Experimental investigation of the protein foam flow structure in horizontal channels: Flow regime and corresponding bubble size distribution

2017 ◽  
Vol 40 (6) ◽  
pp. e12563 ◽  
Author(s):  
Ladan Zoheidi ◽  
Christian Panradl ◽  
Cornelia Rauh ◽  
Antonio Delgado
Keyword(s):  
Experimental Investigation ◽  
Size Distribution ◽  
Flow Regime ◽  
Flow Structure ◽  
Bubble Size ◽  
Bubble Size Distribution ◽  
Foam Flow ◽  
Protein Foam

Physiochemical properties and reproducibility of air-based sodium tetradecyl sulphate foam using the Tessari method

2016 ◽  
Vol 32 (6) ◽  
pp. 390-396 ◽  
Author(s):  
Mike R Watkins ◽  
Richard J Oliver
Keyword(s):  
Size Distribution ◽  
Bubble Size ◽  
Bubble Size Distribution ◽  
Foam Density ◽  
Physiochemical Properties ◽  
Significant Difference ◽  
Experienced Operator ◽  
Sodium Tetradecyl Sulphate ◽  
Foam Production ◽  
Made In

Objectives The objectives were to examine the density, bubble size distribution and durability of sodium tetradecyl sulphate foam and the consistency of production of foam by a number of different operators using the Tessari method. Methods 1% and 3% sodium tetradecyl sulphate sclerosant foam was produced by an experienced operator and a group of inexperienced operators using either a 1:3 or 1:4 liquid:air ratio and the Tessari method. The foam density, bubble size distribution and foam durability were measured on freshly prepared foam from each operator. Results The foam density measurements were similar for each of the 1:3 preparations and for each of the 1:4 preparations but not affected by the sclerosant concentration. The bubble size for all preparations were very small immediately after preparation but progressively coalesced to become a micro-foam (<250 µm) after the first 30 s up until 2 min. Both the 1% and 3% solution foams developed liquid more rapidly when made in a 1:3 ratio (37 s) than in a 1:4 ratio (45 s) but all combinations took similar times to reach 0.4 ml liquid formation. For all the experiments, there was no statistical significant difference between operators. Conclusions The Tessari method of foam production for sodium tetradecyl sulphate sclerosant is consistent and reproducible even when made by inexperienced operators. The best quality foam with micro bubbles should be used within the first minute after production.

Sign in / Sign up

Export Citation Format

Share Document