scholarly journals Real-time monitoring of crystal accumulation in the high-level waste glass melters using an electrical conductivity method

2017 ◽  
Vol 9 (1) ◽  
pp. 42-51 ◽  
Author(s):  
Matthew Edwards ◽  
Josef Matyáš ◽  
Jarrod Crum
Keyword(s):  
Electrical Conductivity ◽  
Real Time ◽  
Waste Glass ◽  
High Level Waste ◽  
Real Time Monitoring ◽  
Conductivity Method ◽  
Crystal Accumulation ◽  
High Level ◽  
Electrical Conductivity Method

scholarly journals Predictive modeling of crystal accumulation in high-level waste glass melters processing radioactive waste

2017 ◽  
Vol 495 ◽  
pp. 322-331 ◽  
Author(s):  
Josef Matyáš ◽  
Vivianaluxa Gervasio ◽  
Sulaiman E. Sannoh ◽  
Albert A. Kruger
Keyword(s):  
Radioactive Waste ◽  
Predictive Modeling ◽  
Waste Glass ◽  
High Level Waste ◽  
Crystal Accumulation ◽  
High Level

Neptunium Speciation in Humic Acid-rich Clay Water upon Interaction With Radioactive Waste Glass Samples

2002 ◽  
Vol 757 ◽  
Author(s):  
V. Pirlet ◽  
P. Van Iseghem
Keyword(s):  
Humic Substances ◽  
Humic Acids ◽  
Specific Interaction ◽  
Waste Glass ◽  
High Level Waste ◽  
Boom Clay ◽  
Dissolution Tests ◽  
Vis Spectroscopy ◽  
Doped Glasses ◽  
High Level

ABSTRACTOrganic complexes of actinides are known to occur upon interaction of high level waste glass and Boom Clay which is a potential host rock formation for disposal of high level waste in Belgium. The solubility and mobility of 237Np, one of the most critical radionuclides, can be affected by the high dissolved organic carbon content of the Boom Clay porewater through complexation with the humic substances. The influence of humic substances on the Np behaviour is considered through dissolution tests of Np-doped glasses in Boom Clay water and through fundamental study of the specific interaction between Np(IV) and the humic acids using spectroscopic techniques. High Np(IV) concentrations are found in the glass dissolution tests. These concentrations are higher than what we should expect from the solubility of Np(OH)4, the solubility limiting solid phase predicted under the reducing conditions and pH prevailing in Boom Clay. Studying the specific interaction of Np(IV) with humic acids in Boom Clay porewater, high soluble Np concentrations are also measured and two main tetravalent Np-humate species are observed by UV-Vis spectroscopy. The two species are interpreted in terms of mixed hydroxo-humate complexes, Np(OH)xHA with x = 3 or 4. These species are the most likely species that can form according to the pH working conditions. Using thermodynamic simplified approaches, high complexation constants, i.e. log β131 and log β141 respectively equal to 46 and 51.6, are calculated for these species under the Boom Clay conditions.Comparing the spectroscopic results of the dissolution tests with the study of the interaction of Np(IV) with humic substances, we can conclude that the complexation of Np(IV) with the humic acids may occur and increases the solubility of Np(OH)4 upon interaction of a Np-doped glass and the Boom Clay porewater.

Vapour Phase Hydration of Blended Oxide - Magnox Waste Glasses

2003 ◽  
Vol 807 ◽  
Author(s):  
Neil C. Hyatt ◽  
William E. Lee ◽  
Russell J. Hand ◽  
Paul K. Abraitis ◽  
Charlie R. Scales
Keyword(s):  
Glass Matrix ◽  
Alkaline Earth ◽  
Vapour Phase ◽  
Waste Glass ◽  
High Level Waste ◽  
Zirconium Silicate ◽  
Constant Rate ◽  
Surface Alteration ◽  
High Level ◽  
Short Incubation Time

ABSTRACTVapour phase hydration studies of a blended Oxide / Magnox simulant high level waste glass were undertaken at 200°C, over a period of 5 – 25 days. The alteration of this simulant waste glass is characterised by a short incubation time of less than 5 days, leading to the formation of an alteration layer several microns thick. Following the incubation period, the alteration proceeds at a constant rate of 0.15(1)μmd−1. The distribution of key glass matrix (Si, Na) and waste (Cs, Zr, Nd, Mo) elements was found to vary significantly across the alteration layer. Vapour phase hydration leads to formation of surface alteration products, identified as smectite, zirconium silicate and alkaline-earth molybdate phases.

