Influence of Free-Stream Turbulence on Turbulent Boundary Layer Heat Transfer and Mean Profile Development, Part II—Analysis of Results

1983 ◽  
Vol 105 (1) ◽  
pp. 41-47 ◽  
Author(s):  
M. F. Blair
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Skin Friction ◽  
Free Stream ◽  
Distribution Data ◽  
Stream Velocity ◽  
Mean Velocity ◽  
Reynolds Analogy ◽  
Free Stream Turbulence

An experimental research program was conducted to determine the influence of free-stream turbulence on zero pressure gradient, fully turbulent boundary layer flow. In Part I of this paper, convective heat transfer coefficients, boundary layer mean velocity and temperature profile data, as well as wall skin friction coefficient distribution data were presented for five flow conditions of constant free-stream velocity (30 m/s) and free-stream turbulence intensities ranging from approximately 1/4 to 7 percent. These data indicated that the turbulence had significant effects on both the turbulent boundary layer skin friction and heat transfer. In the current paper, these new data are compared to various independent experimental data and analytical correlations of free-stream turbulence effects. This analysis has shown that the effects documented in Part I were a function of the freestream turbulence intensity, the turbulence length scale, and the boundary layer momentum thickness Reynolds number. In addition, the Reynolds analogy factor (2St/cf) was shown to increase by just over 1 percent for each 1 percent increase in free-stream turbulence level. New correlations for the influence of free-stream turbulence on skin friction, heat transfer, and the Reynolds analogy factor are presented.

Influence of Free-Stream Turbulence on Turbulent Boundary Layer Heat Transfer and Mean Profile Development, Part I—Experimental Data

1983 ◽  
Vol 105 (1) ◽  
pp. 33-40 ◽  
Author(s):  
M. F. Blair
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Boundary Layer Flow ◽  
Free Stream ◽  
Full Range ◽  
Stream Velocity ◽  
Free Stream Turbulence ◽  
Turbulent Boundary Layer Flow ◽  
Layer Flow

An experimental research program was conducted to determine the influence of free-stream turbulence on zero pressure gradient, fully turbulent boundary layer flow. Connective heat transfer coefficients and boundary layer mean velocity and temperature profile data were obtained for a constant free-stream velocity of 30 m/s and free-stream turbulence intensities ranging from approximately 1/4 to 7 percent. Free-stream multicomponent turbulence intensity, longitudinal integral scale, and spectral distributions were obtained for the full range of turbulence levels. The test results with 1/4 percent free-stream turbulence indicate that these data were in excellent agreement with classic two-dimensional, low free-stream turbulence, turbulent boundary layer correlations. For fully turbulent boundary layer flow, both the skin friction and heat transfer were found to be substantially increased (up to ∼ 20 percent) for the higher levels of free-stream turbulence. Detailed results of the experimental study are presented in the present paper (Part I). A comprehensive analysis is provided in a companion paper (Part II).

Boundary Layer Transition Under High Free-Stream Turbulence and Strong Acceleration Conditions: Part 1—Mean Flow Results

1997 ◽  
Vol 119 (3) ◽  
pp. 420-426 ◽  
Author(s):  
R. J. Volino ◽  
T. W. Simon
Keyword(s):  
Boundary Layer ◽  
Skin Friction ◽  
Free Stream ◽  
Boundary Layer Transition ◽  
Temperature Profiles ◽  
Mean Flow ◽  
Transfer Coefficients ◽  
Mean Velocity ◽  
Layer Transition ◽  
Free Stream Turbulence

Measurements from heated boundary layers along a concave-curved test wall subject to high (initially 8 percent) free-stream turbulence intensity and strong (K = (ν/U∞2) dU∞/dx) as high as 9 × 10−6) acceleration are presented and discussed. Conditions for the experiments were chosen to roughly simulate those present on the downstream half of the pressure side of a gas turbine airfoil. Mean velocity and temperature profiles as well as skin friction and heat transfer coefficients are presented. The transition zone is of extended length in spite of the high free-stream turbulence level. Transitional values of skin friction coefficients and Stanton numbers drop below flat-plate, low-free-stream-turbulence, turbulent flow correlations, but remain well above laminar flow values. The mean velocity and temperature profiles exhibit clear changes in shape as the flow passes through transition. To the authors’ knowledge, this is the first detailed documentation of a high-free-stream-turbulence boundary layer flow in such a strong acceleration field.

