The Timoshenko Beam With a Moving Load

1968 ◽  
Vol 35 (3) ◽  
pp. 481-488 ◽  
Author(s):  
C. R. Steele

The problem of a semi-infinite Timoshenko beam of an elastic foundation with a step load moving from the supported end at a constant velocity is discussed. Asymptotic solutions are obtained for all ranges of load speed. The solution is shown to approach the “steady-state” solution, except for three speeds at which the steady state does not exist. Previous investigators have considered only the steady-state solution for the moving concentrated load and have indicated that the three speeds are “critical.” It is shown, however, that only the lowest speed is truly critical in that the response increases with time. For the load speed equal to either the shear or bar velocity, the transients due to the end condition never leave the vicinity of the load discontinuities, so a steady-state condition is never attained. However, the response is shown to be bounded in time for a distributed load. Thus the nonexistence of a steady state does not necessarily indicate a critical condition. Furthermore, the concentrated load solution is shown to have validity at speeds the magnitude of the sonic speeds only for loads of a concentration beyond the limitations of beam theory. Asymptotic results have also been obtained for the beam without a foundation. Since the procedure is similar for beams with, and without, a foundation, only the results are included to show a comparison with the numerical results previously obtained by Florence.

1996 ◽  
Vol 118 (3) ◽  
pp. 277-284 ◽  
Author(s):  
S. F. Felszeghy

The response of a simply supported semi-infinite Timoshenko beam on an elastic foundation to a moving step load is determined. The response is found from summing the solutions to two mutually complementary sets of governing equations. The first solution is a particular solution to the forced equations of motion. The second solution is a solution to a set of homogeneous equations of motion and nonhomogeneous boundary conditions so formulated as to satisfy the initial and boundary conditions of the actual problem when the two solutions are summed. As a particular solution, the steady-state solution is used which is the motion that would appear stationary to an observer traveling with the load. Steady-state solutions are developed in Part 1 of this article for all load speeds greater than zero. It is shown that a steady-state solution which is identically zero ahead of the load front exists at every load speed, in the sense of generalized functions, including the critical speeds when the load travels at the minimum phase velocity of propagating harmonic waves and the sonic speeds. The solution to the homogeneous equations of motion is developed in Part 2 where the two solutions in question are summed and numerical results are presented as well.


1967 ◽  
Vol 34 (1) ◽  
pp. 111-118 ◽  
Author(s):  
C. R. Steele

A “method of images” series solution is obtained which converges rapidly for a simply supported, long beam with a high-velocity, moving concentrated load. Each term of the series is a Fourier integral solution for an appropriate semi-infinite beam problem. The integrals are evaluated in closed form for the beam without a foundation and have a simple asymptotic evaluation for the beam with an elastic foundation. In particular, the asymptotic results provide a solution for the “critical” load velocity, for which a “steady-state” solution does not exist, and for the limiting case of infinite load velocity, for which the beam is given an initial uniform lateral velocity.


1996 ◽  
Vol 118 (3) ◽  
pp. 285-291 ◽  
Author(s):  
S. F. Felszeghy

The transient response of a simply supported semi-infinite Timoshenko beam on an elastic foundation to a moving step load is determined. The response is found from summing the solutions to two mutually complementary sets of governing equations. The first solution is a particular solution to the forced equations of motion. The second solution is a solution to a set of homogeneous equations of motion and nonhomogeneous boundary conditions so formulated as to satisfy the initial and boundary conditions of the actual problem when the two solutions are summed. As a particular solution, the steady-state solution is used which is the motion that would appear stationary to an observer traveling with the load. Steady-state solutions were developed in Part 1 of this article for all load speeds greater than zero. The solution to the homogeneous equations of motion is developed here in Part 2. It is shown that the latter solution can be obtained by numerical integration using the method of characteristics. Particular attention is given to the cases when the load travels at the critical speeds consisting of the minimum phase velocity of propagating harmonic waves and the sonic speeds. It is shown that the solution to the homogeneous equations combines with the steady-state solution in such a manner that the beam displacements are continuous and bounded for all finite times at all load speeds including the critical speeds. Numerical results are presented for the critical load speed cases.


1965 ◽  
Vol 32 (4) ◽  
pp. 788-792 ◽  
Author(s):  
M. J. Forrestal ◽  
G. Herrmann

An infinitely long, circular, cylindrical shell is submerged in an acoustic medium and subjected to a plane, axially propagating step wave. The fluid-shell interaction is approximated by neglecting fluid motions in the axial direction, thereby assuming that cylindrical waves radiate away from the shell independently of the axial coordinate. Rotatory inertia and transverse shear deformations are included in the shell equations of motion, and a steady-state solution is obtained by combining the independent variables, time and the axial coordinate, through a transformation that measures the shell response from the advancing wave front. Results from the steady-state solution for the case of steel shells submerged in water are presented using both the Timoshenko-type shell theory and the bending shell theory. It is shown that previous solutions, which assumed plane waves radiated away from the vibrating shell, overestimated the dumping effect of the fluid, and that the inclusion of transverse shear deformations and rotatory inertia have an effect on the response ahead of the wave front.


2019 ◽  
Vol 3 (1) ◽  
pp. 26 ◽  
Author(s):  
Vishnu Sidaarth Suresh

Load flow studies are carried out in order to find a steady state solution of a power system network. It is done to continuously monitor the system and decide upon future expansion of the system. The parameters of the system monitored are voltage magnitude, voltage angle, active and reactive power. This paper presents techniques used in order to obtain such parameters for a standard IEEE – 30 bus and IEEE-57 bus network and makes a comparison into the differences with regard to computational time and effectiveness of each solver


Sign in / Sign up

Export Citation Format

Share Document