Edge Effects on the Flow Characteristics in a 90deg Tee Junction

2006 ◽  
Vol 128 (6) ◽  
pp. 1204-1217 ◽  
Author(s):  
N. P. Costa ◽  
R. Maia ◽  
M. F. Proença ◽  
F. T. Pinho

Measurements of pressure drop were carried out for the flow of a Newtonian fluid in 90deg tee junctions with sharp and round corners. Rounding the corners reduced the energy losses by between 10 and 20%, depending on the flow rate ratio, due to the reduction in the branching flow loss coefficient, whereas the straight flow basically remained unaffected. The corresponding detailed measurements of mean and turbulent velocities for a Reynolds number of 31,000 and flowrate ratio of 50% showed that rounding the corner lead to an increase in turbulence in the branch pipe. The increased turbulence diffused momentum more efficiently thus reducing the length of the recirculation by 25% with its width and strength also decreasing in magnitude. The overall effect of the increased dissipation due to turbulence and reduced dissipation due to mean flow irreversibilities in the recirculation was a decrease in the corresponding loss coefficient.

2010 ◽  
Vol 29-32 ◽  
pp. 1646-1650
Author(s):  
Shi Wei Zhang ◽  
Guang Zhe Song ◽  
Zhuo Wang ◽  
Jin Ce Liu ◽  
Zhi Jun Zhang

Aiming at the actual demand, the gas flow characteristics of butterfly vacuum control valves are investigated in this paper. Classification and characteristic of vacuum control valves are discussed in detail. The geometric and mathematic models for two kinds of butterfly vacuum control valves, with seal and without seal, are respectively built. The gas flows through the valve at different opening angles are simulated under different pressure by means of the Fluent software. The flow percentage function and adjustment sensitivity are introduced and formulated to describe the flow regulating characteristic of control valves. The flow conductance coefficient and flow loss coefficient are defined and formulated to describe the resistance characteristic of control valves. The dates and curves of some simulating examples are given and discussed.


2021 ◽  
Vol 2021 ◽  
pp. 1-16
Author(s):  
Hongbin Jia ◽  
Yanxin Li ◽  
Peng Han ◽  
Kun Liu ◽  
Haolei Han ◽  
...  

The oxygen lance is a piece of special equipment in the converter steelmaking process for blowing oxygen into the molten steel. After more than 80 years of development, the structure and function of the oxygen lance have undergone many changes. In this paper, based on the theory of hydrodynamics, the jet behavior characteristics of a dual-structure oxygen lance for the converter are determined and optimized by CFD simulations and compared with those of the traditional-structure oxygen lance. The research results show that multiple jets deflect to the central axis of the oxygen lance during movement and the inclination angle of the nozzle holes influences the jet deflection. A decrease in the nozzle hole angle results in an increase in the mutual suction between the streams. With the increasing flow rate through the large holes in the new dual-structure oxygen lance, the dynamic radial pressure increases at the middle of the jet. The jet flow characteristics of the new dual-structure oxygen lance are better than those of the traditional oxygen lance. Its impact on the molten pool includes greater momentum, a larger impact area, and a more uniform and powerful stirring of the molten pool. A nozzle angle of 14° combined with a flow rate ratio of 65% and a nozzle angle of 17° combined with a flow rate ratio of 35% are the optimal parameters for the new dual-structure oxygen lance.


2016 ◽  
Vol 11 (2) ◽  
pp. 150-155
Author(s):  
R. Troian ◽  
D. Dragna ◽  
C. Bailly ◽  
M.-A. Galland

Modeling of acoustic propagation in a duct with absorbing treatment is considered. The surface impedance of the treatment is sought in the form of a rational fraction. The numerical model is based on a resolution of the linearized Euler equations by finite difference time domain for the calculation of the acoustic propagation under a grazing flow. Sensitivity analysis of the considered numerical model is performed. The uncertainty of the physical parameters is taken into account to determine the most influential input parameters. The robustness of the solution vis-a-vis changes of the flow characteristics and the propagation medium is studied.


2021 ◽  
Vol 108 ◽  
pp. 106377
Author(s):  
Mohammed Faheem ◽  
Aqib Khan ◽  
Rakesh Kumar ◽  
Sher Afghan Khan ◽  
Waqar Asrar ◽  
...  

