Numerical Investigation on Frequency Jump of Flow Over a Cavity Using Large Eddy Simulation

2015 ◽  
Vol 137 (8) ◽  
Author(s):  
Yuchuan Wang ◽  
Lei Tan ◽  
Binbin Wang ◽  
Shuliang Cao ◽  
Baoshan Zhu
Keyword(s):  
Large Eddy Simulation ◽  
Shear Layer ◽  
Cavity Length ◽  
Nonlinear Process ◽  
Sustained Oscillation ◽  
Time Lags ◽  
Frequency Jump ◽  
Eddy Simulation ◽  
Large Eddy ◽  
Flow Over A Cavity

Large eddy simulation (LES) approach was used to investigate jumps of primary frequency of shear layer flow over a cavity. Comparisons between computational results and experimental data show that LES is an appropriate approach to accurately capturing the critical values of velocity and cavity length of a frequency jump, as well as characteristics of the separated shear layer. The drive force of the self-sustained oscillation of impinging shear layer is fluid injection and reinjection. Flow patterns in the shear layer and cavity before and after the frequency jump demonstrate that the frequency jump is associated with vortex–corner interaction. Before frequency jump, a mature vortex structure is observed in shear layer. The vortex is clipped by impinging corner at approximately half of its size, which induces strong vortex–corner interaction. After frequency jump, successive vortices almost escape from impinging corner without the generation of a mature vortex, thereby indicating weaker vortex–corner interaction. Two wave peaks are observed in the shear layer after the frequency jump because of: (1) vortex–corner interaction and (2) centrifugal instability in cavity. Pressure fluctuations inside the cavity are well regulated with respect to time. Peak values of correlation coefficients close to zero time lags indicate the existence of standing waves inside the cavity. Transitions from a linear to a nonlinear process occurs at the same position (i.e., x/H = 0.7) for both velocity and cavity length variations. Slopes of linear region are solely the function of cavity length, thereby showing increased steepness with increased cavity length.

Large Eddy Simulation of Wake-Shear Layer Interactions Over a Multi-Element Aerofoil

2020 ◽  
Author(s):  
Souvik Naskar ◽  
S. Sarkar
Keyword(s):  
Large Eddy Simulation ◽  
Shear Layer ◽  
Separation Bubble ◽  
Turbine Blades ◽  
Leading Edge ◽  
Aerodynamic Characteristics ◽  
Suction Surface ◽  
Free Stream Turbulence ◽  
Eddy Simulation ◽  
Large Eddy

Abstract Modern commercial airliners use multi-element aerofoils to enhance take-off and landing performance. Further, multielement aerofoil configurations have been shown to improve the aerodynamic characteristics of wind turbines. In the present study, high resolution Large Eddy Simulation (LES) is used to explore the low Reynolds Number (Re = 0.832 × 104) aerodynamics of a 30P30N multi-element aerofoil at an angle of attack, α = 4°. In the present simulation, wake shed from a leading edge element or slat is found to interact with the separated shear layer developing over the suction surface of the main wing. High receptivity of shear layer via amplification of free-stream turbulence leads to rollup and breakdown, forming a large separation bubble. A transient growth of fluctuations is observed in the first half of the separation bubble, where levels of turbulence becomes maximum near the reattachment and then decay depicting saturation of turbulence. Results of the present LES are found to be in close agreement with the experiment depicting high vortical activity in the outer layer. Some features of the flow field here are similar to those occur due to interactions of passing wake and the separated boundary layer on the suction surface of high lift low pressure turbine blades.

scholarly journals Control of Vorticity of Flow over a Cavity with the Aid of Large Eddy Simulation

2011 ◽  
Vol 15 ◽  
pp. 4228-4235 ◽  
Author(s):  
Guodong Wang ◽  
Zhiguo Zhang ◽  
Mingyue Liu ◽  
Jing Hu ◽  
Dakui Feng
Keyword(s):  
Large Eddy Simulation ◽  
Eddy Simulation ◽  
Large Eddy ◽  
Flow Over A Cavity

Large Eddy Simulation of Self-Sustained Cavity Oscillation for Subsonic and Supersonic Flows

