Closure to “Discussion of ‘Temperature Effects on Single Bubble Collapse and Induced Impulsive Pressure’” (1988, ASME J. Fluids Eng., 110, p. 344)

1988 ◽  
Vol 110 (3) ◽  
pp. 344-344 ◽  
Author(s):  
A. Shima ◽  
Y. Tomita ◽  
T. Ohno
1988 ◽  
Vol 110 (2) ◽  
pp. 194-199 ◽  
Author(s):  
A. Shima ◽  
Y. Tomita ◽  
T. Ohno

In relation to the temperature effect in cavitation damage, the collapse of a single bubble in water over a wide range of temperatures was experimentally studied. A spark-induced bubble was observed by using a high speed camera and the impulsive pressure caused by the bubble collapse was measured by means of a pressure transducer. As water temperature increases, the motion of a bubble tends to weaken owing to the increase in saturated vapor pressure of water, and the surface configuration of a bubble becomes highly irregular because of thermal instability. The impulsive pressure depends not only on the bubble size and its distance from a solid wall but also on the water temperature. When the water temperature approaches the boiling point of water, the impulsive pressure abruptly decreases with increasing water temperature. The evidence obtained seems to be associated with the known temperature effect on cavitation damage at high water temperature.


2015 ◽  
Vol 656 ◽  
pp. 012043 ◽  
Author(s):  
C Ji ◽  
B Li ◽  
F Y Lin ◽  
J Zou

2014 ◽  
Vol 755 ◽  
pp. 142-175 ◽  
Author(s):  
Chao-Tsung Hsiao ◽  
A. Jayaprakash ◽  
A. Kapahi ◽  
J.-K. Choi ◽  
Georges L. Chahine

AbstractMaterial pitting from cavitation bubble collapse is investigated numerically including two-way fluid–structure interaction (FSI). A hybrid numerical approach which links an incompressible boundary element method (BEM) solver and a compressible finite difference flow solver is applied to capture non-spherical bubble dynamics efficiently and accurately. The flow codes solve the fluid dynamics while intimately coupling the solution with a finite element structure code to enable simulation of the full FSI. During bubble collapse high impulsive pressures result from the impact of the bubble re-entrant jet on the material surface and from the collapse of the remaining bubble ring. A pit forms on the material surface when the impulsive pressure is large enough to result in high equivalent stresses exceeding the material yield stress. The results depend on bubble dynamics parameters such as the size of the bubble at its maximum volume, the bubble standoff distance from the material wall, and the pressure driving the bubble collapse. The effects of these parameters on the re-entrant jet, the following bubble ring collapse pressure, and the generated material pit characteristics are investigated.


2006 ◽  
Vol 41 (3) ◽  
pp. 365-373 ◽  
Author(s):  
Yi-Chun Wang ◽  
Ching-Hung Huang ◽  
Yung-Chun Lee ◽  
Ho-Hsun Tsai

2021 ◽  
Vol 33 (7) ◽  
pp. 073311
Author(s):  
Xiaobin Yang ◽  
Cheng Liu ◽  
Decheng Wan ◽  
Changhong Hu

Sign in / Sign up

Export Citation Format

Share Document