Experimental Investigation on Heating Performance of Newly Designed Air Source Heat Pump System for Electric Vehicles

Author(s):  
Kang Li ◽  
Jun Yu ◽  
Rong Yu ◽  
Lin Su ◽  
Yidong Fang ◽  
...  

Abstract Utilizing the heat from air source with heat pump system in electric vehicles shows a significant advantage from thermoelectric heat source for heat supply in cold climate. It could improve the driving range of electric vehicles considerably in winter and replace the positive temperature coefficient (PTC) heater with an acceptable cost and reliability. In this work, a newly designed heat pump system was first introduced with less components and cost. Second, experiments were conducted to investigate its cooling performance, and subsequent heating performance from −10 to 10 °C. The typical heat transfer and flow characteristics of refrigerant were recorded, and the behavior of each component including compressor, evaporator, condenser, and outside heat exchanger were analyzed and interpreted. The results showed that the heating and cooling performance of the new heat pump system could almost remain the same with traditional air-conditioning system in automobile and surely satisfy with the heat requirement of electric vehicles. In the heating mode, the maximum heating capacity increases by 13% at 400 m3/h air volume from 300 m3/h at the ambient temperature −10 °C, while the outlet air temperature decreases by 4–6%. In addition, using a heat pump system showed an increase in the driving range of electric vehicles by 25–31% as compared to PTC heaters.

Energies ◽  
2020 ◽  
Vol 13 (3) ◽  
pp. 657 ◽  
Author(s):  
Kang Li ◽  
Jun Yu ◽  
Mingkang Liu ◽  
Dan Xu ◽  
Lin Su ◽  
...  

With regard to concerns about an electric vehicle’s driving range extension in a cold climate, an air-conditioning heat pump (ACHP) shows considerable advantage over thermoelectric heaters for battery energy conservation. The effect of refrigerant charge amount for cooling and heating performance of the ACHP system is significant. The optimal charge, realizing the optimal system performance, is usually determined by experiments of cooling and heating performance. In this paper, the optimal charge determination process based on a newly designed ACHP applied in electric vehicles was introduced. Relationships of characteristics with charge in two modes were investigated by experimental and theoretical methods. Firstly, the performance of the ACHP system was respectively investigated at different charge amounts in cooling and heating operating conditions according to key parameters of system cycles. Secondly, the intersection platforms of subcooling and superheat variation curves with refrigerant charge amount were obtained for determining optimal charge amount of the system further by comprehensive analysis. Finally, the theoretical calculation of charge with three instructive and classical void friction correlation models were applied for better comparisons. It was found that charge amount calculated by the Hughmark model proved to be most consistent with the comprehensive experimental results.


Author(s):  
Kang Li ◽  
Hao Gao ◽  
Peng Jia ◽  
Lin Su ◽  
Yidong Fang ◽  
...  

In electrical vehicles, replacing positive temperature coefficient heater as heat source with an air source heat pump could improve the driving range and decrease energy consumption in cold climate. Design of the heating, ventilation, and air-conditioning module for heat pump system has a significant influence on its performance in each working mode. A newly designed heat pump heating, ventilation, and air-conditioning module was introduced in this paper. The air flow characteristics of the heat pump heating, ventilation, and air-conditioning module in four working modes were analyzed, and the air flow rate and wind resistance were obtained by numerical simulation. Experiments were also conducted for validating its airflow rate in each working mode. Results of these experiments show that some unfavorable phenomena such as flow maldistribution and vortex inside the heat pump heating, ventilation, and air-conditioning module exist, which could lead to insufficient utilization of the heat exchange area of heat exchangers and the generation of aerodynamic noise. Furthermore, the air flow rate of the original heating, ventilation, and air-conditioning module was also measured for comparison, and the designed heat pump heating, ventilation, and air-conditioning module shows nearly 15–20% decrease in each working mode.


2009 ◽  
Vol 34 (3) ◽  
pp. 578-582 ◽  
Author(s):  
Yujin Hwang ◽  
Jae-Keun Lee ◽  
Young-Man Jeong ◽  
Kyung-Min Koo ◽  
Dong-Hyuk Lee ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document