scholarly journals Discussion: “The Local Heat-Transfer Coefficient Around a Heated Horizontal Cylinder in an Intense Sound Field” (Fand, R. M., Roos, J., Cheng, P., and Kaye, J., 1962, ASME J. Heat Transfer, 84, pp. 245–250)

1962 ◽  
Vol 84 (3) ◽  
pp. 250-250
Author(s):  
Paul K. Chang
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Sound Field ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Horizontal Cylinder ◽  
Local Heat Transfer Coefficient

The Local Heat-Transfer Coefficient Around a Heated Horizontal Cylinder in an Intense Sound Field

1962 ◽  
Vol 84 (3) ◽  
pp. 245-250 ◽  
Author(s):  
R. M. Fand ◽  
J. Roos ◽  
P. Cheng ◽  
J. Kaye
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Sound Field ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Horizontal Cylinder ◽  
Local Heat Transfer Coefficient ◽  
The Heat Transfer Coefficient

In order to achieve a better understanding of the physical mechanism of interaction between free convection and sound, an experimental investigation of the local heat-transfer coefficient around the circumference of a heated horizontal cylinder, both in the presence and absence of a strong stationary sound field, has been carried out. The results show that superposition of intense sound upon the free-convection temperature-velocity field about a heated horizontal cylinder increases the heat-transfer coefficient both on the under and upper portions of the cylinder’s surface. In the presence of a sound field for which SPL = 146 db (re 0.0002 microbar) and f = 1500 cps, the maximum measured increases in the local heat-transfer coefficient on the under and upper portions of a 3/4-in-diam cylinder—relative to the free convection case at the same temperature potential—were found to be approximately 250 and 1200 per cent, respectively. A comparison of these results with earlier flow-visualization studies indicates that the relatively large percentage increase in the heat-transfer coefficient on the upper portion of the cylinder is caused by the oscillating vortex flow which is characteristic of thermoacoustic streaming. The reasons for the increase in the heat-transfer coefficient on the lower portion of the cylinder appear to be: (a) An increase in laminar boundary-layer velocities (steady components) in this region; and (b) modification of the boundary-layer temperature profile due to acoustically induced oscillations (unsteady components) within the laminar boundary layer. The experimental data presented can be used to check the validity of future analytical investigations of thermoacoustic phenomena.

Local and Average Heat Transfer Characteristics for a Disk Situated Perpendicular to a Uniform Flow

1985 ◽  
Vol 107 (2) ◽  
pp. 321-326 ◽  
Author(s):  
E. M. Sparrow ◽  
G. T. Geiger
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Stagnation Point ◽  
Radial Distance ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Local Heat Transfer Coefficient ◽  
Average Heat ◽  
Radial Profiles

Wind tunnel experiments were performed to determine both the average heat transfer coefficient and the radial distribution of the local heat transfer coefficient for a circular disk facing a uniform oncoming flow. The experiments covered the range of Reynolds numbers Re from 5000 to 50,000 and were performed using the naphthalene sublimation technique. To complement the experiments, an analysis incorporating both potential flow theory and boundary layer theory was used to predict the stagnation point heat transfer. The measured average Nusselt numbers definitively resolved a deep disparity between information from the literature and yielded the correlation Nu = 1.05 Pr0.36 Re1/2. The radial distributions of the local heat transfer coefficient were found to be congruent when they were normalized by Re1/2. Furthermore, the radial profiles showed that the local coefficient takes on its minimum value at the stagnation point and increases with increasing radial distance from the center of the disk. At the outer edge of the disk, the coefficient is more than twice as large as that at the stagnation point. The theoretical predictions of the stagnation point heat transfer exceeded the experimental values by about 6 percent. This overprediction is similar to that which occurs for cylinders and spheres in crossflow.

Heat Transfer to the Turbulent Separated Flow of Air Downstream of a Step in the Surface of a Plate

1964 ◽  
Vol 86 (2) ◽  
pp. 259-264 ◽  
Author(s):  
R. A. Seban
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Separated Flow ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Local Heat Transfer Coefficient ◽  
Suction Or Injection ◽  
Turbulent Separated Flow

Experiments on a system in which separation of a turbulent boundary layer occurred at a downward step in the surface of a plate and reattached on the plate downstream of the step have produced additional results for the local heat-transfer coefficient and for the velocity and temperature distribution in the separated and reattached regions of the flow. In neither region was there found the kind of similarity near the wall that characterizes flows that are dominated by the friction at the wall, so that even this first element of the usual rationalization of the heat transfer is unavailable for the interpretation of the results. The effect of suction or injection through a slot at the base of the step is also indicated and this demonstrates relatively small effects on both the pressure distribution and the local heat-transfer coefficient.

scholarly journals Studies of Full-Coverage Film Cooling: Part 2 — Measurement of Local Heat Transfer Coefficient

1981 ◽  
Author(s):  
M. Kumada ◽  
M. Hirata ◽  
N. Kasagi
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Flux Ratio ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Local Heat Transfer Coefficient ◽  
Stanton Number ◽  
Temperature Ratio ◽  
Full Coverage

The local heat transfer coefficient of full-coverage film-cooled wall has been measured by using the law of analogy to mass transfer. For this experiment, the technique of sublimation of naphthalene was used. The geometric shape of FCFC plate and the experimental condition were the same as those in Part 1. From these experiments, the effects of the mass flux ratio and non-dimensional injection wall temperature ratio on the local Stanton number are made clear and it is confirmed experimentally that the local Stanton number is a linear function of non-dimensional temperature ratio as expected from the analysis. Furthermore, the local heat transfer coefficient on the backside surface has been obtained and a technique for the improvement of cooling effectiveness is discussed.

Sign in / Sign up

Export Citation Format

Share Document