2016 ◽  
Vol 139 (1) ◽  
Author(s):  
K. M. Nair ◽  
S. Sarkar
Keyword(s):  
Large Eddy Simulation ◽  
Shear Layer ◽  
Acoustic Waves ◽  
Large Scale ◽  
Hydrodynamic Instability ◽  
Supersonic Flows ◽  
Large Scale Structures ◽  
Eddy Simulation ◽  
Large Eddy ◽  
Scale Structures

The primary objective is to perform a large eddy simulation (LES) using shear improved Smagorinsky model (SISM) to resolve the large-scale structures, which are primarily responsible for shear layer oscillations and acoustic loads in a cavity. The unsteady, three-dimensional (3D), compressible Navier–Stokes (N–S) equations have been solved following AUSM+-up algorithm in the finite-volume formulation for subsonic and supersonic flows, where the cavity length-to-depth ratio was 3.5 and the Reynolds number based on cavity depth was 42,000. The present LES resolves the formation of shear layer, its rollup resulting in large-scale structures apart from shock–shear layer interactions, and evolution of acoustic waves. It further indicates that hydrodynamic instability, rather than the acoustic waves, is the cause of self-sustained oscillation for subsonic flow, whereas the compressive and acoustic waves dictate the cavity oscillation, and thus the sound pressure level for supersonic flow. The present LES agrees well with the experimental data and is found to be accurate enough in resolving the shear layer growth, compressive wave structures, and radiated acoustic field.

Assessment of a Noise Reduction Concept for a Hot Supersonic Jet Using Large Eddy Simulation

2013 ◽  
Author(s):  
James P. Erwin ◽  
Neeraj Sinha
Keyword(s):  
Large Eddy Simulation ◽  
Noise Reduction ◽  
Shear Layer ◽  
Nozzle Exit ◽  
Supersonic Jet ◽  
Broadband Noise ◽  
Shock Cell ◽  
Testing Procedures ◽  
Eddy Simulation ◽  
Large Eddy

Noise emissions of a hot, supersonic jet at laboratory scale are predicted with and without a noise reduction concept. The hot jet is representative of an over-expanded, low bypass ratio military gas turbine engine exhaust. The reduction device consists of twelve non-penetrating chevrons that are equilateral triangles, extending tangentially from the inner nozzle wall and to the flow at the nozzle exit. The chevrons are idealized and not a result of any design or testing procedures. Hybrid Reynolds Averaged Navier Stokes and Large Eddy Simulation (HRLES) is performed at both 5.5 million and 128 million cell grid resolutions. A novel structured topology is used to perform the HRLES with and without the chevrons using the same grid, and the chevrons are turned on and off through a boundary condition switch. The noise emissions are then predicted on a circular array one hundred jet exit diameters from the nozzle exit with the permeable Ffowcs Williams and Hawkings equation method. The chevrons modify the entrained flow at the over-expanded power setting, impacting the shear layer and associated far-field noise. The chevrons stabilize the jet shock cell structure, and also reduce turbulent fluctuations throughout the length of the shear layer. An overall sound pressure level reduction of between one and four decibels is predicted at all angles to the jet, including the elimination of jet screech relative to the baseline jet with no chevrons. A significant reduction in broadband noise is also predicted downstream. The jet with chevrons is also predicted with the higher resolution grid and noise levels are compared with the low resolution grid. Upstream noise level predictions are increased due to enhanced resolution of fine scale turbulence.

Large eddy simulation of flow over a twisted cylinder at a subcritical Reynolds number

2014 ◽  
Vol 759 ◽  
pp. 579-611 ◽  
Author(s):  
Jae Hwan Jung ◽  
Hyun Sik Yoon
Keyword(s):  
Reynolds Number ◽  
Large Eddy Simulation ◽  
Shear Layer ◽  
Vortex Shedding ◽  
Vortex Formation ◽  
The Body ◽  
Recirculation Region ◽  
Eddy Simulation ◽  
Large Eddy ◽  
Drag And Lift

