Control Oriented Dynamic Modeling of a Tension-Leg Platform Based Floating Offshore Wind Turbine With Dynamic Vibration Absorbers

2018 ◽  
Author(s):  
Zhongyou Wu ◽  
Yaoyu Li
Keyword(s):  
Wind Turbine ◽  
Controller Design ◽  
Lagrange Equation ◽  
Offshore Wind ◽  
Offshore Wind Turbine ◽  
Tension Leg Platform ◽  
Floating Offshore Wind Turbine ◽  
Wind Turbine Tower ◽  
Lqr Controller ◽  
Load Increase

Due to platform motions, floating offshore wind turbine loads are increased. Among proposed platform concepts, tension leg platform introduces least wind turbine load increase. To reduce wind turbine loads, extra actuators have been added to the platform to suppress the tension leg platform motion. For these actuators controller design, it is critical to derive a mathematical model of the platform-wind turbine-actuator system. In this paper, a reduced 13 DOFs model is derived using Lagrange equation and validated with simulation results from FAST. This reduced model is simple, but accurate enough to predict wind turbine and platform response under wind and wave disturbance. Based on the proposed model, an LQR controller is designed. One simulation case shows that the wind turbine tower load can be effectively reduced by actively controlled DVAs.

Dynamic Modeling and Simulation of a Spar Floating Offshore Wind Turbine With Consideration of the Rotor Speed Variations

2019 ◽  
Vol 141 (8) ◽  
Author(s):  
Mohammed Khair Al-Solihat ◽  
Meyer Nahon ◽  
Kamran Behdinan
Keyword(s):  
System Dynamics ◽  
Wind Turbine ◽  
Torque Control ◽  
Offshore Wind ◽  
Offshore Wind Turbine ◽  
Aerodynamic Load ◽  
Floating Platform ◽  
Dynamic Simulations ◽  
Floating Offshore Wind Turbine ◽  
Wind Turbine Tower

This paper presents a rigid multibody dynamic model to simulate the dynamic response of a spar floating offshore wind turbine (FOWT). The system consists of a spar floating platform, the moorings, the wind turbine tower, nacelle, and the rotor. The spar platform is modeled as a six degrees-of-freedom (6DOFs) rigid body subject to buoyancy, hydrodynamic and moorings loads. The wind turbine tower supports rigid nacelle and rotor at the tip. The rigid rotor is modeled as a disk spinning around its axis and subject to the aerodynamic load. The generator torque control law is incorporated into the system dynamics to capture the rotor spinning speed response when the turbine is operating below the rated wind speed. The equations of motions are derived using Lagrange's equation in terms of the platform quasi-coordinates and rotor spin speed. The external loads due to hydrostatics, hydrodynamics, and aerodynamics are formulated and incorporated into the equations of motion. The dynamic simulations of the spar FOWT are performed for three load cases to examine the system eigen frequencies, free decay response, and response to a combined wave and wind load. The results obtained from the present model are validated against their counterparts obtained from other simulation tools, namely, FAST, HAWC2, and Bladed, with excellent agreement. Finally, the influence of the rotor gyroscopic moment on the system dynamics is investigated.

Coupled Dynamic Analysis of a Tension Leg Platform Floating Offshore Wind Turbine

2019 ◽  
Vol 142 (1) ◽  
Author(s):  
Teng Wang ◽  
Hui Jin ◽  
Xiaoni Wu
Keyword(s):  
Dynamic Analysis ◽  
Wind Turbine ◽  
Offshore Wind ◽  
Wind Loads ◽  
Offshore Wind Turbine ◽  
Wave Loads ◽  
Tension Leg Platform ◽  
Floating Offshore Wind Turbine ◽  
Turbulent Wind ◽  
Coupled Dynamic Analysis

The dynamic response of a tension leg platform (TLP) floating offshore wind turbine (FOWT) was analyzed with considering the aero-hydro characteristic of the whole floating wind turbine system including the wind turbine, TLP platform, and tethers. The “aero-hydro” coupled dynamic analysis was conducted in ansys-aqwa with a dynamic link library (DLL) calculating the aerodynamics loading at every steptime based on the blade element momentum theory. Results from the coupled dynamic analysis of TLP FOWT under the condition of turbulent wind and regular wave show that the wind loads influence mainly the low-frequency response of the TLP FOWT. The wind loads have a large impact on the offsets of the TLP away from the initial position while the wave loads influence mainly the fluctuation amplitude of the TLP FOWT. The average TLP pitch response under the wind load is significantly larger due to the large wind-induced heeling moment on the wind turbine. In addition, the tension of tethers at the upwind end is greater than that at the downwind end. The wind loads could reduce effectively the average tension of the tethers, and the tension of tethers is significantly affected by the pitch motion. Results from the coupled dynamic analysis of TLP FOWT under the condition of turbulent wind and irregular wave show that the surge and pitch of TLP result in an obvious increase of thrust of the turbine and the amplitude of torque fluctuation, more attention should be paid to the pitch and surge motion of TLP FOWT.

scholarly journals Resonance Avoidance Control Algorithm for Semi-Submersible Floating Offshore Wind Turbine

Energies ◽  
2021 ◽  
Vol 14 (14) ◽  
pp. 4138
Author(s):  
Kwansu Kim ◽  
Hyunjong Kim ◽  
Hyungyu Kim ◽  
Jaehoon Son ◽  
Jungtae Kim ◽  
...  
Keyword(s):  
Wind Turbine ◽  
Control Algorithm ◽  
Torque Control ◽  
Offshore Wind ◽  
Offshore Wind Turbine ◽  
Resonance Problem ◽  
Exclusion Zone ◽  
Mean Power ◽  
Floating Offshore Wind Turbine ◽  
Avoidance Control

In this study, a resonance avoidance control algorithm was designed to address the tower resonance problem of a semi-submersible floating offshore wind turbine (FOWT) and the dynamic performance of the wind turbine, floater platform, and mooring lines at two exclusion zone ranges were evaluated. The simulations were performed using Bladed, a commercial software for wind turbine analysis. The length of simulation for the analysis of the dynamic response of the six degrees of freedom (DoF) motion of the floater platform under a specific load case was 3600 s. The simulation results are presented in terms of the time domain, frequency domain, and using statistical analysis. As a result of applying the resonance avoidance control algorithm, when the exclusion zone range was ±0.5 rpm from the resonance rpm, the overall performance of the wind turbine was negatively affected, and when the range was sufficiently wide at ±1 rpm, the mean power was reduced by 0.04%, and the damage equivalent load of the tower base side–side bending moment was reduced by 14.02%. The tower resonance problem of the FOWT caused by practical limitations in design and cost issues can be resolved by changing the torque control algorithm.

Sign in / Sign up

Export Citation Format

Share Document