Experimental Investigation and Empirical Analysis of Non-Boiling Gas-Liquid Two Phase Heat Transfer in Vertical Downward Pipe Orientation

2012 ◽  
Author(s):  
Swanand M. Bhagwat ◽  
Mehmet Mollamahmutoglu ◽  
Afshin J. Ghajar
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Annular Flow ◽  
Single Phase ◽  
Phase Flow ◽  
Upward Flow ◽  
Two Phase ◽  
Reynolds Analogy ◽  
Two Phase Heat Transfer

The non-boiling gas-liquid two phase flow is pertinent to industrial applications like the reduction of paraffin wax depositions in petroleum transport lines, air lift systems and the chemical processes such as ethanol-water fractionation seeking enhanced heat and mass transfer. The non-boiling two phase heat transfer mechanism in horizontal and vertical orientations has been investigated by many researchers. However, till date very little experimental work and investigation has been performed for vertical downward flow. In order to contribute more to this research and have a better understanding of the non-boiling two phase heat transfer phenomenon for this pipe orientation, experimental investigation is undertaken for a vertical downward oriented 0.01252 m I.D. schedule 10 S stainless steel pipe using air-water as fluid combination. The influence of different flow patterns on the two phase convective heat transfer coefficient is studied using experimental measurements of 165 data points for bubbly, slug, froth, falling film and annular flow patterns spanned over the entire range of the void fraction. In general the two phase heat transfer coefficients are found to be consistently higher than that of the single phase flow. This tendency is observed to increase with increase in the gas flow rate as the flow regime migrates from bubbly to the annular flow. The concept of Reynolds analogy as implemented by Tang and Ghajar [1] for horizontal and vertical upward flow is analyzed against the vertical downward flow data collected in the present study. Due to lack of correlations available for predicting the two phase heat transfer coefficient in vertical downward orientation it was decided to perform the quantitative analysis of the seventeen two phase heat transfer correlations available for vertical upward flow. This analysis is concluded by the recommendation of the top performing correlations in the literature for each flow pattern. Based on the pressure drop data and using Reynolds analogy, a simple equation is proposed to correlate the two phase heat transfer coefficient with the single phase heat transfer coefficient.

On the Application of Macro-Pipe Two-Phase Heat Transfer Correlations and Flow Regime Maps to Mini-Channels

2006 ◽  
Author(s):  
Avram Bar-Cohen ◽  
Ilai Sher ◽  
Emil Rahim
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Flow Regime ◽  
Annular Flow ◽  
Negative Slope ◽  
Two Phase ◽  
Heat Transfer Correlations ◽  
Two Phase Heat Transfer ◽  
Flow Regime Maps

The present study is aimed at evaluating the ability of conventional “macro-pipe” correlations and regime transitions to predict the two-phase thermofluid characteristics of mini-channel cold plates. Use is made of the Taitel-Dukler flow regime maps, seven classical heat transfer coefficient correlations and two dryout predictions. The vast majority of the mini-channel two-phase heat-transfer data, taken from the literature, is predicted to fall in the annular regime, in agreement with the reported observations. A characteristic heat transfer coefficient locus has been identified, with a positive slope following the transition from Intermittent to Annular flow and a negative slope following the onset of partial dryout at higher qualities. While the classical two-phase heat transfer correlations are generally capable of providing good agreement with the low-quality annular flow data the quality at which partial dryout occurs and the ensuing heat transfer rates are not predictable by the available macro-pipe correlations.

Two-Phase Heat Transfer Performance of Dielectric Fluid HFE-7100 Within Multiport Microchannel

2008 ◽  
Author(s):  
Lung-Yi Lin ◽  
Yeau-Ren Jeng ◽  
Chi-Chuan Wang
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Single Phase ◽  
Heat Transfer Performance ◽  
Convective Heat Transfer Coefficient ◽  
Dielectric Fluid ◽  
Transfer Performance ◽  
Two Phase ◽  
Two Phase Heat Transfer

This study presents convective single-phase and boiling two-phase heat transfer performance of HFE-7100 coolant within multi-port microchannel heat sinks. The corresponding hydraulic diameters are 450 and 237 μm, respectively. For single-phase results, the presence of inlet/outlet locations inevitably gives rise to considerable increase of total pressure drop of a multi-port microchannel heat sink whereas has virtually no detectable influence on overall heat transfer performance provided that the effect of entrance has been accounted for. The convective boiling heat transfer coefficient for the HFE-7100 coolant shows a tremendous drop when vapor quality is above 0.6. For Dh = 450 μm, it is found that the mass flux effect on the convective heat transfer coefficient is rather small.

A Natural Circulation Model of the Closed Loop, Two-Phase Thermosyphon for Electronics Cooling

2001 ◽  
Author(s):  
S. I. Haider ◽  
Yogendra K. Joshi ◽  
Wataru Nakayama
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Closed Loop ◽  
Two Phase Flow ◽  
Natural Circulation ◽  
Saturation Temperature ◽  
Electronics Cooling ◽  
Phase Flow ◽  
Two Phase

Abstract The study presents a model for the two-phase flow and heat transfer in the closed loop, two-phase thermosyphon (CLTPT) involving co-current natural circulation. Most available models deal with two-phase thermosyphons with counter-current circulation within a closed, vertical, wickless heat pipe. The present research focuses on CLTPTs for electronics cooling that face more complex two-phase flow patterns than the vertical heat pipes, due to closed loop geometry and smaller tube size. The present model is based on mass, momentum, and energy balances in the evaporator, rising tube, condenser, and the falling tube. The homogeneous two-phase flow model is used to evaluate the friction pressure drop of the two-phase flow imposed by the available gravitational head through the loop. The saturation temperature dictates both the chip temperature and the condenser heat rejection capacity. Thermodynamic constraints are applied to model the saturation temperature, which also depends upon the local heat transfer coefficient and the two-phase flow patterns inside the condenser. The boiling characteristics of the enhanced structure are used to predict the chip temperature. The model is compared with experimental data for dielectric working fluid PF-5060 and is in general agreement with the observed trends. The degradation of condensation heat transfer coefficient due to diminished vapor convective effects, and the presence of subcooled liquid in the condenser are expected to cause higher thermal resistance at low heat fluxes. The local condensation heat transfer coefficient is a major area of uncertainty.

Investigation of Two Phase Heat Transfer Coefficients of Cryogenic Mixed Refrigerants

2013 ◽  
Author(s):  
Seungwhan Baek ◽  
Sangkwon Jeong
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Heat Exchanger ◽  
Transfer Coefficient ◽  
Transfer Coefficients ◽  
Two Phase ◽  
Microchannel Heat Exchanger ◽  
Heat Transfer Coefficients ◽  
Evaporation Heat ◽  
Two Phase Heat Transfer

Mixed Refrigerant Joule Thomson (MR-JT) refrigerators are widely used in various kinds of cryogenic systems these days. Although heat transfer coefficient estimation for a multiphase and multi-component fluid in cryogenic temperature range is necessarily required in the heat exchanger design of MR-JT refrigerator, it has been rarely discussed so far. In this paper, condensation and evaporation heat transfer coefficients of mixed refrigerant are measured in a microchannel heat exchanger. Printed Circuit Heat Exchanger (PCHE) has been developed as a compact microchannel heat exchanger and used in the experiment. Several two-phase heat transfer coefficient correlations are examined to discuss the experimental measurement results. The result of this paper shows that cryogenic mixed refrigerant heat transfer coefficients can be estimated by conventional two-phase heat transfer coefficient correlations.

Sign in / Sign up

Export Citation Format

Share Document