Experimental Investigation of Natural Convection in Inclined Rectangular Regions of Differing Aspect Ratios

1976 ◽  
Vol 98 (1) ◽  
pp. 67-71 ◽  
Author(s):  
J. N. Arnold ◽  
I. Catton ◽  
D. K. Edwards
Keyword(s):  
Heat Transfer ◽  
Experimental Investigation ◽  
Natural Convection ◽  
Scaling Law ◽  
Convection Heat Transfer ◽  
Theoretical Work ◽  
Natural Convection Heat Transfer ◽  
Aspect Ratios ◽  
Simple Scaling ◽  
Rayleigh Numbers

An experimental investigation of steady natural convection heat transfer was carried out for finite rectangular regions. The effect of angle of inclination on heat transfer across rectangular regions of several aspect ratios was measured for Rayleigh numbers between 103 and 106. The angle of inclination varied from 0 deg (heated from above) to 180 deg (heated from below) with aspect ratios of one, three, six, and twelve. Comparison is made with past theoretical work, and a simple scaling law is derived which is valid for angles of inclination from 0 to 90 deg (vertical).

Natural Convection Heat Transfer From Horizontal Rectangular Ducts

2006 ◽  
Vol 129 (9) ◽  
pp. 1195-1202 ◽  
Author(s):  
Mohamed E. Ali
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Convection Heat Transfer ◽  
Natural Convection Heat Transfer ◽  
Convection Heat ◽  
Transfer Coefficients ◽  
Heat Transfer Coefficients ◽  
Nusselt Numbers ◽  
Aspect Ratios ◽  
Rayleigh Numbers

Experimental investigations have been reported on steady state natural convection from the outer surface of horizontal ducts in air. Five ducts have been used with aspect ratios (Γ=duct height/duct width) of 2, 1, and 0.5. The ducts are heated using internal constant heat flux heating elements. The temperatures along the surface and peripheral directions of the duct wall are measured. Longitudinal (circumference averaged) heat transfer coefficients along the side of each duct are obtained for laminar and transition regimes of natural convection heat transfer. Total overall averaged heat transfer coefficients are also obtained. Longitudinal (circumference averaged) Nusselt numbers are evaluated and correlated using the modified Rayleigh numbers for transition regime using the axial distance as a characteristic length. Furthermore, total overall averaged Nusselt numbers are correlated with the modified Rayleigh numbers, the aspect ratio, and area ratio for the laminar and transition regimes. The longitudinal or total averaged heat transfer coefficients are observed to decrease in the laminar region and to increase in the transition region. Laminar regimes are obtained only at very small heat fluxes, otherwise, transitions are observed.

Three Dimensional Numerical Simulation of the Natural Convection in an Annulus With an Internal Slotted Cylinder

2011 ◽  
Author(s):  
Mo Yang ◽  
Jin Wang ◽  
Kun Zhang ◽  
Ling Li ◽  
Yuwen Zhang
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Numerical Solutions ◽  
Three Dimensional ◽  
Convection Heat Transfer ◽  
Natural Convection Heat Transfer ◽  
Dimensional Model ◽  
Heat Transfer Characteristics ◽  
Flow And Heat Transfer ◽  
Rayleigh Numbers

Detailed numerical analysis is presented for three-dimensional natural convection heat transfer in annulus with an internal concentric slotted cylinder. The internal slotted cylinder and the outer annulus are maintained at uniform but different temperatures. Governing equations are discretized using control volume technique based on staggered grid formulation and solved using SIMPLE algorithm with QUICK scheme. Flow and heat transfer characteristics are investigated for a Rayleigh number range of 10 to 106 while Prandtl number (Pr) is taken to be 0.7. The results indicate, at Rayleigh numbers below 105, the system shows two dimensional flow and heat transfer characteristics. On the other hand, the flow and heat transfer shows three dimensional characteristics while for Rayleigh numbers greater than 5×105. Comparison with experimental results indicated that the numerical solutions by three dimensional model can obtain more accuracy than the numerical solutions by two dimensional model. Besides, Numerical results show that the average equivalent conductivity coefficient of natural convection heat transfer of this problem can be enhanced by as much as 30% while relative slot width is more than 0.1.

Effect of Wall Heat Conduction on Natural Convection Heat Transfer in a Square Enclosure

1985 ◽  
Vol 107 (1) ◽  
pp. 139-146 ◽  
Author(s):  
D. M. Kim ◽  
R. Viskanta
Keyword(s):  
Heat Transfer ◽  
Heat Conduction ◽  
Natural Convection ◽  
Solid Wall ◽  
Convection Heat Transfer ◽  
Natural Convection Heat Transfer ◽  
Convection Heat ◽  
Square Enclosure ◽  
Void Fractions ◽  
Aspect Ratios

This paper presents numerical and experimental results for buoyancy-induced flow in a two-dimensional, fluid-filled enclosure. Rectangular cavities formed by finite conductance walls of different void fractions and aspect ratios are considered. Parametric heat transfer calculations have been performed and results are presented and discussed. Local and average Nusselt numbers along the cavity walls are reported for a range of parameters of physical interest. The temperatures in the walls were measured with thermocouples, and the temperature distributions in the air-filled cavity were determined using a Mach-Zehnder interferometer. Good agreement has been obtained between the measured and the predicted temperatures in both the solid wall and in the fluid using the mathematical model. Wall heat conduction reduces the average temperature differences across the cavity, partially stabilizes the flow, and decreases natural convection heat transfer.

scholarly journals Heat Transfer Performance of Different Fluids During Natural Convection in Enclosures with Varying Aspect Ratios

2021 ◽  
Vol 287 ◽  
pp. 03010
Author(s):  
Rajashekhar Pendyala ◽  
Suhaib Umer Ilyas ◽  
Yean Sang Wong
Keyword(s):  
Heat Transfer ◽  
Nusselt Number ◽  
Natural Convection ◽  
Heat Transfer Performance ◽  
Convection Heat Transfer ◽  
Heat Transfer Process ◽  
Natural Convection Heat Transfer ◽  
Transfer Performance ◽  
Convection Heat ◽  
Aspect Ratios

The heat transfer process takes place in numerous applications through the natural convection of fluids. Investigations of the natural convection heat transfer in enclosures have gained vital importance in the last decade for the improvement in thermal performance and design of the heating/cooling systems. Aspect ratios (AR=height/length) of the enclosures are one of the crucial factors during the natural convection heat transfer process. The investigated fluids consisting of air, water, engine oil, mercury, and glycerine have numerous engineering applications. Heat transfer and fluid flow characteristics are studied in 3-dimensional rectangular enclosures with varying aspect ratios (0.125 to 150) using computational fluid dynamics (CFD) simulations. Studies are carried out using the five different fluids having Prandtl number range 0.01 to 4500 in rectangular enclosures with the hot and cold surface with varying temperature difference 20K to 100K. The Nusselt number and heat transfer coefficients are estimated at all conditions to understand the dependency of ARs on the heat transfer performance of selected fluids. Temperature and velocity profiles are compared to study the flow pattern of different fluids during natural convection. The Nusselt number correlations are developed in terms of aspect ratio and Rayleigh number to signify the natural convection heat transfer performance.

Sign in / Sign up

Export Citation Format

Share Document