Discussion: “Mechanism of Lubrication by Surrounding Gas Molecules in Adhesive Wear” (Soda, Norimune, and Sasada, Tadashi, 1978, ASME J. Lubr. Technol., 100, pp. 492–499)

1978 ◽  
Vol 100 (4) ◽  
pp. 499-499
Author(s):  
E. Rabinowicz ◽  
N. Ohmae
Keyword(s):  
Adhesive Wear ◽  
Gas Molecules

Mechanism of Lubrication by Surrounding Gas Molecules in Adhesive Wear

1978 ◽  
Vol 100 (4) ◽  
pp. 492-499 ◽  
Author(s):  
Norimune Soda ◽  
Tadashi Sasada
Keyword(s):  
Transition Point ◽  
Adhesive Wear ◽  
Contact Point ◽  
Free Time ◽  
Fundamental Relation ◽  
Clean Surface ◽  
Critical Transition ◽  
Contact Points ◽  
The Mean ◽  
Gas Molecules

To explain quantitatively the lubricating effect of gas molecules on adhesive wear, the authors have introduced a new concept of mean free time of a small contact point. When a bridge formed between two contact points is sheared off and a small clean surface is exposed to surrounding gases, it must have a free time t until it forms the next bridge when sliding. During this time t, the gas molecules attack the clean spot and can easily form a chemisorbed monolayer when the contact pressure p is low or when the sliding speed v is low. The authors have verified the fundamental relation between the mean free time t and the value pv, and have found that the critical transition point from the mild to severe wear corresponds to the condition where the mean free time of a sheared junction is just enough to be covered by the chemisorbed monolayer of surrounding gas molecules.

The effects of surface absorbed monolayer microdiffraction patterns

1988 ◽  
Vol 46 ◽  
pp. 680-681
Author(s):  
M. Pan ◽  
J.M. Cowley
Keyword(s):  
Surface Potential ◽  
Electron Probe ◽  
Potential Distribution ◽  
Crystal Surface ◽  
Normal Direction ◽  
Surface Image ◽  
Extended Surface ◽  
Gas Molecules ◽  
Surface Nature ◽  
Electron Microdiffraction

Electron microdiffraction patterns, obtained when a small electron probe with diameter of 10-15 Å is directed to run parallel to and outside a flat crystal surface, are sensitive to the surface nature of the crystals. Dynamical diffraction calculations have shown that most of the experimental observations for a flat (100) face of a MgO crystal, such as the streaking of the central spot in the surface normal direction and (100)-type forbidden reflections etc., could be explained satisfactorily by assuming a modified image potential field outside the crystal surface. However the origin of this extended surface potential remains uncertain. A theoretical analysis by Howie et al suggests that the surface image potential should have a form different from above-mentioned image potential and also be smaller by several orders of magnitude. Nevertheless the surface potential distribution may in practice be modified in various ways, such as by the adsorption of a monolayer of gas molecules.

Principles of Low-Vacuum SEM

1992 ◽  
Vol 50 (2) ◽  
pp. 1304-1305
Author(s):  
Klaus-Ruediger Peters
Keyword(s):  
New Technologies ◽  
High Vacuum ◽  
Optical Microscope ◽  
Specimen Surface ◽  
Electrical Field ◽  
Gaseous Environment ◽  
New Information ◽  
Gas Molecules ◽  
New Interactions ◽  
Gas Pressures

Only recently it became possible to expand scanning electron microscopy to low vacuum and atmospheric pressure through the introduction of several new technologies. In principle, only the specimen is provided with a controlled gaseous environment while the optical microscope column is kept at high vacuum. In the specimen chamber, the gas can generate new interactions with i) the probe electrons, ii) the specimen surface, and iii) the specimen-specific signal electrons. The results of these interactions yield new information about specimen surfaces not accessible to conventional high vacuum SEM. Several microscope types are available differing from each other by the maximum available gas pressure and the types of signals which can be used for investigation of specimen properties.Electrical non-conductors can be easily imaged despite charge accumulations at and beneath their surface. At high gas pressures between 10-2 and 2 torr, gas molecules are ionized in the electrical field between the specimen surface and the surrounding microscope parts through signal electrons and, to a certain extent, probe electrons. The gas provides a stable ion flux for a surface charge equalization if sufficient gas ions are provided.

