Second Law Assessment of a Wet Ethanol Fuelled HCCI Engine Combined With Organic Rankine Cycle

2012 ◽  
Vol 134 (2) ◽  
Author(s):  
Abdul Khaliq ◽  
Shailesh K. Trivedi

In this study, first and second law analyses of a new combined power cycle based on wet ethanol fuelled homogeneous charge compression ignition (HCCI) engine and an organic Rankine cycle are presented. A computational analysis is performed to evaluate first and second law efficiencies, with the latter providing good guidance for performance improvement. The effect of changing turbocharger pressure ratio, organic Rankine cycle (ORC) evaporator pinch point temperature, turbocharger compressor efficiency, and ambient temperature have been observed on cycle’s first law efficiency, second law efficiency, and exergy destruction in each of its component. A first law efficiency of 41.5% and second law efficiency of 36.9% were obtained for the operating conditions (T0 = 300 K, rp = 3, ηT = 80%). The first law efficiency and second law efficiency of the combined power cycle significantly vary with the change in the turbocharger pressure ratio, but the change in pinch point temperature, turbocharger efficiency, and ambient temperature shows small variations in these efficiencies. Second law analysis demonstrates well how the fuel exergy is used, lost, and reused in all of the cycle components. It was found that 78.9% of the total input exergy is lost: 2.0% to the environment in the flue and 76.9% due to irreversibilities in the components. The biggest exergy loss occurs in the HCCI engine which is 68.7%, and the second largest exergy loss occurs in catalytic converter, i.e., nearly 3.13%. Results clearly show that performance evaluation based on first law analysis alone is not adequate, and hence more meaningful evaluation must include second law analysis.

Solar Energy ◽  
2013 ◽  
Vol 93 ◽  
pp. 100-108 ◽  
Author(s):  
Xinguo Li ◽  
Xiajie Li ◽  
Qilin Zhang

Energies ◽  
2018 ◽  
Vol 11 (11) ◽  
pp. 3032 ◽  
Author(s):  
Xiaoli Yu ◽  
Zhi Li ◽  
Yiji Lu ◽  
Rui Huang ◽  
Anthony Roskilly

An innovative cascade cycle combining a trilateral cycle and an organic Rankine cycle (TLC-ORC) system is proposed in this paper. The proposed TLC-ORC system aims at obtaining better performance of temperature matching between working fluid and heat source, leading to better overall system performance than that of the conventional dual-loop ORC system. The proposed cascade cycle adopts TLC to replace the High-Temperature (HT) cycle of the conventional dual-loop ORC system. The comprehensive comparisons between the conventional dual-loop ORC and the proposed TLC-ORC system have been conducted using the first and second law analysis. Effects of evaporating temperature for HT and Low-Temperature (LT) cycle, as well as different HT and LT working fluids, are systematically investigated. The comparisons of exergy destruction and exergy efficiency of each component in the two systems have been studied. Results illustrate that the maximum net power output, thermal efficiency, and exergy efficiency of a conventional dual-loop ORC are 8.8 kW, 18.7%, and 50.0%, respectively, obtained by the system using cyclohexane as HT working fluid at THT,evap = 470 K and TLT,evap = 343 K. While for the TLC-ORC, the corresponding values are 11.8 kW, 25.0%, and 65.6%, obtained by the system using toluene as a HT working fluid at THT,evap = 470 K and TLT,evap = 343 K, which are 34.1%, 33.7%, and 31.2% higher than that of a conventional dual-loop ORC.


Author(s):  
C. Somayaji ◽  
P. J. Mago ◽  
L. M. Chamra

This paper presents a second law analysis and optimization for the use of Organic Rankine Cycle “ORC” to convert waste energy to power from low grade heat sources. The working fluids used in this study are organic substances which have a low boiling point and a low latent heat for using low grade waste heat sources. The organic working fluids under investigation are R134a and R113 and their results are compared with those of ammonia and water under similar operating conditions. A combined first and second law analysis is performed by varying some system operating parameters at various reference temperatures. Some of the results show that the efficiency of ORC is typically below 20% depending on the temperatures and matched working fluid. In addition, it has been found that organic working fluids are more suited for heat recovery than water for low temperature applications, which justifies the use of organic working fluids at the lower waste source temperatures.


Author(s):  
Wei Gu ◽  
Yiwu Weng

The evaporator is a key component for Organic Rankine Cycle (ORC) system. Second law analysis of the evaporator was carried out in this work. Three processes were included and studied: pre-heating, boiling and super-heating. Firstly, ε–NTU method was applied to study the heat transfer area of evaporator. Then, internal entropy generation for three processes of evaporator was studied by entropy generation number. Thirdly, entropy generation distribution (ds/dA) was predicted by analyzing the temperature difference between the two sides of single stage counter-flow evaporator, for both pure and mixed working fluids. The results show that increase of waste heat fluid temperature increases internal irreversibility, and higher evaporator pressure decreases this irreversibility. The results also show that temperature difference at the end part of boiling process is larger for pure working fluids; and for mixed fluids, because of its’ increasing boiling temperature, this irreversibility decreases remarkably. In conclusion, second law analysis shows that the evaporating pressure plays a key role in evaporator design for ORC system; and both evaporator and working fluid should be well designed to minimize the second law loss.


Sign in / Sign up

Export Citation Format

Share Document