Thermal Conductivity of Amorphous and Crystalline Mesoporous Titania Thin Films From 30 to 320 K

Author(s):  
Jin Fang ◽  
Laurent Pilon ◽  
Christian Reitz ◽  
Torsten Brezesinski ◽  
E. Joseph Nemanick ◽  
...  

This paper reports, for the first time, the cross-plane thermal conductivity of amorphous and crystalline templated cubic mesoporous titania thin films from 30 to 320 K. Both sol-gel and nanocrystal-based films were synthesized by evaporation-induced self-assembly with porosity of 30% to 35%, respectively. The pore diameter in sol-gel mesoporous films ranged from 14 to 25 nm and film thickness from 120 to 370 nm. Crystalline domains in crystalline mesoporous films were 9 to 13 nm in diameter. The thermal conductivity was measured between 30 and 320 K using the 3ω method. The experimental setup and the associated analysis were first validated by comparing experimental measurements with data reported in the literature for high purity silicon substrate and thermal oxide films over the temperature range considered. The thermal conductivity of sol-gel dense and mesoporous TiO2 films was found to increase with increasing temperature. The thermal conductivity of polycrystalline dense film was strongly dependent on temperature while that of dense amorphous and mesoporous films increased slowly with increasing temperature. The amorphous mesoporous TiO2 films featured very small thermal conductivity due to the fact that heat was mainly transferred by very localized non-propagating vibrational modes. Despite the particles crystallinity, the nanocrystal-based film showed significantly lower thermal conductivity than that of the sol-gel polycrystalline mesoporous thin films due to the strong phonon scattering at the nanocrystal boundaries.

Author(s):  
Thomas Coquil ◽  
Laurent Pilon ◽  
Christian Reitz ◽  
Torsten Brezesinski ◽  
Joseph E. Nemanick ◽  
...  

This paper reports the cross-plane thermal conductivity of amorphous and crystalline templated mesoporous titania thin films synthesized by evaporation-induced self-assembly. Both sol-gel and nanocrystal-based films were considered, with respective average porosities of 30% and 35%. The pore diameter ranged from 7 to 25 nm and film thickness from 60 to 370 nm while the average wall thickness varied from 3 to 25 nm. Nanocrystals in crystalline mesoporous films featured diameters between 9 and 13 nm. The thermal conductivity was measured at room temperature using the 3ω method. The experimental setup and the associated analysis were validated by comparing the thermal conductivity measurements with data reported in the literature for dense titania films with thickness ranging from 95 to 1000 nm. The cross-plane thermal conductivity of the amorphous mesoporous titania thin films did not show strong dependence on pore size, wall thickness, or film thickness. This can be attributed to the high atomic scale disorder of amorphous materials. Heat is thus mainly carried by localized non-propagating vibrational modes. The average thermal conductivity of the amorphous mesoporous titania films was identical to that of the nanocrystal-based films and equal to 0.37 W/m.K. Thermal conductivity of sol-gel crystalline mesoporous titania thin films was significantly larger than that of their amorphous counterparts. It also depended on the organic template used to make the films. The results indicated that the pore size was not an important factor. Instead thermal conductivity depended only on porosity, crystallinity, nanocrystal size and connectivity.


RSC Advances ◽  
2015 ◽  
Vol 5 (101) ◽  
pp. 83115-83121 ◽  
Author(s):  
S. El-Kacemi ◽  
Mar. Es-Souni ◽  
S. Habouti ◽  
D. Schopf ◽  
M. Hamdani ◽  
...  

Crack-free mesoporous anatase films are obtained on graphite felt using a one-pot synthesis from a precursor solution. The films are characterized by high photocatalytic performance in comparison to macro-mesoporous films on silicon substrates.


2008 ◽  
Author(s):  
Vincenzo Resta ◽  
Anna Maria Laera ◽  
Maria Cristina Ferrara ◽  
Emanuela Piscopiello ◽  
Saverio Mazzarelli ◽  
...  

2010 ◽  
Vol 10 (1) ◽  
pp. 26-31 ◽  
Author(s):  
Canggih Setya Budi ◽  
Indriana Kartini ◽  
Bambang Rusdiarso

Mesoporous titania powders with high-order crystalline building blocks had been synthesized through the sol-gel process using potato starch gel template. Internal spongelike pore structure of starch gel template was generated by heating the starch granules at 95 °C in water solution and freezing the starch gel at -15 °C. The synthesis routes were performed by immersing the starch gel template for 4 days into the white colloidal solution of TiO2 nanoparticles, which were prepared by hydrolyzing titanium (IV) tetraisopropoxide (TTIP) in ethanol at pH 1. Mesoporous TiO2 powders were obtained by two different ways of template removal, performed by calcination of the TiO2-starch composites at 600 °C for 4 h or combination of extraction with ethanol-HCl (2:1) at 80 °C and calcination at 500 °C for 4 h. Fourier Transform Infra Red (FT-IR) spectra shows both of template removal methods result in decreasing of characteristic vibrational band of the starch hydrocarbon on the resulted TiO2 powders. The X-Ray Diffraction (XRD) pattern imply that the concentrations of starch gel template influence the anatase crystallite peaks intensity of the synthesized TiO2 powders. TiO2 templated by 20% of starch sponges gel has highest intensity of anatase crystallite. Scherrer calculation inidicated that anatase particle size has nanoscale dimmension up to 12.96 nm. The nano-architecture feature of mesoporous TiO2 scaffolds was also evaluated by the Scanning Electron Microscope (SEM). It is shown that mesoporous TiO2 framework consist of nanocrystalline TiO2 particles as buiding blocks. The N2 adsorption-desorption isotherm curves assign that TiO2 powder resulted from extraction-calcination route has higher mesoporosity than that of only calcinated. The synthesized mesoporous TiO2 powder exhibits high Brunauer-Emmet-Teller (BET) specific surface area up to 65.65 m2/g.   Keywords: mesoporous TiO2, potato starch, template


2020 ◽  
Vol 92 (20) ◽  
pp. 13656-13660
Author(s):  
M. Mercedes Zalduendo ◽  
Víctor Oestreicher ◽  
Judith Langer ◽  
Luis M. Liz-Marzán ◽  
Paula C. Angelomé

2010 ◽  
Vol 20 (14) ◽  
pp. 2831 ◽  
Author(s):  
Jinjin Zhao ◽  
Sébastien Sallard ◽  
Bernd M. Smarsly ◽  
Silvia Gross ◽  
Massimo Bertino ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document