the boundary curve function involves the variable parameter of forced main flow (Graetz number) and natural secondary flow (Rayleigh number), constituting a criterion suitable for defining transition of forced flow to mixed flow.


1967 ◽  
Vol 30 (2) ◽  
pp. 337-355 ◽  
Author(s):  
Peter D. Richardson

An analysis is described for convection from a circular cylinder subjected to transverse oscillations relative to the fluid in which it is immersed. The analysis is based upon use of the acoustic streaming flow field. It is assumed that the frequency involved is sufficiently small that the acoustic wavelength in the fluid is much larger than the cylinder diameter, and that there is no externally imposed mean flow across or along the cylinder. Solutions are presented which are appropriate for a wide range of Prandtl number, and the cases of small and of large streaming Reynolds number are distinguished. The analysis compares favourably with experiments when the influence of natural convection is small.


2005 ◽  
Vol 127 (4) ◽  
pp. 479-486
Author(s):  
Bin Liu ◽  
Mauricio Prado

For any pumping artificial lift system in the petroleum industry, the free gas significantly affects the performance of the pump and the system above the pump. A model, though not a complete two-phase flow model, has been developed for the effective prediction of separation efficiency across a wide range of production conditions. The model presented is divided into two main parts, the single-phase flow-field solution and the bubble-tracking method. The first part of the model solves the single-phase liquid flow field using the computational fluid dynamics approach. Then, a simple bubble-tracking method was applied to estimate the down-hole natural separation efficiency for two-phase flow. A comparison between the results of the model and the experimental data was conducted. It shows a very good agreement with the experimental data for lower gas void fractions (bubble flow regime).


Author(s):  
Christian Weinmu¨ller ◽  
Dimos Poulikakos

Microfluidics has experienced a significant increase in research activities in recent years with a wide range of applications emerging, such as micro heat exchangers, energy conversion devices, microreactors, lab-on-chip devices and micro total chemical analysis systems (μTAS). Efforts to enhance or extend the performance of single phase microfluidic devices are met by two-phase flow systems [1, 2]. Essential for the design and control of microfluidic systems is the understanding of the fluid/hydrodynamic behavior, especially pressure drop correlations. These are well established for single phase flow, however, analytical correlations for two-phase flow only reflect experimentally obtained values within an accuracy of ± 50% [3, 4]. The present study illustrates the effect of two-phase flow regimes on the pressure drop. Experimental measurement data is put into relation of calculated values based on established correlations of Lockhart-Martinelli with Chisholm modifications for macroscopic flows [5, 6] and Mishima-Hibiki modifications for microscale flows [7]. Further, the experimental pressure drop data is superimposed onto two-phase flow maps to identify apparent correlations of pressure drop abnormalities and flow regimes. The experiments were conducted in a square microchannel with a width of 200 μm. Optical access is guaranteed by an anodically bonded glass plate on a MEMS fabricated silicon chip. Superficial velocities range from 0.01 m/s to 1 m/s for the gas flow and from 0.0001 m/s to 1 m/s for the liquid flow with water as liquid feed and CO2 as gas. The analysis of the flow regimes was performed by imaging the distinct flow regimes by laser induced fluorescence microscopy, employing Rhodamine B as the photosensitive dye. The pressure drop was synchronically recorded with a 200 mbar, 2.5 bar and 25 bar differential pressure transmitter and the data was exported via a LabView based software environment, see Figure 1. Figure 2 illustrates the experimentally obtained pressure drop in comparison to the calculated values based on the Lockhard-Martinelli correlation with the Chisholm modification and the Mishima-Hibiki modification. For both cases the predications underestimate the two-phase pressure drop by more than 50%. Nevertheless, the regression of the experimental data has an offset of linear nature. Two-phase flow is assigned to flow regime maps of bubbly, wedging, slug or annular flow defined by superficial gas and liquid velocities. In Figure 3 the pressure drop is plotted as a surface over the corresponding flow regime map. Transition lines indicate a change of flow regimes enclosing an area of an anticline in the pressure data. In the direct comparison between the calculated and the measured values, the two surfaces show a distinct deviation. Especially, the anticline of the experimental data is not explained by the analytical correlations. Figure 4 depicts the findings of Figure 3 at a constant superficial velocity of 0.0232 m/s. The dominant influence of the flow regimes on the pressure drop becomes apparent, especially in the wedging flow regime. The evident deviation of two-phase flow correlations for the pressure drop is based on omitting the influence of the flow regimes. In conclusion, the study reveals a strong divergence of pressure drop measurements in microscale two-phase flow from established correlations of Lockhart-Martinelli and recognized modifications. In reference to [8, 9], an analytical model incorporating the flow regimes and, hence, predicting the precise pressure drop would be of great benefit for hydrodynamic considerations in microfluidics.


Author(s):  
K. Venkatadri ◽  
S. Abdul Gaffar ◽  
Ramachandra Prasad V. ◽  
B. Md. Hidayathulla Khan ◽  
O. Anwar Beg

Natural convection within trapezoidal enclosures finds significant practical applications. The natural convection flows play a prominent role in the transport of energy in energyrelated applications, in case of proper design of enclosures to achieve higher heat transfer rates. In the present study, a two-dimensional cavity with adiabatic right side wall is studied. The left side vertical wall is maintained at the constant hot temperature and the top slat wall is maintained at cold temperature. The dimensionless governing partial differential equations for vorticity-stream function are solved using the finite difference method with incremental time steps. The parametric study involves a wide range of Rayleigh number, Ra, 103 ≤ Ra ≤ 105 and Prandtl number (Pr = 0.025, 0.71 and 10). The fluid flow within the enclosure is formed with different shapes for different Pr values. The flow rate is increased by enhancing the Rayleigh number (Ra = 104 ). The numerical results are validated with previous results. The governing parameters in the present article, namely Rayleigh number and Prandtl number on flow patterns, isotherms as well as local Nusselt number are reported. 


