Unsteady Heat Transfer for Turbulent Boundary Layer Flow With Time Dependent Wall Temperature

1974 ◽  
Vol 96 (1) ◽  
pp. 117-118 ◽  
Author(s):  
L. C. Thomas ◽  
B. T. F. Chung
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Wall Temperature ◽  
Boundary Layer Flow ◽  
Time Dependent ◽  
Unsteady Heat Transfer ◽  
Turbulent Boundary Layer Flow ◽  
Layer Flow

A Numerical Study of Turbulent Boundary Layer Flow Over a Flat Surface With a Single Dimple

2000 ◽  
Author(s):  
Mark E. Kithcart ◽  
David E. Klett
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Boundary Layer Flow ◽  
Flat Surface ◽  
Numerical Study ◽  
Heat Transfer Augmentation ◽  
Study Results ◽  
Turbulent Boundary Layer Flow ◽  
Layer Flow

Abstract Turbulent boundary layer flow over a flat surface with a single dimple has been investigated numerically using the FLUENT CFD software package, and compared to an experiment by Ezerskii and Shekhov [1989], which studied the same configuration. The impetus for this work developed as a result of previous studies. Kithcart and Klett [1996], and Afanas’yev and Chudnovskiy [1992], showed that dimpled surfaces enhance heat transfer comparably to surfaces with protrusion roughness elements, but with a much lower drag penalty. However, the actual physical mechanisms involved in this phenomena were only partially known prior this study. Results obtained numerically are in good agreement with the experiment, most notably the confirmation of the existence of a region of enhanced heat transfer created by interaction of the flow with the dimple. In particular, the simulation indicates that heat transfer augmentation is a consequence of the development of a stagnation flow region within the dimple geometry, and the existence of coherent vortical structures which create a periodic flow-field within and immediately downstream of the dimple. This periodicity appears to govern the magnitude of the heat transfer augmentation.

Influence of Free-Stream Turbulence on Turbulent Boundary Layer Heat Transfer and Mean Profile Development, Part I—Experimental Data

1983 ◽  
Vol 105 (1) ◽  
pp. 33-40 ◽  
Author(s):  
M. F. Blair
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Boundary Layer Flow ◽  
Free Stream ◽  
Full Range ◽  
Stream Velocity ◽  
Free Stream Turbulence ◽  
Turbulent Boundary Layer Flow ◽  
Layer Flow

An experimental research program was conducted to determine the influence of free-stream turbulence on zero pressure gradient, fully turbulent boundary layer flow. Connective heat transfer coefficients and boundary layer mean velocity and temperature profile data were obtained for a constant free-stream velocity of 30 m/s and free-stream turbulence intensities ranging from approximately 1/4 to 7 percent. Free-stream multicomponent turbulence intensity, longitudinal integral scale, and spectral distributions were obtained for the full range of turbulence levels. The test results with 1/4 percent free-stream turbulence indicate that these data were in excellent agreement with classic two-dimensional, low free-stream turbulence, turbulent boundary layer correlations. For fully turbulent boundary layer flow, both the skin friction and heat transfer were found to be substantially increased (up to ∼ 20 percent) for the higher levels of free-stream turbulence. Detailed results of the experimental study are presented in the present paper (Part I). A comprehensive analysis is provided in a companion paper (Part II).

Effect of Reynolds number on drag reduction in turbulent boundary layer flow over liquid–gas interface

2020 ◽  
Vol 32 (12) ◽  
pp. 122111
Author(s):  
Hongyuan Li ◽  
SongSong Ji ◽  
Xiangkui Tan ◽  
Zexiang Li ◽  
Yaolei Xiang ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Turbulent Boundary Layer ◽  
Drag Reduction ◽  
Boundary Layer Flow ◽  
Turbulent Boundary Layer Flow ◽  
Layer Flow
Sign in / Sign up

Export Citation Format

Share Document