Environmental cell studies of deformation and fracture

1990 ◽  
Vol 48 (4) ◽  
pp. 516-517
Author(s):  
H. K. Birnbaum ◽  
I. M. Robertson
Keyword(s):  
National Laboratory ◽  
Argonne National Laboratory ◽  
Damage Threshold ◽  
Chromatic Aberration ◽  
Good Choice ◽  
Point Of View ◽  
Deformation And Fracture ◽  
Environmental Cell ◽  
Gas Molecules ◽  
The University

Studies of the effects of hydrogen environments on the deformation and fracture of fcc, bcc and hep metals and alloys have been carried out in a TEM environmental cell. The initial experiments were performed in the environmental cell of the HVEM facility at Argonne National Laboratory. More recently, a dedicated environmental cell facility has been constructed at the University of Illinois using a JEOL 4000EX and has been used for these studies. In the present paper we will describe the general design features of the JEOL environmental cell and some of the observations we have made on hydrogen effects on deformation and fracture.The JEOL environmental cell is designed to operate at 400 keV and below; in part because of the available accelerating voltage of the microscope and in part because the damage threshold of most materials is below 400 keV. The gas pressure at which chromatic aberration due to electron scattering from the gas molecules becomes excessive does not increase rapidly with with accelerating voltage making 400 keV a good choice from that point of view as well. A series of apertures were placed above and below the cell to control the pressures in various parts of the column.

Recent Progress In High-Resolution Shadowing For Biological Transmission Electron Microscopy

1990 ◽  
Vol 48 (1) ◽  
pp. 510-511 ◽  
Author(s):  
Heinz Gross ◽  
Katarina Krusche ◽  
Peter Tittmann
Keyword(s):  
Heavy Metal ◽  
High Resolution ◽  
Freeze Drying ◽  
Atmospheric Conditions ◽  
Vacuum Equipment ◽  
Transmission Electron ◽  
Gas Atmosphere ◽  
Gas Molecules ◽  
Residual Gas ◽  
Backing Layer

Freeze-drying followed by heavy metal shadowing is a long established and straight forward approach to routinely study the structure of dehydrated macromolecules. Very thin specimens such as isolated membranes or single macromolecules are directly adsorbed on C-coated grids. After rapid freezing the grids are transferred into a suitable vacuum equipment for freeze-drying and heavy metal shadowing.To improve the resolution power of shadowing films we introduced shadowing at very low specimen temperature (−250°C). To routinely do that without the danger of contamination we developed in collaboration with Balzers an UHV (p≤10-9 mbar) machine (BAF500K, Fig.2). It should be mentioned here that at −250°C the specimen surface acts as effective cryopump for practically all impinging residual gas molecules from the residual gas atmosphere.Common high resolution shadowing films (Pt/C, Ta/W) have to be protected from alterations due to air contact by a relatively thick C-backing layer, when transferred via atmospheric conditions into the TEM. Such an additional C-coat contributes disturbingly to the contrast at high resolution.

Two Consecutive Magneto-Structural Gas-Solid Transformations with Single-Crystal Retention in Non-Porous Molecular Materials

2018 ◽  
Author(s):  
Julia Miguel-Donet ◽  
Javier López-Cabrelles ◽  
Nestor Calvo Galve ◽  
Eugenio Coronado ◽  
Guillermo Minguez Espallargas
Keyword(s):  
Solid State ◽  
Single Crystal ◽  
Structural Rearrangement ◽  
Magnetic Behaviour ◽  
Porous Solids ◽  
Potential Applications ◽  
Hcl Gas ◽  
Porous Coordination Polymer ◽  
Gas Molecules ◽  
Magnetostructural Transformation

<p>Modification of the magnetic properties in a solid-state material upon external stimulus has attracted much attention in the recent years for their potential applications as switches and sensors. Within the field of coordination polymers, gas sorption studies typically focus on porous solids, with the gas molecules accommodating in the channels. Here we present a 1D non-porous coordination polymer capable of incorporating HCl gas molecules, which not only causes a reordering of its atoms in the solid state but also provokes dramatic changes in the magnetic behaviour. Subsequently, a further solid-gas transformation can occur with the extrusion of HCl gas molecules causing a second structural rearrangement which is also accompanied by modification in the magnetic path between the metal centres. Unequivocal evidence of the two-step magnetostructural transformation is provided by X-ray single-crystal diffraction.</p>

Sign in / Sign up

Export Citation Format

Share Document