The Effect of Process Variables on Extrusion Pressures of Lead

1959 ◽  
Vol 81 (3) ◽  
pp. 207-214 ◽  
Author(s):  
J. Frisch ◽  
E. G. Thomsen
Keyword(s):  
Room Temperature ◽  
Extrusion Ratio ◽  
Extrusion Pressure ◽  
White Lead ◽  
Cylinder Wall ◽  
Process Variables ◽  
Pure Lead ◽  
Commercially Pure ◽  
Wide Range

Billets of commercially pure lead, 2 in. diam × 3 in. long were extruded at room temperature through five different die contours at ram speeds up to 50 ipm. It was found that, for the direct and indirect extrusions, with good lubrication (white lead in oil) and with good cylinder-wall finish, the extrusion pressure-displacement diagrams were essentially the same. The concentric and eccentric single-bar and multibar extrusions at constant extrusion ratio required approximately the same pressures when extruded at identical speeds. The extrusion pressures over the wide range of speeds investigated showed approximate linearity when plotted on log-log co-ordinates.

Computer Application to the Visioplasticity Method

1967 ◽  
Vol 89 (2) ◽  
pp. 339-346 ◽  
Author(s):  
A. Shabaik ◽  
S. Kobayashi
Keyword(s):  
Plane Strain ◽  
Complete Solution ◽  
Effective Strain ◽  
Cone Angle ◽  
Extrusion Process ◽  
Axisymmetric Deformation ◽  
Extrusion Ratio ◽  
Computer Application ◽  
White Lead ◽  
Pure Lead

Procedures for using a computer for the complete solution to plane strain as well as axisymmetric deformation problems have been developed. The velocity, strain rate, total effective strain, and stress distributions were obtained for two commercially pure lead specimens extruded in a forward extrusion process using white lead in oil as a lubricant. The axisymmetric extrusion was carried out at a speed of 1/8 ipm through a conical die having a 45 deg half-cone angle with a 2:1 extrusion ratio, and the plane-strain extrusion through a tapered die having a 45 deg half-taper angle with a 1.66:1 extrusion ratio.

Mechanical Properties and Dislocation Structure of Single Crystal Cdte Deformed in Compression at 300°C

1976 ◽  
Vol 34 ◽  
pp. 592-593
Author(s):  
Ernest L. Hall ◽  
J. B. Vander Sande
Keyword(s):  
Mechanical Properties ◽  
Single Crystal ◽  
Dislocation Structure ◽  
Room Temperature ◽  
Elevated Temperatures ◽  
Strain Curve ◽  
Optical Devices ◽  
Semiconductor Compound ◽  
Wide Range ◽  
Sample Orientation

The present paper describes research on the mechanical properties and related dislocation structure of CdTe, a II-VI semiconductor compound with a wide range of uses in electrical and optical devices. At room temperature CdTe exhibits little plasticity and at the same time relatively low strength and hardness. The mechanical behavior of CdTe was examined at elevated temperatures with the goal of understanding plastic flow in this material and eventually improving the room temperature properties. Several samples of single crystal CdTe of identical size and crystallographic orientation were deformed in compression at 300°C to various levels of total strain. A resolved shear stress vs. compressive glide strain curve (Figure la) was derived from the results of the tests and the knowledge of the sample orientation.

Evaluation of 99mTc-Label led Vitamin K4 as an Agent for Testicular Imaging

1991 ◽  
Vol 30 (01) ◽  
pp. 35-39 ◽  
Author(s):  
H. S. Durak ◽  
M. Kitapgi ◽  
B. E. Caner ◽  
R. Senekowitsch ◽  
M. T. Ercan
Keyword(s):  
Soft Tissue ◽  
Room Temperature ◽  
Normal Subjects ◽  
Left Testis ◽  
Wide Range ◽  
Activity Ratios ◽  
The Right ◽  
Radioactivity Levels

