An Experiment Concerning the Confluence of a Wake and a Boundary Layer

1982 ◽  
Vol 104 (1) ◽  
pp. 18-23 ◽  
Author(s):  
F. Bario ◽  
G. Charnay ◽  
K. D. Papailiou

Measurements have been performed at low speed in the confluent region of a two dimensional wake and turbulent boundary layer. A tandem symmetrical arrangement was used, placed in a variable pressure gradient wind tunnel. Pressure and turbulent quantities were measured and current semi-empirical laws were examined in the light of the experimental results.

1981 ◽  
Vol 48 (4) ◽  
pp. 701-706 ◽  
Author(s):  
W.-S. Yeung ◽  
R.-J. Yang

The orthonormal version of the Method of Integral Relations (MIR) was applied to solve for a two-dimensional incompressible turbulent boundary layer. The flow was assumed to be nonseparating. Flows with favorable, unfavorable, and zero pressure gradient were considered, and comparisons made with available experimental data. In general, the method predicted very well the experimental results for flows with favorable or zero pressure gradient; for flows with unfavorable pressure gradient, it predicted the experimental data well only up to a certain distance from the initial station. This result is due to the flow not being in equilibrium beyond that distance. Finally, the scheme was shown to be efficient in obtaining numerical solutions.


1974 ◽  
Vol 64 (3) ◽  
pp. 529-564 ◽  
Author(s):  
J. Counihan ◽  
J. C. R. Hunt ◽  
P. S. Jackson

By making simple assumptions, an analytical theory is deduced for the mean velocity behind a two-dimensional obstacle (of heighth) placed on a rigid plane over which flows a turbulent boundary layer (of thickness δ). It is assumed thath[Gt ] δ, and that the wake can be divided into three regions. The velocity deficit −uis greatest in the two regions in which the change in shear stress is important, a wall region (W) close to the wall and a mixing region (M) spreading from the top of the obstacle. Above these is the external region (E) in which the velocity field is an inviscid perturbation on the incident boundary-layer velocity, which is taken to have a power-law profileU(y) =U∞(y−y1)n/δn, wheren[Gt ] 1. In (M), assuming that an eddy viscosity (=KhU(h)) can be defined for the perturbed flow in terms of the incident boundary-layer flow and that the velocity is self-preserving, it is found thatu(x,y) has the form$\frac{u}{U(h)} = \frac{ C }{Kh^2U^2(h)} \frac{f(n)}{x/h},\;\;\;\; {\rm where}\;\;\;\; \eta = (y/h)/[Kx/h]^{1/(n+2)}$, and the constant which defines the strength of the wake is$C = \int^\infty_0 y^U(y)(u-u_E)dy$, whereu=uE(x, y) asy→ 0 in region (E).In region (W),u(y) is proportional to Iny.By considering a large control surface enclosing the obstacle it is shown that the constant of the wake flow is not simply related to the drag of the obstacle, but is equal to the sum of the couple on the obstacle and an integral of the pressure field on the surface near the body.New wind-tunnel measurements of mean and turbulent velocities and Reynolds stresses in the wake behind a two-dimensional rectangular block on a roughened surface are presented. The turbulent boundary layer is artificially developed by well-established methods (Counihan 1969) in such a way that δ = 8h. These measurements are compared with the theory, with other wind-tunnel measurements and also with full-scale measurements of the wind behind windbreaks.It is found that the theory describes the distribution of mean velocity reasonably well, in particular the (x/h)−1decay law is well confirmed. The theory gives the correct self-preserving form for the distribution of Reynolds stress and the maximum increase of the mean-square turbulent velocity is found to decay downstream approximately as$ (\frac{x}{h})^{- \frac{3}{2}} $in accordance with the theory. The theory also suggests that the velocity deficit is affected by the roughness of the terrain (as measured by the roughness lengthy0) in proportion to In (h/y0), and there seems to be some experimental support for this hypothesis.


2019 ◽  
Vol 41 (4) ◽  
pp. 19-26
Author(s):  
A.A. Avramenko ◽  
M.M. Kovetskaya ◽  
E.A. Kondratieva ◽  
T.V. Sorokina

Effect of pressure gradient on heat transfer in turbulent boundary layer is constantly investigated during creation and improvement of heat exchange equipment for energy, aerospace, chemical and biological systems. The paper deals with problem of steady flow and heat  transfer in turbulent boundary layer with variable pressure in longitudinal direction. The mathematical model is presented and the analytical solution of heat transfer in the turbulent boundary layer problem at positive and negative pressure gradients is given. Dependences for temperature profiles and coefficient of heat transfer on flow parameters were obtained.  At negative longitudinal pressure gradient (flow acceleration) heat transfer coefficient can both increase and decrease. At beginning of acceleration zone, when laminarization effects are negligible, heat transfer coefficient increases. Then, as the flow laminarization increases, heat transfer coefficient decreases. This is caused by flow of turbulent energy transfers to accelerating flow. In case of positive longitudinal pressure gradient, temperature profile gradient near wall decreases. It is because of decreasing velocity gradient before zone of possible boundary layer separation.


Author(s):  
Luciano Castillo ◽  
Junghwa Seo ◽  
T. Gunnar Johansson ◽  
Horia Hangan

A 2D turbulent boundary layer experiment in a zero pressure gradient (ZPG) has been carried out using two cross hot-wire probes. The mean velocity and all non-zero Reynolds stresses were measured in a number of positions, 14–28 m from the inlet of the wind tunnel over a rough and a smooth surface. Wind tunnel speeds of 10 m/s and 20 m/s were set up in order to test the effect of the upstream conditions on the downstream flow. The long test section allowed us to investigate the mean velocity and Reynolds stresses dependence on the local Reynolds number and the initial conditions at very high Reynolds number (i.e. Rθ ∼ 120,000). Furthermore, it will be shown that the mean velocity deficit profiles and some of the Reynolds stresses collapse when the upstream conditions are kept fixed for smooth and rough surface.


1970 ◽  
Vol 14 (04) ◽  
pp. 241-276
Author(s):  
P. N. Joubert ◽  
N. Matheson

A 9-ft and a 4½-ft reflex model of the Lucy Ashton were tested in a wind tunnel. Both pins and wires were used as stimulators to promote a turbulent boundary layer. The effects of the stimulators could be taken into account by considering the virtual origin of the turbulent boundary layer. Slightly different viscous drag curves were found for each model, both with a slope much steeper than previously anticipated. The skin friction was determined using two independent methods. Large increases and deficits in local skin friction coefficients were found at the bow and stern of the models respectively as compared with those for a two-dimensional flat plate.


Sign in / Sign up

Export Citation Format

Share Document