scholarly journals Optimal Energy Management for a Hybrid Vehicle Using Neuro-Dynamic Programming to Consider Transient Engine Operation

Author(s):  
Rajit Johri ◽  
Ashwin Salvi ◽  
Zoran Filipi

This paper proposes a self-learning approach to develop optimal power management with multiple objectives, e.g. to minimize fuel consumption and transient engine-out NOx and particulate matter emission for a series hydraulic hybrid vehicle. Addressing multiple objectives is particularly relevant in the case of a diesel powered hydraulic hybrid since it has been shown that managing engine transients can significantly reduce real-world emissions. The problem is formulated as an infinite time horizon stochastic sequential decision making/markovian problem. The problem is computationally intractable by conventional Dynamic programming due to large number of states and complex modeling issues. Therefore, the paper proposes an online self-learning neural controller based on the fundamental principles of Neuro-Dynamic Programming (NDP) and reinforcement learning. The controller learns from its interactions with the environment and improves its performance over time. The controller tries to minimize multiple objectives and continues to evolve until a global solution is achieved. The control law is a stationary full state feedback based on 5 states and can be directly implemented. The controller performance is then evaluated in the Engine-in-the-Loop (EIL) facility.

2019 ◽  
Vol 141 (5) ◽  
Author(s):  
Kyle Williams ◽  
Monika Ivantysynova

This paper develops a new computational approach for energy management in a hydraulic hybrid vehicle. The developed algorithm, called approximate stochastic differential dynamic programming (ASDDP) is a variant of the classic differential dynamic programming algorithm. The simulation results are discussed for two Environmental Protection Agency drive cycles and one real world cycle based on collected data. Flexibility of the ASDDP algorithm is demonstrated as real-time driver behavior learning, and forecasted road grade information are incorporated into the control setup. Real-time potential of ASDDP is evaluated in a hardware-in-the-loop (HIL) experimental setup.


Author(s):  
Timothy O. Deppen ◽  
Andrew G. Alleyne ◽  
Kim A. Stelson ◽  
Jonathan J. Meyer

In this paper, a model predictive control (MPC) approach is presented for solving the energy management problem in a parallel hydraulic hybrid vehicle. The hydraulic hybrid vehicle uses variable displacement pump/motors to transfer energy between the mechanical and hydraulic domains and a high pressure accumulator for energy storage. A model of the parallel hydraulic hybrid powertrain is presented which utilizes the Simscape/Simhydraulics toolboxes of Matlab. These toolboxes allow for a concise description of the relevant powertrain dynamics. The proposed MPC regulates the engine torque and pump/motor displacement in order to track a desired velocity profile while maintaining desired engine conditions. In addition, logic is applied to the MPC to prevent high frequency cycling of the engine. Simulation results demonstrate the capability of the proposed control strategy to track both a desired engine torque and vehicle velocity.


2021 ◽  
Vol 13 (2) ◽  
Author(s):  
Emmanouil Spyrakos-Papastavridis ◽  
Jian S. Dai

Abstract This paper attempts to address the quandary of flexible-joint humanoid balancing performance augmentation, via the introduction of the Full-State Feedback Variable Impedance Control (FSFVIC), and Model-Free Compliant Floating-base VIC (MCFVIC) schemes. In comparison to rigid-joint humanoid robots, efficient balancing control of compliant bipeds, powered by Series Elastic Actuators (or harmonic drives), requires the design of more sophisticated controllers encapsulating both the motor and underactuated link dynamics. It has been demonstrated that Variable Impedance Control (VIC) can improve robotic interaction performance, albeit by introducing energy-injecting elements that may jeopardize closed-loop stability. To this end, the novel FSFVIC and MCFVIC schemes are proposed, which amalgamate both collocated and non-collocated feedback gains, with power-shaping signals that are capable of preserving the system's stability/passivity during VIC. The FSFVIC and MCFVIC stably modulate the system's collocated state gains to augment balancing performance, in addition to the non-collocated state gains that dictate the position control accuracy. Utilization of arbitrarily low-impedance gains is permitted by both the FSFVIC and MCFVIC schemes propounded herein. An array of experiments involving the COmpliant huMANoid reveals that significant balancing performance amelioration is achievable through online modulation of the full-state feedback gains (VIC), as compared to utilization of invariant impedance control.


2015 ◽  
Vol 1115 ◽  
pp. 440-445 ◽  
Author(s):  
Musa Mohammed Bello ◽  
Amir Akramin Shafie ◽  
Raisuddin Khan

The main purpose of vehicle suspension system is to isolate the vehicle main body from any road geometrical irregularity in order to improve the passengers ride comfort and to maintain good handling stability. The present work aim at designing a control system for an active suspension system to be applied in today’s automotive industries. The design implementation involves construction of a state space model for quarter car with two degree of freedom and a development of full state-feedback controller. The performance of the active suspension system was assessed by comparing it response with that of the passive suspension system. Simulation using Matlab/Simulink environment shows that, even at resonant frequency the active suspension system produces a good dynamic response and a better ride comfort when compared to the passive suspension system.


Sign in / Sign up

Export Citation Format

Share Document