scholarly journals MiR396‐ GRF module associates with switchgrass biomass yield and feedstock quality

2021 ◽  
Author(s):  
Yanrong Liu ◽  
Jianping Yan ◽  
Kexin Wang ◽  
Dayong Li ◽  
Rui Yang ◽  
...  
Keyword(s):  
Biomass Yield ◽  
Feedstock Quality

scholarly journals Nitrogen and harvest impact on warm-season grass biomass yield and feedstock quality

2017 ◽  
Author(s):  
◽  
Chamara Sandaruwan Weerasekara Imbulana Acharige
Keyword(s):  
Biomass Yield ◽  
Warm Season ◽  
Early Spring ◽  
Harvest Date ◽  
Feedstock Quality ◽  
Harvest Timing ◽  
Bioenergy Feedstocks ◽  
Partial Factor ◽  
The Impact ◽  
Warm Season Grasses

Perennial warm-season grasses including switchgrass (Panicum virgatum L.), big bluestem (Andropogon geradii Vitman), and Indiangrass (Sorghastrum nutans L.) have drawn interest as bioenergy feedstocks due to their high yielding capacity with minimal amounts of inputs under a wide range of environments, and their capability to produce multiple environmental benefits. Nitrogen (N) fertility and harvest timing are considered as critical management practices when optimizing biomass yield and the feedstock quality of these grasses. The objective of this investigation was to quantify the impact of N fertilizer rate, N timing and harvest date on warm season biomass dry matter yield. Research was conducted in 2014 and 2015 on a total of four field-plot locations situated in central and west-central Missouri. Nitrogen fertilizer was applied using dry ammonium nitrate at the rates of 0, 34, 67, and 101 kg ha-1 at two application times, all N early spring and split N (early spring and following 1st harvest). Harvest treatments were as follows: 1) one cut in September; 2) one cut in November; 3) one cut in June and a second in September; and 4) one cut in June and a second in November. Treatments were arranged in a split-plot design with N rate as the main plot and harvest as the sub-plot in arandomized complete block design. Both N and harvest date and their interactions impacted biomass yield at all four locations. Delaying harvesting until late fall or killing frost increased yield. November harvest in combination with N rates grater than or equal to 67 kg ha-1 year-1 produced higher yields compared to the control and 34 kg ha-1N treatments and other harvest timing strategies. Although N was needed to optimize yield, partial factor 24 productivity (PFP) of applied N was flat when N applied was greater than 34 kg ha-1. Nitrogen fertilization at 67 kg ha-1 per growing season provided an opportunity to maintain a balance between both yield and efficiency of N inputs. Results of this research highlight the interactions of N fertilization and harvest management have when optimizing yield of warm-season grasses grown as bioenergy feedstocks. List of acronyms: N, Nitrogen; PFP, partial factor productivity.

scholarly journals Heteroexpression of Osa-miR319b improved switchgrass biomass yield and feedstock quality by repression of PvPCF5

2020 ◽  
Vol 13 (1) ◽  
Author(s):  
Yanrong Liu ◽  
Jianping Yan ◽  
Kexin Wang ◽  
Dayong Li ◽  
Yejun Han ◽  
...  
Keyword(s):  
Biomass Yield ◽  
Feedstock Quality

Biomass Yield and Feedstock Quality of Prairie Cordgrass in Response to Seeding Rate, Row Spacing, and Nitrogen Fertilization

2017 ◽  
Vol 109 (6) ◽  
pp. 2474-2485 ◽  
Author(s):  
Jia Guo ◽  
Santanu Thapa ◽  
Thomas Voigt ◽  
Vance Owens ◽  
Arvid Boe ◽  
...  
Keyword(s):  
Nitrogen Fertilization ◽  
Biomass Yield ◽  
Row Spacing ◽  
Seeding Rate ◽  
Feedstock Quality ◽  
Prairie Cordgrass

Effect of nickel(II) on the biomass yield of the activated sludge

1996 ◽  
Vol 34 (5-6) ◽  
pp. 163-171 ◽  
Author(s):  
Celal F. Gökçay ◽  
Ulku Yetis
Keyword(s):  
Activated Sludge ◽  
Decay Constant ◽  
Biomass Yield ◽  
Culture Conditions ◽  
Synthetic Wastewater ◽  
Base Line ◽  
Microbial Culture ◽  
Feed Composition ◽  
Steady State Condition ◽  
Applied Microbiology