Vitamin K4 was labelled with 99mTc with an efficiency higher than 97%. The compound was stable up to 24 h at room temperature, and its biodistribution in NMRI mice indicated its in vivo stability. Blood radioactivity levels were high over a wide range. 10% of the injected activity remained in blood after 24 h. Excretion was mostly via kidneys. Only the liver and kidneys concentrated appreciable amounts of radioactivity. Testis/soft tissue ratios were 1.4 and 1.57 at 6 and 24 h, respectively. Testis/blood ratios were lower than 1. In vitro studies with mouse blood indicated that 33.9 ±9.6% of the radioactivity was associated with RBCs; it was washed out almost completely with saline. Protein binding was 28.7 ±6.3% as determined by TCA precipitation. Blood clearance of 99mTc-l<4 in normal subjects showed a slow decrease of radioactivity, reaching a plateau after 16 h at 20% of the injected activity. In scintigraphic images in men the testes could be well visualized. The right/left testis ratio was 1.08 ±0.13. Testis/soft tissue and testis/blood activity ratios were highest at 3 h. These ratios were higher than those obtained with pertechnetate at 20 min post injection.99mTc-l<4 appears to be a promising radiopharmaceutical for the scintigraphic visualization of testes.

Porphyrin-Catalyzed Oxidation of N-Substituted Tetrahydroisoquinolines to Dihydroisoquinolones

Synlett ◽  
2021 ◽  
Author(s):  
Ao Li ◽  
Bin Pan ◽  
Mu Chao ◽  
Na Wang ◽  
Yu-Long Li ◽  
...  
Keyword(s):  
Visible Light ◽  
Room Temperature ◽  
Air Atmosphere ◽  
Wide Range ◽  
Convenient Route ◽  
Catalyzed Oxidation

A visible-light-induced direct α-oxygenation of N-substituted tetrahydroisoquinoline derivatives has been successfully developed. Metalloporphyrin (ZnTPP) has been identified as an effective and inexpensive photocatalyst for this transformation with a wide range of substrates. This protocol provides a convenient route to afford the desired products in moderate to good yields at room temperature under air atmosphere.

scholarly journals Plasmonic semiconductor nanogroove array enhanced broad spectral band millimetre and terahertz wave detection

2021 ◽  
Vol 10 (1) ◽  
Author(s):  
Jinchao Tong ◽  
Fei Suo ◽  
Tianning Zhang ◽  
Zhiming Huang ◽  
Junhao Chu ◽  
...  
Keyword(s):  
Surface Plasmon ◽  
High Performance ◽  
Room Temperature ◽  
Spectral Band ◽  
High Capacity ◽  
Terahertz Wave ◽  
Semiconductor Surface ◽  
Wide Range ◽  
Low Sensitivity ◽  
Air Interfaces

AbstractHigh-performance uncooled millimetre and terahertz wave detectors are required as a building block for a wide range of applications. The state-of-the-art technologies, however, are plagued by low sensitivity, narrow spectral bandwidth, and complicated architecture. Here, we report semiconductor surface plasmon enhanced high-performance broadband millimetre and terahertz wave detectors which are based on nanogroove InSb array epitaxially grown on GaAs substrate for room temperature operation. By making a nanogroove array in the grown InSb layer, strong millimetre and terahertz wave surface plasmon polaritons can be generated at the InSb–air interfaces, which results in significant improvement in detecting performance. A noise equivalent power (NEP) of 2.2 × 10−14 W Hz−1/2 or a detectivity (D*) of 2.7 × 1012 cm Hz1/2 W−1 at 1.75 mm (0.171 THz) is achieved at room temperature. By lowering the temperature to the thermoelectric cooling available 200 K, the corresponding NEP and D* of the nanogroove device can be improved to 3.8 × 10−15 W Hz−1/2 and 1.6 × 1013 cm Hz1/2 W−1, respectively. In addition, such a single device can perform broad spectral band detection from 0.9 mm (0.330 THz) to 9.4 mm (0.032 THz). Fast responses of 3.5 µs and 780 ns are achieved at room temperature and 200 K, respectively. Such high-performance millimetre and terahertz wave photodetectors are useful for wide applications such as high capacity communications, walk-through security, biological diagnosis, spectroscopy, and remote sensing. In addition, the integration of plasmonic semiconductor nanostructures paves a way for realizing high performance and multifunctional long-wavelength optoelectrical devices.