1989 ◽  
Vol 25 (7) ◽  
pp. 394-396
Author(s):  
V. E. Shcherba ◽  
I. S. Berezin ◽  
S. S. Danilenko ◽  
I. E. Titov ◽  
P. P. Filippov

2017 ◽  
Vol 328 ◽  
pp. 480-487 ◽  
Author(s):  
V.R. Giampietro ◽  
M. Gulas ◽  
P. Rudolf von Rohr
Keyword(s):  

Author(s):  
G. K. Batchelor

A new and fruitful theory of turbulent motion was published in 1941 by A. N. Kolmogoroff. It does not seem to be as widely known outside the U.S.S.R. as its importance warrants, and the present paper therefore describes the theory in some detail before presenting a number of extensions and making a comparison of experimental results with some of the theoretical predictions.Kolmogoroff's basic notion is that at high Reynolds number all kinds of turbulent motion, of arbitrary mean-flow characteristics, show a similar structure if attention is confined to the smallest eddies. The motion due to these eddies of limited size is conceived to be isotropic and statistically steady. Within this range of eddies we recognize two limiting processes. The influence of viscosity on the larger eddies of the range is negligible if the Reynolds number is large enough, so that their motion is determined entirely by the amount of energy which they are continually passing on to smaller eddies. This quantity of energy is the local mean energy dissipation due to turbulence. On the other hand, the smaller eddies of the range dissipate through the action of viscosity a considerable proportion of the energy which they receive, and the motion of the very smallest eddies is entirely laminar. The analytical expression of this physical picture is that the motion due to eddies less than a certain limiting size in an arbitrary field of turbulence is determined uniquely by two quantities, the viscosity and the local mean energy dissipation per unit mass of the fluid.The mathematical method of describing the motion due to eddies of a particular size is to construct correlations between the differences of parallel-velocity components at two points at an appropriate distance apart. Kinematical results analogous to those for turbulence which is isotropic in the ordinary sense are obtained, and then the scalar functions occurring in the expressions for the correlations are determined by dimensional analysis. The consequences of the theory in the case of turbulence which possesses ordinary isotropy are analysed and various predictions are made. One of these, namely that dimensionless ratios of moments of the probability distribution of the rate of extension of the fluid in any direction are universal constants, is confirmed by recent experiments, so far as the second and third moments are concerned. In several other cases it can be said that relations predicted by the theory have the correct form, but further experiments at Reynolds numbers higher than those hitherto used will be required before the theory can be regarded as fully confirmed. If valid, Kolmogoroff's theory of locally isotropic turbulence will provide a powerful tool for the analysis of problems of non-uniform turbulent flow, and for the determination of statistical characteristics of space and time derivatives of quantities influenced by the turbulence.


Author(s):  
Yandong Gu ◽  
Ji Pei ◽  
Shouqi Yuan ◽  
Jinfeng Zhang ◽  
Ernst Nikolajew ◽  
...  

The volute casing used in centrifugal pumps is efficient for the transformation of kinetic energy into pressure energy, however, its asymmetric hydraulic design makes the flow in diffuser-discharge-channel (DDC) inhomogeneous, resulting in unsatisfactory flow patterns. In this study, the unsteady numerical simulations are carried out to investigate the transient flow characteristics in DDC. The accuracy of numerical results is found to agree well with experimental performance and pressure fluctuations. It is observed that the flow in DDC is significantly uneven. At the elbow of DDC, the static pressure on the volute left side (VL) is larger than the volute right side (VR) due to the flow impact and flow separation respectively. Thereby, this high-pressure gradient induces the secondary flow on the cross sections of DDC. Further, there is an obvious dependency of pressure fluctuations in the discharge pipe on the strong interaction between the impeller and tongue, in which four small peaks and four large peaks can be observed. At each moment, the pressure on VL gradually decreases from the inlet of discharge pipe to the pump outlet, while it increases on VR, finally, two sides tend to be the same. The pressure fluctuation intensity gradually becomes equivalent-distributed. In particular, it should be noticed that the energy loss in the diffuser part is larger than the discharge pipe, which requires a redesign concerning hydraulic performance. This study can help to better understand the transient flow characteristics and provide guidance for reducing flow loss in the volute casing.


Sign in / Sign up

Export Citation Format

Share Document