Biomass yield of microorganisms is important in applied microbiology since it is the ultimate factor determining the amount of product produced regardless of whether product is growth-linked or not. In the case of environmental microbiology the opposite is true and minimizing the biomass produced, or the sludge in the relevant jargon, often is the prime goal. In this paper, a unique means of manipulating the microbial biomass yield of a heterogeneous culture to fulfil either of the two goals is presented. 5.0 mgl−1 Ni(II) in the feed composition to a completely mixed, once- through, activated sludge was found to induce the observed biomass yield of the microbial culture developed from sewage. As compared with the base-line study without Ni(II), where the reactor received synthetic wastewater only, true biomass yield was found to have increased along with the increased decay constant with the net effect of lowering observed biomass yield drastically at lower dilution rates and increasing it over that observed in the base-line study at higher dilution rates. At 10.0 mgl−1 influent Ni(II) concentration the culture conditions almost reverted back to the base- line study and at 25 mgl−1 Ni(II) concentration a truly steady-state condition could not be attained.

Phenotypic plasticity of plant traits contributing to grain and biomass yield of dual-purpose sorghum

Planta ◽  
2021 ◽  
Vol 253 (4) ◽  
Author(s):  
Malick Ndiaye ◽  
Bertrand Muller ◽  
Komla Kyky Ganyo ◽  
Aliou Guissé ◽  
Ndiaga Cissé ◽  
...  
Keyword(s):  
Phenotypic Plasticity ◽  
Biomass Yield ◽  
Plant Traits ◽  
Dual Purpose

Genotype-Environment-Management Interactions in Biomass Yield and Feedstock Composition of Photoperiod-Sensitive Energy Sorghum

2021 ◽  
Author(s):  
August Schetter ◽  
Cheng-Hsien Lin ◽  
Colleen Zumpf ◽  
Chunhwa Jang ◽  
Leo Hoffmann ◽  
...  
Keyword(s):  
Biomass Yield ◽  
Environment Management ◽  
Photoperiod Sensitive ◽  
Energy Sorghum

scholarly journals Influence of Atomization Nozzles and Spraying Intervals on Growth, Biomass Yield, and Nutrient Uptake of Butter-Head Lettuce under Aeroponics System

Agronomy ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 97
Author(s):  
Mazhar H. Tunio ◽  
Jianmin Gao ◽  
Imran A. Lakhiar ◽  
Kashif A. Solangi ◽  
Waqar A. Qureshi ◽  
...  
Keyword(s):  
Root Growth ◽  
Nutrient Uptake ◽  
Nutrient Solution ◽  
Biomass Yield ◽  
Chemical Properties ◽  
Cultivated Plants ◽  
Growth Ratio ◽  
Shoot Ratio ◽  
Droplet Sizes ◽  
Root To Shoot Ratio

The atomized nutrient solution droplet sizes and spraying intervals can impact the chemical properties of the nutrient solution, biomass yield, root-to-shoot ratio and nutrient uptake of aeroponically cultivated plants. In this study, four different nozzles having droplet sizes N1 = 11.24, N2 = 26.35, N3 = 17.38 and N4 = 4.89 µm were selected and misted at three nutrient solution spraying intervals of 30, 45 and 60 min, with a 5 min spraying time. The measured parameters were power of hydrogen (pH) and electrical conductivity (EC) values of the nutrient solution, shoot and root growth, ratio of roots to shoots (fresh and dry), biomass yield and nutrient uptake. The results indicated that the N1 presented significantly lower changes in chemical properties than those of N2, N3 and N4, resulting in stable lateral root growth and increased biomass yield. Also, the root-to-shoot ratio significantly increased with increasing spraying interval using N1 and N4 nozzles. The N1 nozzle also revealed a significant effect on the phosphorous, potassium and magnesium uptake by the plants misted at proposed nutrient solution spraying intervals. However, the ultrasonic nozzle showed a nonsignificant effect on all measured parameters with respect to spraying intervals. In the last, this research experiment validates the applicability of air-assisted nozzle (N1) misting at a 30-min spraying interval and 5 min of spraying time for the cultivation of butter-head lettuce in aeroponic systems.

Sign in / Sign up

Export Citation Format

Share Document