Cholinium-amino acid based ionic liquids: a new method of synthesis and physico-chemical characterization

2015 ◽  
Vol 17 (32) ◽  
pp. 20687-20698 ◽  
Author(s):  
Serena De Santis ◽  
Giancarlo Masci ◽  
Francesco Casciotta ◽  
Ruggero Caminiti ◽  
Eleonora Scarpellini ◽  
...  
Keyword(s):  
Ionic Liquids ◽  
Amino Acid ◽  
Room Temperature ◽  
Chemical Characterization ◽  
New Method ◽  
Room Temperature Ionic Liquids ◽  
Synthetic Method ◽  
Chemical Structures ◽  
Physico Chemical ◽  
Wide Range

Fourteen cholinium-amino acid based room temperature ionic liquids were prepared using a cleaner synthetic method. Chemicophysical properties were well correlated with the wide range of amino acid chemical structures.

scholarly journals A Highly Sensitive Room Temperature CO2 Gas Sensor Based on SnO2-rGO Hybrid Composite

Materials ◽  
2021 ◽  
Vol 14 (3) ◽  
pp. 522
Author(s):  
Zhi Yan Lee ◽  
Huzein Fahmi bin Hawari ◽  
Gunawan Witjaksono bin Djaswadi ◽  
Kamarulzaman Kamarudin
Keyword(s):  
Electron Microscopy ◽  
Carbon Dioxide ◽  
Gas Sensor ◽  
Photoelectron Spectroscopy ◽  
Hybrid Composite ◽  
Room Temperature ◽  
Co2 Gas ◽  
X Ray ◽  
Wide Range ◽  
Co2 Gas Sensor

A tin oxide (SnO2) and reduced graphene oxide (rGO) hybrid composite gas sensor for high-performance carbon dioxide (CO2) gas detection at room temperature was studied. Since it can be used independently from a heater, it emerges as a promising candidate for reducing the complexity of device circuitry, packaging size, and fabrication cost; furthermore, it favors integration into portable devices with a low energy density battery. In this study, SnO2-rGO was prepared via an in-situ chemical reduction route. Dedicated material characterization techniques including field emission scanning electron microscopy (FESEM), high-resolution transmission electron microscopy (HRTEM), energy dispersive X-ray (EDX) spectroscopy, Raman spectroscopy, and X-ray photoelectron spectroscopy (XPS) were conducted. The gas sensor based on the synthesized hybrid composite was successfully tested over a wide range of carbon dioxide concentrations where it exhibited excellent response magnitudes, good linearity, and low detection limit. The synergistic effect can explain the obtained hybrid gas sensor’s prominent sensing properties between SnO2 and rGO that provide excellent charge transport capability and an abundance of sensing sites.

Alkene Difunctionalization Directed by Free Amines: Diamine Synthesis via Nickel-Catalyzed 1,2-Carboamination

2021 ◽  
Author(s):  
Taeho Kang ◽  
José Manuel González ◽  
Zi-Qi Li ◽  
Klement Foo ◽  
Peter Cheng ◽  
...  
Keyword(s):  
Nickel Catalyst ◽  
Room Temperature ◽  
Kinetic Studies ◽  
Fine Tuning ◽  
Secondary Amines ◽  
Protecting Group ◽  
Wide Range ◽  
Leaving Group ◽  
Primary And Secondary Amines ◽  
Reaction Proceeds

A versatile method to access differentially substituted 1,3- and 1,4-diamines via a nickel-catalyzed three-component 1,2-carboamination of alkenyl amines with aryl/alkenylboronic ester nucleophiles and N–O electrophiles is reported. The reaction proceeds efficiently with free primary and secondary amines without needing a directing auxiliary or protecting group, and is enabled by fine-tuning the leaving group on the N–O reagent. The transformation is highly regioselective and compatible with a wide range of coupling partners and alkenyl amine substrates, all performed at room temperature. A series of kinetic studies support a mechanism in which alkene coordination to the nickel catalyst is turnover-limiting.

Diversification of α–Ketoamides via Transamidation Reactions with Alkyl and Benzyl Amines at Room Temperature

2021 ◽  
Author(s):  
Shweta Singh ◽  
Sureshbabu Popuri ◽  
Qazi Mohammad Junaid ◽  
Sabiah Shahul Hameed ◽  
Jeyakumar Kandasamy
Keyword(s):  
Room Temperature ◽  
The Other ◽  
Alkyl Amines ◽  
Other Hand ◽  
Wide Range

A wide range of N-tosyl α–ketoamides underwent transamidation with various alkyl amines in the absence of catalyst, base, or additives. On the other hand, transamidation in N-Boc α–ketoamides is achieved...

Sign in / Sign up

Export Citation Format

Share Document