AbstractWe consider a twisted cylinder that was designed by rotating the elliptic cross-section along the spanwise direction, resulting in a passive control. The flow over the twisted cylinder is investigated at a subcritical Reynolds number (Re) of 3000 using large eddy simulation based on the finite volume method. For comparison, the flow past smooth and wavy cylinders is also calculated. The twisted cylinder achieves reductions of approximately 13 and 5 % in mean drag compared with smooth and wavy cylinders, respectively. In particular, the root mean square (r.m.s.) value of the lift fluctuation of the twisted cylinder shows a substantial decrease of approximately 96 % compared with the smooth cylinder. The shear layer of the twisted cylinder covering the recirculation region is more elongated than those of the smooth and wavy cylinders, and vortex shedding from the twisted cylinder is considerably suppressed. Consequently, the elongation of the shear layer from the body and the near disappearance of vortex shedding in the near wake with weak vortical strength contributes directly to the reduction of drag and lift oscillation. Various fundamental mechanisms that affect the flow phenomena, three-dimensional separation, pressure coefficient, vortex formation length and turbulent kinetic energy are examined systematically to demonstrate the effect of the twisted cylinder surface. In addition, for the twisted cylinder at $\mathit{Re}=3000$, the effect of the cross-sectional aspect ratio is investigated from 1.25 to 2.25 to find an optimal value that can reduce the drag and lift forces. Moreover, the effect of the Reynolds number on the aerodynamic characteristics is investigated in the range of $3\times 10^{3}\leqslant \mathit{Re}\leqslant 1\times 10^{4}$. We find that as Re increases, the mean drag and the r.m.s. lift coefficient of the twisted cylinder increase, and the vortex formation length decreases.

scholarly journals Large eddy simulation of the velocity-intermittency structure for flow over a field of symmetric dunes

2016 ◽  
Vol 805 ◽  
pp. 656-685 ◽  
Author(s):  
Christopher J. Keylock ◽  
Kyoungsik S. Chang ◽  
George S. Constantinescu
Keyword(s):  
Large Eddy Simulation ◽  
Shear Layer ◽  
Outer Region ◽  
Recirculation Region ◽  
Flow Structures ◽  
Wall Region ◽  
Numerical Work ◽  
Eddy Simulation ◽  
Large Eddy ◽  
Near Wall

Owing to their frequent occurrence in the natural environment, there has been significant interest in refining our understanding of flow over dunes and other bedforms. Recent work in this area has focused, in particular, on their shear-layer characteristics and the manner by which flow structures are generated. However, field-based studies, are reliant on single-, or multi-point measurements, rather than delimiting flow structures from the velocity gradient tensor, as is possible in numerical work. Here, we extract pointwise time series from a well-resolved large eddy simulation as a means to connect these two approaches. The at-a-point analysis technique is termed the velocity-intermittency quadrant method and relates the fluctuating, longitudinal velocity, $u_{1}^{\prime }(t)$, to its fluctuating pointwise Hölder regularity, $\unicode[STIX]{x1D6FC}_{1}^{\prime }(t)$. Despite the difference in boundary conditions, our results agree very well with previous experiments that show the importance, in the region above the dunes, of a quadrant 3 ($u_{1}^{\prime }<0$, $\unicode[STIX]{x1D6FC}_{1}^{\prime }<0$) flow configuration. Our higher density of sampling beneath the shear layer and close to the bedforms relative to experimental work reveals a negative correlation between $u_{1}^{\prime }(t)$ and $\unicode[STIX]{x1D6FC}_{1}^{\prime }(t)$ in this region. This consists of two distinct layers, with quadrant 4 ($u_{1}^{\prime }>0$, $\unicode[STIX]{x1D6FC}_{1}^{\prime }<0$) dominant near the wall and quadrant 2 ($u_{1}^{\prime }<0$, $\unicode[STIX]{x1D6FC}_{1}^{\prime }>0$) dominant close to the lower part of the separated shear layer. These results are consistent with a near-wall advection of vorticity into a region downstream of a temporarily foreshortened reattachment region, and the entrainment of slow moving and quiescent fluid into a faster, more turbulent shear layer. A comparison of instantaneous vorticity fields to the velocity-intermittency analysis shows how the pointwise results reflect larger-scale organisation of the flow. We illustrate this using results from two instantaneous datasets. In the former, extreme velocity-intermittency events corresponding to a foreshortened recirculation region (and high pressures on the stoss slope of the dune immediately downstream) arise, and the development of intense flow structures occurs as a consequence. In the other case, development of a ‘skimming flow’ with relatively little exchange between the inner and outer regions results in exceedances because of the coherence associated with this high velocity, high turbulence outer region. Thus, our results shed further light on the characteristics of dune flow in the near-wall region and, importantly for field-based research, show that useful information on flow structure can be obtained from single-point single velocity component measurements.

Sign in / Sign up

Export Citation Format

Share Document