scholarly journals Comparison of k-ε Models in Predicting Heat Transfer and Skin Friction Under High Free Stream Turbulence

1996 ◽  
Author(s):  
Ganesh R. Iyer ◽  
Savash Yavuzkurt
Keyword(s):  
Heat Transfer ◽  
Experimental Data ◽  
Boundary Layer ◽  
Skin Friction ◽  
Turbulence Intensity ◽  
Free Stream ◽  
Skin Friction Coefficient ◽  
Empirical Correlations ◽  
Free Stream Turbulence ◽  
Boundary Layer Equations

Calculations of the effects of high free stream turbulence (FST) on heat transfer and skin friction in a flat plate turbulent boundary layer using different k-ε models (Launder-Sharma, K-Y Chien, Lam-Bremhorsi and Jones-Launder) are presented. This study was carried out in order to investigate the prediction capabilities of these models under high FST conditions. In doing so, TEXSTAN, a partial differential equation solver which is based on the ideas of Patankar and Spalding and solves steady-flow boundary layer equations, was used. Firstly, these models were compared as to how they predicted very low FST (≤ 1% turbulence intensity) cases. These baseline cases were tested by comparing predictions with both experimental data and empirical correlations. Then, these models were used in order to determine the effect of high FST (>5% turbulence intensity) on heat transfer and skin friction and compared with experimental data. Predictions for heat transfer and skin friction coefficient for all the turbulence intensities tested by all the models agreed well (within 1–8%) with experimental data. However, all these models predicted poorly the dissipation of turbulent kinetic energy (TKE) in the free stream and TKE profiles. Physical reasoning as to why the aforementioned models differ in their predictions and the probable cause of poor prediction of free-stream TKE and TKE profiles are given.

Skin Friction and Heat Transfer for Laminar Boundary-Layer Flow With Variable Properties and Variable Free-Stream Velocity

1953 ◽  
Vol 20 (3) ◽  
pp. 415-421
Author(s):  
S. Levy ◽  
R. A. Seban
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Prandtl Number ◽  
Skin Friction ◽  
Laminar Boundary Layer ◽  
Boundary Layer Flow ◽  
Free Stream ◽  
Free Stream Velocity ◽  
Stream Velocity ◽  
Layer Flow

Abstract Numerical solutions of the momentum and energy equations are presented for particular types of laminar boundary-layer flow analogous to the Hartree “wedge flows.” Variation of the viscosity and of the thermal conductivity is considered under the circumstances of no dissipation, favorable pressure gradient, and the product of conductivity and density a constant. The solution is based on approximate representations of the velocity and temperature profiles in the boundary layer and these are of such character that the labor of calculation is minimized and the accuracy of the results preserved. The differential equations are reduced to two algebraic equations which rapidly yield the skin friction and the heat transfer in terms of the wall to free-stream temperature ratio for the desired value of Prandtl number. Numerical results are given for a range of wedge flows with gases of Prandtl number 0.70 and 1.0. These results reveal that when the free-stream velocity is variable the temperature difference between the wall and the free stream exerts a substantial effect on the velocity distribution in the boundary layer and on the skin-friction coefficient. Alternatively, the heat-transfer coefficient is not affected radically. A calculation method is presented for the determination of the heat transfer and skin friction for a flow with an arbitrary variation of velocity over an isothermal surface. This method utilizes the results of the present analysis for the variable property wedge flows.

Velocity Distributions, Temperature Distributions, Effectiveness and Heat Transfer for Air Injected Through a Tangential Slot Into a Turbulent Boundary Layer

1961 ◽  
Vol 83 (3) ◽  
pp. 293-305 ◽  
Author(s):  
J. P. Hartnett ◽  
R. C. Birkebak ◽  
E. R. G. Eckert
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Free Stream ◽  
Injection Rate ◽  
Stream Velocity ◽  
Plate Temperature ◽  
Wall Boundary Conditions ◽  
Slot Size ◽  
Layer Velocity

A detailed study of the heat transfer for tangential air injection through a single slot into a turbulent boundary layer on a flat plate is presented; the results apply to a specific slot size, one injection rate, and a fixed free-stream velocity. Boundary-layer velocity and temperature profiles for a number of positions downstream from the point of injection are presented as well as plate-temperature distribution and heat-transfer data for adiabatic and constant heat input-wall boundary conditions.

Sign in / Sign up

Export Citation Format

Share Document