scholarly journals Discussion: “An Electrical Resistance Method of Determining the Mean Surface Temperature of Tubes” (Marchant, John H., 1937, ASME J. Appl. Mech., 4, pp. A16–A20)

1937 ◽  
Vol 4 (3) ◽  
pp. A141
Author(s):  
W. S. Patterson
1937 ◽  
Vol 4 (1) ◽  
pp. A16-A20
Author(s):  
John H. Marchant

Abstract The author describes a new method for determining the mean surface temperature of condenser tubes through which a steady radial flow of heat occurs. The method consists in using the tube itself as a resistance thermometer. The author explains that when a steady longitudinal flow of electricity is superimposed upon the given radial flow of heat, the actual current being so small as not to involve appreciable Joulean heat, the temperature gradients associated with the flow of heat affect the electrical resistance of the tube material, and expressions for the mean temperature of the inner and outer tube surfaces can be derived from applications of physical laws. These expressions are derived by the author.


Author(s):  
Kiyotaka Ikejo ◽  
Kazuteru Nagamura

This paper describes the effect of traction oil on the power loss of spur gear drive. In this study, we measured the power loss of super gear drive using several traction oils. We separated the power loss into gear friction loss and oil churning loss. Furthermore, we measured the surface temperature on the gear tooth by the dynamic thermocouple method, and observed the lubrication condition between meshing teeth by the electrical resistance method. Then, we investigated the relationships between the power loss of the gear drive lubricated with the traction oil, the surface temperature on the gear tooth, and the lubrication condition.


2021 ◽  
pp. 112067212110237
Author(s):  
Ari Leshno ◽  
Ori Stern ◽  
Yaniv Barkana ◽  
Noa Kapelushnik ◽  
Reut Singer ◽  
...  

Purpose: Accumulating evidence suggests that neuroinflammation and immune response are part of the sequence of pathological events leading to optic nerve damage in glaucoma. Changes in tissue temperature due to inflammation can be measured by thermographic imaging. We investigated the ocular surface temperature (OST) profile of glaucomatous eyes to better understand the pathophysiology of these conditions. Methods: Subjects diagnosed with glaucoma (primary open angle glaucoma [POAG] or pseudo exfoliation glaucoma [PXFG]) treated at the Sam Rothberg Glaucoma Center (11/2019–11/2020.) were recruited. Healthy subjects with no ocular disease served as controls. The Therm-App thermal imaging camera was used for OST acquisition. Room and body temperatures were recorded, and the mean temperatures of the medial cantus, lateral cantus, and cornea were calculated with image processing software. Results: Thermographic images were obtained from 52 subjects (52 eyes: 25 POAG and 27 PXFG) and 66 controls (66 eyes). Eyes with glaucoma had a significantly higher OST compared to controls (mean 0.9 ± 0.3°C, p < 0.005). The difference between the two groups remained significant after adjustment for age, sex, intraocular pressure (IOP) and room and body temperatures. Lens status and topical IOP-lowering medication did not significantly affect OST. A subgroup analysis revealed that the OST was higher among eyes with POAG compared to eyes with PXFG, but not significantly. Conclusions: Differences in the OST between glaucomatous and normal eyes strengthens current thinking that inflammation affects the pathophysiology of glaucoma. Longitudinal studies are warranted to establish the prognostic value of thermographic evaluations in these patients.


1971 ◽  
Vol 46 (1) ◽  
pp. 165-175 ◽  
Author(s):  
Hiroshi Ishigaki

The time-mean skin friction of the laminar boundary layer on a flat plate which is fixed at zero incidence in a fluctuating stream is investigated analytically. Flow oscillation amplitude outside the boundary layer is assumed constant along the surface. First, the small velocity-amplitude case is treated, and approximate formulae are obtained in the extreme cases when the frequency is low and high. Next, the finite velocity-amplitude case is treated under the condition of high frequency, and it is found that the formula obtained for the small-amplitude and high-frequency case is also valid. These results show that the increase of the mean skin friction reduces with frequency and is ultimately inversely proportional to the square of frequency.The corresponding energy equation is also studied simultaneously under the condition of zero heat transfer between the fluid and the surface. It is confirmed that the time-mean surface temperature increases with frequency and tends to be proportional to the square root of frequency. Moreover, it is shown that the timemean recovery factor can be several times as large as that without flow oscillation.


CORROSION ◽  
1961 ◽  
Vol 17 (10) ◽  
pp. 485t-491t ◽  
Author(s):  
DAVID ROLLER ◽  
WILLARD R. SCOTT ◽  
HERMAN S. PREISER ◽  
FRANK E. COOK

Abstract This paper describes the design, fabrication and preliminary testing of several types of corrosion measuring probes developed for use on maritime vessels. The probes are part of a system utilizing the electrical resistance method for continuously monitoring corrosion during actual operation. One type of probe to be described is intended for monitoring corrosion on either the exterior surface of the hull or interior structural members in large compartment. Another probe has been developed for measuring condenser tube inlet (tube end) corrosion. A third probe has been developed for measuring corrosion in crevices and pipe lines. Both laboratory and simulated service testing has been carried out. Results of these tests and the effectiveness of the probes in measuring corrosive conditions on ships are discussed. 2.4.2


Sign in / Sign up

Export Citation Format

Share Document