scholarly journals The initial dissolution rates of simulated UK Magnox–ThORP blend nuclear waste glass as a function of pH, temperature and waste loading

2015 ◽  
Vol 79 (6) ◽  
pp. 1529-1542 ◽  
Author(s):  
N. Cassingham ◽  
C.L. Corkhill ◽  
D.J. Backhouse ◽  
R.J. Hand ◽  
J.V. Ryan ◽  
...  
Keyword(s):  
Dissolution Kinetics ◽  
Intrinsic Rate ◽  
Waste Glass ◽  
High Level Waste ◽  
Dissolution Mechanism ◽  
Dissolution Rates ◽  
Forward Rates ◽  
Glass Dissolution ◽  
High Level ◽  
Kinetics Of

AbstractThe first comprehensive assessment of the dissolution kinetics of simulant Magnox–ThORP blended UK high-level waste glass, obtained by performing a range of single-pass flow-through experiments, is reported here. Inherent forward rates of glass dissolution were determined over a temperature range of 23 to 70°C and an alkaline pH range of 8.0 to 12.0. Linear regression techniques were applied to the TST kinetic rate law to obtain fundamental parameters necessary to model the dissolution kinetics of UK high-level waste glass (the activation energy (Ea), pH power law coefficient (η) and the intrinsic rate constant (k0)), which is of importance to the post-closure safety case for the geological disposal of vitreous products. The activation energies based on B release ranged from 55 ± 3 to 83 ± 9 kJ mol–1, indicating that Magnox–THORP blend glass dissolution has a surface-controlled mechanism, similar to that of other high-level waste simulant glass compositions such as the French SON68 and LAW in the US. Forward dissolution rates, based on Si, B and Na release, suggested that the dissolution mechanism under dilute conditions, and pH and temperature ranges of this study, was not sensitive to composition as defined by HLW-incorporation rate.

Materials Interface Interactions Test (MIIT); in-Situ Testing of Simulated Hlw Forms in Salt- Performance of Srs Simulated Waste Glass After up to 5 Years of Burial at the Waste Isolation Pilot Plant (WIPP)

1991 ◽  
Vol 257 ◽  
Author(s):  
G.G. Wicks ◽  
A.R. Lodding ◽  
P.B. Macedo ◽  
D.E. Clark
Keyword(s):  
United States ◽  
Pilot Plant ◽  
Field Tests ◽  
Field Testing ◽  
The United States ◽  
Waste Glass ◽  
Department Of Energy ◽  
High Level Waste ◽  
Waste Isolation Pilot Plant ◽  
High Level

ABSTRACTThe first field tests conducted in the United States involving burial of simulated high-level waste [HLW] forms and package components, were started in July of 1986. The program, called the Materials Interface Interactions Test or MIIT, is the largest cooperative field-testing venture in the international waste management community. Included in the study are over 900 waste form samples comprising 15 different systems supplied by 7 countries. Also included are approximately 300 potential canister or overpack metal samples along with more than 500 geologic and backfill specimens. There are almost 2000 relevant interactions that characterize this effort which is being conducted in the bedded salt site at the Waste Isolation Pilot Plant (WIPP), near Carlsbad, New Mexico. The MIIT program represents a joint endeavor managed by Sandia National Laboratories in Albuquerque, N.M., and Savannah River Laboratory in Aiken, S.C. and sponsored by the U.S. Department of Energy. Also involved in MIIT are participants from various laboratories and universities in France, Germany, Belgium, Canada, Japan, Sweden, the United Kingdom, and the United States. In July of 1991, the experimental portion of the 5-yr. MIIT program was completed. Although only about 5% of all MIIT samples have been assessed thus far, there are already interesting findings that have emerged. The present paper will discuss results obtained for SRS 165/TDS waste glass after burial of 6 mo., 1 yr. and 2 yrs., along with initial analyses of 5 yr. samples.

Sign in / Sign up

Export Citation Format

Share Document