2021 ◽  
Vol 39 (2) ◽  
pp. 390-402
Author(s):  
Yanán Camaraza-Medina

This paper presents the main results of the research developed by the author in his postdoctoral investigations on heat transfer calculations during film condensation inside tubes. The elements studied are combined in an analysis expression that provides a reasonable fit with the available experimental data, which includes a total of 22 fluids, including water, refrigerants and a wide range of organic substances, which condense inside horizontal, inclined and vertical tubes. These experimental data were obtained from the reports of 33 sources. Available data covers tube diameters from 2 to 50 mm, mass flow rates from 3 to 850 kg/(m2s), reduced pressures ranging from 0.0008 to 0.91, values for single-phase from 1 to , Reynolds number for two-phase from 900 to 594390, Reynolds number for single-phase from 65 to 84950 and vapor quality from 0.01 to 0.99. The mean deviation found for the analyzed data for horizontal tubes was 13.4%, while for the inclined and vertical tubes data the mean deviation was 14.9%. In all cases, the agreement of the proposed model is good enough to be considered satisfactory for practical design.


Author(s):  
Adriana Greco ◽  
Rita Mastrullo ◽  
Alfonso W. Mauro ◽  
Giuseppe P. Vanoli

A 962 points database for refrigerants two-phase flows by Greco A. and Vanoli G.P. was statistically compared to four widely used prediction methods by Lockhart and Martinelli, Chawla, Theissing and Mu¨ller-Steinhagen and Heck in order to determine the best one. The experimental points are in a wide range of operating conditions for six pure or mixed refrigerants (R134a, R22, R407C, R507A, R410A and R404A) during evaporation in a smooth horizontal tube of 6 m length and 6 mm ID.


2011 ◽  
Vol 133 (11) ◽  
Author(s):  
Eiyad Abu-Nada

Dissipative particle dynamics with energy conservation (eDPD) was used to study natural convection in liquid domain over a wide range of Rayleigh Numbers. The problem selected for this study was the Rayleigh–Bénard convection problem. The Prandtl number used resembles water where the Prandtl number is set to Pr = 6.57. The eDPD results were compared to the finite volume solutions, and it was found that the eDPD method calculates the temperature and flow fields throughout the natural convection domains correctly. The eDPD model recovered the basic features of natural convection, such as development of plumes, development of thermal boundary layers, and development of natural convection circulation cells (rolls). The eDPD results were presented by means of temperature isotherms, streamlines, velocity contours, velocity vector plots, and temperature and velocity profiles.


Author(s):  
E. Natarajan ◽  
Tanmay Basak ◽  
S. Roy

The present numerical study deals with natural convection flow in a trapezoidal cavity when the bottom wall is uniformly heated and the vertical wall(s) are linearly heated and cooled whereas the top wall is well insulated. Nonlinear coupled partial differential equations governing the flow have been solved by penalty finite element method with bi-quadratic rectangular elements. Parametric study for the wide range of Rayleigh number (Ra), 103 ≤ Ra ≤ 105 and Prandtl number (Pr), 0.07 ≤ Pr ≤ 100 shows consistent performance of the present numerical approach to obtain the solutions in terms of stream functions and the temperature profiles. For linearly heated side walls symmetry is observed while representing the flow patterns in terms of stream functions whereas secondary circulation is observed for the linearly heated left wall and cooled right wall. Local Nusselt number becomes negative at the side wall for linearly heated side walls and at the left wall for linearly heated left wall and cooled right wall indicating the reversal of heat flow. The effect of Prandtl number in the variation of average Nusselt numbers is more significant for Prandtl numbers in the range 0.07 to 0.7 than 10 to 100.


1996 ◽  
Vol 329 ◽  
pp. 373-388 ◽  
Author(s):  
Hiroshi Ishigaki

When a curved pipe rotates about the centre of curvature, the fluid flowing in it is subjected to both Coriolis and centrifugal forces. Based on the analogy between laminar flows in stationary curved pipes and in orthogonally rotating pipes, the flow characteristics of fully developed laminar flow in rotating curved pipes are made clear and definite by similarity arguments, computational studies and using experimental data. Similarity arguments clarify that the flow characteristics in loosely coiled rotating pipes are governed by three parameters: the Dean number KLC, a body force ratio F and the Rossby number Ro. As the effect of Ro is negligible when Ro is large, computational results are presented for this case first, and then the effect of Ro is studied. Flow structure and friction factor are studied in detail. Variations of flow structure show secondary flow reversal at F ≈ −1, where the two body forces are of the same order but in opposite directions. It is also shown how the Taylor–Proudman effect dominates the flow structure when Ro is small. Computed curves of the friction factor for constant Dean number have their minimum at F ≈ −1. A composite parameter KL is introduced as a convenient governing parameter and used to correlate the characteristics. By applying KL to the analogy formula previously derived for two limiting flows, a semi-empirical formula for the friction factor is presented, which shows good agreement with the experimental data for a wide range of the parameters.


Sign in / Sign up

Export Citation Format

Share Document